Chauvetメーカー56-24UVBの使用説明書/サービス説明書
ページ先へ移動 of 17
LED PAR 56-24UVB User Manual.
CHAUVET®, 2010, All Rights Reserved Information and specifications in this User Manual are subject to change without notice.
1. Before You Begin 3 9/13/2010 2:33 PM 1. B EFORE Y OU B EGIN What is included • 1 x LED PAR 56-24UVB • 1 x Gel Holder • 1 x Warranty Card • 1 x User Manual Unpacking Instructions Immediately.
1. Before You Begin 4 9/13/2010 2:33 PM Safety Instructions • Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.
2. Introduction 5 9/13/2010 2:33 PM 2. I NTRODUCTION Product Overview DMX In Power Input Microphone Microphone Sensitivity Adjustment Knob Fuseholder Bracket Adjustment Knob Attachment Bolt (not meant.
3. Setup 6 9/13/2010 2:33 PM 3. S ETUP AC Power This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage to which you are connecting it is within the range of accepted voltages.
3. Setup 7 9/13/2010 2:33 PM Mounting Orientation The LED PAR 56-24UVB may be mounted in an y position provided there is adequate room for ventilation. Rigging Be sure that the structure can support the wei ght of the fixture. Pl ease see the “Technical Specifications” section of this manual for a detailed weight listing.
4. Operating Instructions 8 9/13/2010 2:33 PM 4. O PERATING I NSTRUCTIONS Configuring the Starting Address The LED PAR 56-24UVB fixture us es two DMX channels. The hi ghest channel that the fixture may be set to in order to function properly is 511. An y address higher than this will prevent access to all of the channels.
4. Operating Instructions 9 9/13/2010 2: 33 PM DMX Operation This operating mode allows control of the fixture with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual.
4. Operating Instructions 10 9/13/2010 2:33 PM Automatic This fixture has a preprogrammed pulsating chas e with adjustable speed. Access this via the control panel of the front of the fixture. Please see the instructions below for further d etails. 1.
5. Appendix 11 9/13/2010 2:33 PM 5. A PPENDIX General Troubleshooting S YMPTOM P OSSIBLE C AUS E ( S ) P OSSIBLE A CTION ( S ) Breaker/Fuse keeps blowing • Excessive circuit load • Check total load placed on the electrical circuit. • Short circuit along the power wires • Check for a short in the electrical wiring (internal and/or external).
5. Appendix 12 9/13/2010 2:33 PM DMX Primer There are 512 channels in a DMX connection. A fixt ure capable of receiving DMX will require one or a number of sequential channels. The user must assign a starting address on the fi xture that indicates the first channel reserved in the cont roller.
5. Appendix 13 9/13/2010 2:33 PM Cable Connectors Cabling must have a male XLR connector on one end and a female XLR connector on the other end. Do not allow contact be twe en the common and the fixture’s ch assis ground. Grounding the common can caus e a ground loop, and y our fixture may pe rform erratically.
5. Appendix 14 9/13/2010 2:33 PM 3-Pin to 5-Pin Conversion Chart If you use a controller with a 5-pin DMX outpu t connector, you will ne ed to use a 5-pi n to 3-pin adapter.
5. Appendix 15 9/13/2010 2:33 PM General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month.
T ECHNICAL S PECIFICATIONS WEIGHT & DIMENSIONS Length ............................................................................................................. 9.2 in (23 4 mm) Width ............................................................
C ONTACT U S World Wi de General Information CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 fax: 954.929.5560 toll free: 800.762.1084 Technical Support CHAUVET® 5200 NW 108 th Ave Sunrise, FL 33351 voice: 954.929.1115 (Press 4) fax: 954.
デバイスChauvet 56-24UVBの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Chauvet 56-24UVBをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはChauvet 56-24UVBの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Chauvet 56-24UVBの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Chauvet 56-24UVBで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Chauvet 56-24UVBを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はChauvet 56-24UVBの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Chauvet 56-24UVBに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちChauvet 56-24UVBデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
