Electroluxメーカー267083の使用説明書/サービス説明書
ページ先へ移動 of 30
From the Electrolux Group DOC. NO. 5938 035 01 EDITION 1 E-Z-A 0802 LA-LC - ELECTRICS HEATED STEAM CONVECTION OVENS INSTALLATION, OPERATION AND MAINTENANCE Page 9 - FORNI CONVEZIONE/VAPORE ELETTRICI I.
2 5938 035 01 INST ALLA TION DIA GRAM SCHEMI DI INST ALLAZIONE SCHEMAS D'INST ALLA TION ESQUEMA P ARA LA INST ALA CIÓN SAFETY INSTRUCTIONS Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.
3 5938 035 01 1a USA I - Power supply cable inlet B - Water supply connection (0.5- 5 °F) ø3/4" NPT gasline C - Water drain connection ø1"1/4 NPT gasline N - Steam condens. water connection ø3/4" NPT gasline D - Overflow drain pipe (AIR-BREAK) (Do not connect) ( ^) FUNCTIONAL LEVEL IT I - Entrata cavo elettrico B - Attacco alim.
4 5938 035 01 47 9 16 " 1208 mm 5 23 32 " 145 mm C 67 17 32 " 1715 mm 3 1 16 " 77.5 mm 3 1 16 " 77.5 mm 2 15 32 " 62.5 mm 11 27 32 " 301 mm 22 27 32 " 580 mm 26 5 16 " 668 mm 14 1 4 " 362 mm 3 15 16 " 100 mm 1 9 11 16 " 500 mm 3 15 16 " 100 mm C B I N D cod.
5 5938 035 01 35 11 32 " 8 9 8m m 5 1 9 32 " 142 mm C 54 23 32 " 13 9 0m m 2 7 8 " 73 mm 2 5 32 " 55 mm 2 7 8 " 73 mm 6 1 4 " 15 9 mm 17 5 16 " 440 mm 20 5 16 " 516 mm 8 11 16 " 221 mm 3 15 16 " 100 mm 3 15 16 " 100 mm 1 9 11 16 " 500 mm C B I N D cod.
6 5938 035 01 1d USA I - Power supply cable inlet B - Water supply connection (0.5- 5 °F) ø3/4" NPT gasline C - Water drain connection ø1"1/4 NPT gasline N - Steam condens. water connection ø3/4" NPT gasline D - Overflow drain pipe (AIR-BREAK) (Do not connect) ( ^) FUNCTIONAL LEVEL IT I - Entrata cavo elettrico B - Attacco alim.
7 5938 035 01 1e USA I - Power supply cable inlet B - Water supply connection (0.5- 5 °F) ø3/4" NPT gasline C - Water drain connection ø1"1/4 NPT gasline N - Steam condens. water connection ø3/4" NPT gasline D - Overflow drain pipe (AIR-BREAK) (Do not connect) ( ^) FUNCTIONAL LEVEL IT I - Entrata cavo elettrico B - Attacco alim.
8 5938 035 01 1f USA I - Power supply cable inlet B - Water supply connection (0.5- 5 °F) ø3/4" NPT gasline C - Water drain connection ø1"1/4 NPT gasline N - Steam condens. water connection ø3/4" NPT gasline D - Overflow drain pipe (AIR-BREAK) (Do not connect) ( ^) FUNCTIONAL LEVEL IT I - Entrata cavo elettrico B - Attacco alim.
9 USA 5938 035 01 INSTRUCTIONS FOR INSTALLATION AND USE Table of contents Page - Installation diagram .................................................
10 USA 5938 035 01 1. DESCRIPTION OF APPLIANCE This booklet describes a number of appliance models. For more detailed information about the model in your possession, refer to "Technical Data" table 1. The appliance has the following features: • Digital temperature controlle.
11 USA 5938 035 01 3. PRECAUTIONS • The following terms alert you to potentially dangerous conditions to the operator, service personnel or to the equipment. • Danger! This term warns of immediate hazards which will result in severe injury or death.
12 USA 5938 035 01 4. SAFEGUARDING THE ENVIRONMENT 4.1 PACKAGING • All the packaging materials used are environmentally safe and friendly. They may be stored without fear or danger. They may be recycled or burned in a special waste incineration plant.
13 USA 5938 035 01 1.4 IMMEDIATELY INSPECT FOR SHIPPING DAMAGE The container should be examined for damage before and during unloading. The freight carrier has assumed responsibility for its safe transit and delivery. If damaged equipment is received, either apparent or concealed, a claim must be made with the delivering carrier.
14 USA 5938 035 01 RATING PLATE 3.1 INSTALLING THE POWER SUPPLY CABLE To access the power supply cable connection terminal board, proceed as follows: Model 6 - 10 - 20 GN • Remove the left side panel.
15 USA 5938 035 01 - OVEN level C - Connect drain fitting “C” to a drain pipe of the same diameter which is between 0.5 and 3 metres in length and is resistant to temperatures of at least 100°C. The drain pipe must be siphoned (height 80 mm) to an open drain “O” (“Air-Break”) or floor grating (see Fig.
16 USA 5938 035 01 Before switching on the appliance, read this instruction booklet carefully because it contains important information concerning correct use of the appliance. If you require further information about the oven's features and cooking performance, consult your local dealer.
17 USA 5938 035 01 3. DESCRIPTION OF THE CONTROL PANEL 3.1 INTRODUCTION To aid understanding of the operation of the oven, find the folding double page showing the control panel for your model among those included at the back of this handbook and then open it out and keep it open while reading this section.
18 USA 5938 035 01 Low speed cycle (fan): for delicate cooking such as for baking cakes. Can be combined with any other cycle. Reduced power cycle (heating) : for delicate cooking such as for baking cakes. Can be combined with any other cycle. Cooking with ECO-DELTA : for cooking large pieces of food (5kg and above, e.
19 USA 5938 035 01 OPERATING LEVEL A and C (C = Convect) 4. INTRODUCTION Cooking of food is carried out by heating it and can be achieved in a specific MODE, at a specific TEMPERATURE, a specific TIME and HUMIDITY level. Therefore these parameters must be set in order to execute a COOKING CYCLE.
20 USA 5938 035 01 After 5 seconds the COOKING TEMPERATURE stops flashing to indicate that it has been SET. Note The temperature of the steam cycle is automatically set at 212°F(100°C). You can, however, set low temperature steam from 77°F to 210°F(25° to 99°C) by turning the knob.
21 USA 5938 035 01 Note: Press the button again to switch from the PROBE function to the TIME function: the relative LED on the DISPLAY will light up. 4) Start the cycle .
22 USA 5938 035 01 4.3.9 UTILITIES - Switch on the oven by pressing button I . - Set a cooking cycle for the following UTILITIES: UTILITIES with cycle presetting; this is not necessary for the other utilities as they are already specific cycles. - Press button U (UTILITY): U (UTILITY) - The green UTILITY LEDs will light up and one will be flashing.
23 USA 5938 035 01 4.4.1 AUTOMATIC SEQUENTIAL MULTIPHASE COOKING Food can be cooked using different temperatures during the cooking cycle (i.e. in several different stages). The oven allows the execution of programs composed of several sequential phases.
24 USA 5938 035 01 4) Set the required START time (shown in small numbers on the TM timer display) and press the START/STOP button. The cycle will start at the time set in the DELAY START option and the letter D will flash in alternation with a dot to remind the user that this function is active.
25 USA 5938 035 01 letter G A O G flashing P : C O N F I R M Press the button P to confirm this letter, the first recipe or program starting with the letter G appears on the display. first recipe 1 4 G A M M O N with letter G P : M E N U Select the name of the desired recipe from those beginning with the letter G.
26 USA 5938 035 01 • Fast maturing process - time saving and use of fresh cut. • Significant less cooking shrinkage, 5-8 % (depend on food quality and selected core temperature). • Remarkable gain of portions for selling. • Dramatic energy-saving due to the intelligent EFS - LTC program.
27 USA 5938 035 01 End - End of a cycle or function. FILL - Boiler filling. (Ensure water supply tap/cock are open). Hold - Cooking option, HOLD function active. LOAd - Place the food in the oven. oPEn - Boiler discharge valve opening. PrEH - (TIME TM / PRB DISPLAY)Boiler preheating.
28 USA 5938 035 01 5) - Press the START/STOP button to start the cycle. ————— SEMIAUTOMATIC Cycle only ( A-C ) ————— The cycle will commence when the temperature automatically reaches 100 °C in the oven chamber . 6) - The 1st cleaning phase (STEAM cycle) ends after 5 minutes, as signalled by the audible alarm.
29 USA 5938 035 01 IMPORTANT - 1 Insert a rubber hose inside the boiler filler pipe and rinse thoroughly with water to remove all traces of descaling agent. • Refit the filler plug and close the boiler drain (by pressing the relative button). After descaling the boiler, it is good practice to execute a 30- minute STEAM cycle with the oven empty.
30 USA 5938 035 01 NO TEXT ON THIS PAGE.
デバイスElectrolux 267083の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Electrolux 267083をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはElectrolux 267083の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Electrolux 267083の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Electrolux 267083で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Electrolux 267083を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はElectrolux 267083の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Electrolux 267083に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちElectrolux 267083デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
