CDAメーカーFF820の使用説明書/サービス説明書
ページ先へ移動 of 20
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer .
2 Important The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance.
3 CE Declarations of Conformity: This appliance has been designed, constructed and marketed in compliance with safety requirements of EEC Directive 2006/95/EEC (L ow voltage) and requirements of EMC Directive 2004/108/EEC.
4 Before First Use Y ou must allow the fridge to settle for at least twenty four hours prior to switching the power on. It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and warm water and then thoroughly drying the interior .
5 • Do not splash water onto the top or back of this appliance. • Never put liquids in the refrigerator uncovered. • Never put hot foods in the refrigerator . W arm food should be allowed to cool to room temperature before being put into the refrigerator .
6 Control P anel D A B C A On/O key B Increase temperature key C Decrease temperature key D High humidity function key E High humidity indicator fig. 1 Switching the fridge on and o T o switch on the fridge for the first time, press and hold the On/O key (A) for three seconds.
7 high humidity indicator will show on the display and the fridge will beep twice to confirm the setting. T o switch the high humidity function o , press and hold the high humidity key for three seconds. The high humidity indicator on the display will switch o and the fridge will beep twice to confirm the setting.
8 fig. 2 Defrosting the Fridge The fridge is self-defrosting. The defrosted water is collected in the evaporating tray at the back of the appliance. Adjusting the shelves The fridge shelves can be moved according to the storage requirements within the fridge section.
9 Care and Cleaning Always disconnect the appliance from the power supply before any cleaning or maintenance. • The refrigerator should be cleaned using a solution of bicarbonate of soda and lukewarm water . • Do not use abrasive products or detergents.
10 T roubleshooting If you have any problems with your appliance, you should check the troubleshooting prior to calling CD A Customer Care to prevent unnecessary service calls and potential cost. The appliance is not working • Check there is power to the appliance: • The house fuses are intact and the fuse in the plug has not blown.
11 There is water in the lower part of the refrigerator compartment • The drain hole in the channel at the back of the compartment is clear . Please note: The LED lighting cannot be replaced without a service call. If the light fails, contact CD A Customer Care.
12 Installation And V entilation This appliance must never be installed close to heat sources i.e. heating elements, cookers or in damp places The diagram shows the ventilation requirements for your product.
13 R eversing the Door W e recommend you seek the help of another individual to support the doors whilst performing this operation. 1. Carefully remove the two hinge cover plates and two cover caps from the control panel. 2. Remove the control panel, ensuring that the wires are not damaged.
14 opposite side, leaving the screwhead appro ximately 3mm proud of the appliance. 6. Remove the lower hinge and reposition the lower hinge pin as shown in figure 5. 7 . R eposition the lower hinge on the opposite side as shown in fig 7 . 8. Reverse the upper hinge pin as shown in fig 6.
15 Electrical Information W arning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. T o change a fuse in this type of plug, follow the steps below: 1. R emove the fuse cover and fuse.
16 As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- • The wire which is coloured GREEN and YELLO W must be connected to the terminal which is marked with letter (E) or by the Earth symbol or coloured GREEN and YELL O W .
17.
18 NO TES.
19 NO TES.
Please contact our Customer Care Department for Service on the details below Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
デバイスCDA FF820の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
CDA FF820をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCDA FF820の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。CDA FF820の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。CDA FF820で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
CDA FF820を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCDA FF820の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、CDA FF820に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCDA FF820デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。