Cisco Systemsメーカー3750の使用説明書/サービス説明書
ページ先へ移動 of 15
Table of Contents Configuring Inter−VLAN Routing with Catalyst 3750 Series Switches in a Stacked Configuration .........1 Document ID: 45002 ............................................................................................................
Configuring Inter−VLAN Routing with Catalyst 3750 Series Switches in a Stacked Configuration Document ID: 45002 Introduction Before You Begin Conventions Prerequisites Components Used Background The.
Components Used The information in this document is based on the software and hardware versions below. Two Catalyst 3750G−24T switches running 12.1(14)EA1 EMI Software Release stacked together • Catalyst 2950G−48 running 12.1(12c)EA1 EI Software Release • Catalyst 2948G running 6.
Generating and distribution of the Distributed Cisco Express Forwarding (dCEF) database to the different stack members • The MAC address of the master is used as source MAC of routed packets • Pac.
The above diagram shows a small sample network with the stack of Catalyst 3750s providing inter−VLAN routing between the various segments. The following are the three user defined VLANs: VLAN 2 − .
VLAN 1 is not used for management. All ports in Catalyst switches default to VLAN 1, and any devices connected to non−configured ports will be in VLAN 1. This may cause potential issues for the management of switches, as explained above. • A Layer 3 (L3) (routed) port is used to connect to the default gateway port.
description To 2950 switchport trunk encapsulation dot1q ! !−−− Dot1q trunking (with negotiation) is configured on the L2 switch. !−−− If DTP is not supported on the far switch, issue the !−−− switchport mode trunk command !−−− to force the switch port to trunk mode.
interface GigabitEthernet1/0/22 ! interface GigabitEthernet1/0/23 ! interface GigabitEthernet1/0/24 ! interface GigabitEthernet2/0/1 description To 2948G switchport trunk encapsulation dot1q ! !−−− Output suppressed.
Note: Since the 3750 is configured as a VLAN Trunk Protocol (VTP) server, the VTP configuration is not displayed by the switch. This is standard behavior. The commands below are used on this switch to create a VTP server with the three user−defined VLANs from global configuration mode.
switchport mode access no ip address spanning−tree portfast ! !−−− Output suppressed. interface GigabitEthernet0/1 switchport trunk encapsulation dot1q no ip address ! interface GigabitEtherne.
begin ! # ***** NON−DEFAULT CONFIGURATION ***** ! ! #time: Fri Jun 30 1995, 05:04:47 ! #version 6.3(10) ! ! #system web interface version(s) ! #test ! #system set system name Cat2948G ! #frame distribution method set port channel all distribution mac both ! #vtp !−−− VTP domain is configured to be that same as the 3550 (VTP server).
Verify This section provides information you can use to confirm your configuration is working properly. Certain show commands are supported by the Output Interpreter Tool ( registered customers only ) , which allows you to view an analysis of show command output.
E1 − OSPF external type 1, E2 − OSPF external type 2, E − EGP i − IS−IS, L1 − IS−IS level−1, L2 − IS−IS level−2, ia − IS−IS inter area * − candidate default, U − per−user static route, o − ODR P − periodic downloaded static route Gateway of last resort is 200.
200.1.1.1 disabled disabled 2−1000 show trunk Cat2948G> (enable) show trunk * − indicates vtp domain mismatch Port Mode Encapsulation Status Native vlan −−−−−−−− −−−−−.
Updated: Mar 10, 2005 Document ID: 45002 Cisco − Configuring Inter−VLAN Routing with Catalyst 3750 Series Switches in a Stacked Configuration.
デバイスCisco Systems 3750の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Cisco Systems 3750をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCisco Systems 3750の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Cisco Systems 3750の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Cisco Systems 3750で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Cisco Systems 3750を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCisco Systems 3750の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Cisco Systems 3750に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCisco Systems 3750デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。