CenturyメーカーPM-1863ABの使用説明書/サービス説明書
ページ先へ移動 of 32
Instruction Manual Para instrucciones en Español, llamar al: 1-800-837-4044 www .centuryproducts.com PM-1863AB 6/01 A void injury or death - Read and understand this manual!.
T ABLE OF CONTENTS Important Information..................................... 1 W arnings......................................................... 2 Basic Information............................................ . 4 V ehicle Seat Belts.................
IMPORT ANT INFORMA TION No car seat can guarantee protection fr om injury in every situation, but proper use helps reduce the risk of serious injury or death. Child restraints (car seats) could be recalled for safety reasons. Y ou must register this restraint to be reached in a recall.
2 W ARNINGS - Prevent serious injur y or death: x Never use a vehicle “lap-only” belt across front of child. Never put a car seat in a front vehicle seat unless recommended by vehicle owner’ s manual.
3 W ARNINGS - Prevent serious injur y or death (continued): DO NOT use car seat if it is damaged or has missing parts. DO NOT use accessories or parts other than those provided by Century or Graco. Their use could alter the function of the car seat. Never leave child unattended, even when sleeping.
DO NOT use after date shown on back of car seat due to changing requirements and normal wear and tear . Look for: BASIC INFORMA TION Always secure car seat with a vehicle seat belt, even when unoccupied. An unsecured car seat can injure passengers. Protect vehicle seat.
HEIGHT and WEIGHT LIMITS 5 ❃ Outgrowing Car Seat T o avoid injuries from whiplash, top of child’ s ears must be below top edge of headrest. W ARNING Without Harness System With Harness System Child MUST meet all of the following requirements: • W eight is 30 - 40 lbs.
Place forward-facing on vehicle seat. Thread vehicle seat belt through openings (fig. a) (pad cut out for illustration purposes only) and buckle belt. Press down firmly in center of car seat to compress vehicle seat cushion while tightening vehicle seat belt.
Place forward-facing on vehicle seating position with a vehicle lap/shoulder belt. See “V ehicle Seat Belts” section. T ether may be used to stabilize booster seat: Attach tether hook (A) to anchor hardware (B) and tighten strap to remove any slack (fig.
Adjust harness system: Harness straps must be through slots at or just above shoulders. Place child in car seat with child’ s back flat against back of car seat. Place harness straps over child’ s shoulders and insert tongues into buckle. Pull up on tongues to be sure they are locked.
9 2 3 (fig. a) (fig. b) PLACING CHILD IN CAR SEA T - with harness system (continued).
Remove harness system (see “Harness System - removal and re-assembly” section). Place child in car seat with child’ s back flat against back of car seat. Place shoulder belt across child’ s chest and lap belt under both armrests. Buckle belt and pull shoulder belt to adjust lap belt snugly .
11 (fig. b) (fig. c) (fig. a) PLACING CHILD IN CAR SEA T - without har ness system (continued).
OPERA TIONS and ADJUSTMENTS 12 Harness Tie: • T o open: Unhook harness tie from harness strap on child’ s left (fig. a) . • T o close: From back of harness tie, slide harness strap over harness tie tab. Buckle: • T o lock: Insert both tongues into buckle.
13 2 1 (fig. b) Tighten Adjuster Loosen OPERA TIONS and ADJUSTMENTS (continued) (fig. a).
14 Changing Harness Strap Slots: MUST use slots at or just above shoulders. A Lift adjuster bar and pull harness straps out of current slots. B Change harness strap slots. Make sure harness straps are threaded through matching slot of seat pad and car seat.
15 (fig. d) (fig. e) Metal Plate (fig. f) OPERA TIONS and ADJUSTMENTS (continued) Minimum 2 inches (fig. c) Adjuster Bar Loosen Tighten.
HARNESS SYSTEM - removal and re-assembly 16 Removal: • Lift adjuster bar and pull both harness straps out of current slots. • Pull harness strap out of car seat, harness tie, and tongues. Store all parts for future use. • Push buckle and crotch strap down into crotch strap opening.
17 1 2 4 5 (With Shield on some models) 3 HARNESS SYSTEM - removal and re-assembly (continued) (Clip) (Clip).
18 VEHICLE SEA T BEL TS If car seat with harness system is not held securely after following instructions in this manual, vehicle seat belt labels, and vehicle owner’ s manual: • Move car seat to another seating location and try again, or • Contact vehicle dealer for possible seat belt modification parts.
19 With Harness System: The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip latch plate over (fig. a) and re-buckle. T est installation again to see if this works.
With Harness System: Lap belts with retractors may or may not hold a car seat securely . Follow these steps to determine if you have a retractor system that will hold car seat securely: a. Pull belt all the way out. b. Allow belt to retract about 6 inches (15 cm).
21 With or Without Harness System: DO NOT use with any car seat. ❃ Passive Restraint - Lap Belt with Motorized Shoulder Belt With or Without Harness System: DO NOT use with any car seat.
22 With Harness System: V ehicle seat belts located for ward of seat crease may not securely hold car seat. Check vehicle owner’ s manual or see vehicle dealer for car seat installation requirements. If approved for use with car seat by vehicle manufacturer , install car seat and check for secure installation by pulling car seat fr ont to back.
23 (fig. b) ❃ Combination Lap/Shoulder Belt with Locking Latch Plate With Harness System: OK to use. Follow vehicle owner’ s manual for specific instructions on how to use vehicle seat belts. The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle.
(fig. a) ❃ Combination Lap/Shoulder Belt with Sliding Latch Plate Pull 24 VEHICLE SEA T BEL TS (continued) With Harness System: Pull on latch plate (fig. a) . If belt slides freely through latch plate, a locking clip MUST be used. (See “Locking Clip”section.
25 T est installation to see if car seat is secure. If not secure, additional belt tightening may be required: • Unbuckle vehicle seat belt. • Hold belts together and remove locking clip. • Shorten length of lap belt portion slightly by pulling belt through latch plate.
ADDITIONAL INFORMA TION V ehicle may already be equipped with a tether anchor (top strap anchor). See vehicle owner’ s manual for location. If vehicle does not have a tether anchor , one must be installed: • Contact vehicle dealership for proper anchor location and installation.
27 For storage of tether hook if not used with a belt position booster: • Adjust tether strap length so hook end is as short as possible. • Roll loose end of strap up. • Place rolled up strap on top of adjuster and place rubber band around bundle.
Removing Seat Pads: If using harness system, remove harness system (see “Harness System - removing and re-assembly” section). T urn car seat upside down: Using a screwdriver , pr y metal rod loose from car seat shell and slide elastic off. CAUTION: Be careful not to damage webbing with screwdriver .
29 ADDITIONAL INFORMA TION (continued) Prevent serious injury or death: • Buckle must be properly latched. • Periodically inspect and clean buckle to remove objects or debris that could prevent latching. W ARNING Seat Pad and Armrest Pads: Machine-wash separately on gentle cycle and drip dry .
Store behind headrest pad. Fold instruction manual. 1 2 If a part is damaged, missing, or you need help or replacement parts, DO NOT return car seat to the store. CALL US FIRST Call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555.
デバイスCentury PM-1863ABの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Century PM-1863ABをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCentury PM-1863ABの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Century PM-1863ABの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Century PM-1863ABで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Century PM-1863ABを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCentury PM-1863ABの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Century PM-1863ABに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCentury PM-1863ABデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。