ClarityメーカーW-1000の使用説明書/サービス説明書
ページ先へ移動 of 28
Clarity ® The telephone that hear s what you’ve been missing. W -1000 User Guide S P A N I S H F R E N C H E N G L I S H W1000_User_Guide 11/15/99, 9:37 PM 1.
SAFETY INSTR UCTIONS INST ALLA TION FEA TURES: • Clarity Contr ol® • Ringer V olume Contr ol • Visual Ringer • Ringer Pitch Contr ol • T one / Pulse Selection • Last Number Redial • Fla.
P age 3 W -1000 Read and Understand All Instructions I mpor tant Safety Instructions 1.Ne ver install telephone wiring during a lightning storm. 2. Nev er install telephone jacks in w et locations unless the jack is specifically designed for w et locations.
W -1000 P age 4 Safety Instructions Continued • Nev er push objects of any kind into this pr oduct thr ough cabinet slots as they ma y touch dangerous v oltage points or short out par ts that could r esult in a risk of fir e or electric shock. Nev er spill liquid of any kind on the pr oduct.
P age 5 W -1000 The follo wing items are included as part of the CS-03 Requirements. The Load Number of the equipment is 20. The standar d connecting arrangement code for the equipment is CA11A. NO TICE: The Canadian Department of Communications label identifies cer tified equipment.
W -1000 P age 6 Inside y ou will find the follo wing items: A. Handset B. Handset Line Cor d (Coiled, 10 ft.) C . Base Unit D . Phone Line Cord (long, flat) E.
P age 7 W -1000 Note: If you are plugging the phone into an older 4-prong jack, use an RJ11C adapter Select a Location: Connecting the Clarity Phone: W arning: T o pr event electrical shoc k, always remo ve the telephone line cor d from the w all jack before r emoving the cord fr om the telephone .
W -1000 P age 8 Note: If the wall-mounting br ac k et is already placed in the desk mount position, remo ve it by pressing the tabs and turning it 180 ° per the k ey sho wn for the w all- mount. W alker Clarity comes assembled with mounting br acket attached in desk mount position.
P age 9 W -1000 • Plug one end of the handset cord (coiled) into the bottom of the handset. • Plug the other end of the handset cord into the jack located on the low er left edge of the W alk er Clarity . • Place the handset in the cradle of the W alker Clarity .
W -1000 P age 10 Impor tant: Reset the Clar ity Po wer Contr ol to zer o after e ver y call to protect other users of the telephone . A high setting on this control may be unpleasant to another user ; caution should be tak en to reset it after e ver y use .
P age 11 W -1000 A lighted ringer w orks in conjunction with the low fr equency ringer . It sends out a visual flashing alert every time a phone call is coming in. (This ringer will light up regar dless of the setting on the ringer volume contr ol.) The Clarity Phone can be used as either a T ONE (touch dial) or PULSE (rotary dial) phone.
W -1000 P age 12 Note for Users with Pulse/Rotar y ser vice only: Many automated answering systems used by banks, stores and go vernment agencies ask you to “Push 1 for ser vice”, “Push 2 for the oper ator”, etc . Y ou must s witc h the tone/pulse switch on the top edge of the phone to tone bef ore responding to these pr ompts.
P age 13 W -1000 1. While a telephone call is in pr ogr ess, pr ess the hold button once to place the call on hold. The red hold light will turn on. 2. Hang up the r eceiver 3. T o take the call off hold: A. Simply lift the W alker Clarity r eceiver out of the cradle.
W -1000 P age 14 Oper ating the W alk er Clarity® Once y ou ha ve installed y our W alker Clarity according to the instructions noted pr eviously , it will be ready to use. T o Place or Receiv e a Call: Note: If you made an error while dialing, just depress the hookswitch, listen for a dial tone, and dial again.
P age 15 W -1000 Hospital). The W alk er Clarity will let you store up to 15 digits with each button. 2. Select the corr ect T ONE/PULSE setting y ou normally dial in.
W -1000 P age 16 Pr ogr amming Continued 3. Pick up the handset fr om the phone base, press and release the “PR OGRAM” button on the base unit. 4. Dial the number y ou wish to stor e. The number is not transmitted while y ou are pr ogramming it. Y ou can pr ogram a pause into the dialing sequence, if necessar y .
P age 17 W -1000 Pr ogr amming Fr equently-Dialed Numbers The W alk er Clarity will allow you to pr ogram up to ten (10) frequentl y-dialed phone numbers f or future use. By doing so , y ou will only ha ve to pr ess one button to call numbers that y ou normally dial often (e.
W -1000 P age 18 1. Pick up the handset and listen for a dial tone. 2. Press the a ppr opriate “Memor y” button. Pr ogr amming Continued 3. Pick up the handset fr om the phone base, press and release the “PR OGRAM” Button on the base unit. 4. Dial the number y ou wish to stor e.
P age 19 W -1000 1. Lift the handset, listen for a dial tone. 2. Push memor y 1 and then memor y 2 immediately ther eafter . 3. The W alk er Clarity will automatically dial the whole number . 4. W ait for the person y ou are calling to answ er . Y ou can cascade an y number of memory locations.
W -1000 P age 20 —Mak e sure that T ONE/PULSE switch is not set in the middle. Slide the switch fully to the left or the right. —If y ou ha ve the T ONE/PULSE switch set to T ONE, mak e sur e that you ha ve T ouchT one ser vice from y our local phone compan y .
P age 21 W -1000 T r oubleshooting Continued • Difficulty Pr ogramming Account Numbers —Y our T ONE/PULSE selector must be switched to the T ONE mode to enter account numbers. This is because most interactiv e phone systems requir e T OUCH T ONE to operate .
W -1000 P age 22 • Clarity Phones Are Compatible With Digital PBX Systems —These units ha v e a large electr onic box contr olling many phones as one unit. These types of units ma y be found in office buildings and some r etirement homes, nursing homes and condos.
P age 23 W -1000 If you ha ve an y telephone ser vice pr oblems, first mak e sure y ou hav e follow ed all of the installation pr ocedur es outlined in this user’ s guide . Then tr y to determine if the sour ce of the problem is the W alk er Clarity itself or your phone service .
W -1000 P age 24 FCC Requir ements Continued 3. Repair Instructions If it is determined that your telephone equipment is malfunctioning, the FCC requires that it not be used and that it be unplugged from the modular outlet until the pr oblem has been corrected.
P age 25 W -1000 W alk er Equipment Corpor ation Limited W arr anty* W alker Equipment Corporation warrants each item of ne w telephone equipment manufactur ed by it against defects in material or w orkmanship for a period of one year fr om the date of original pur chase .
W -1000 P age 26 • Damage by negligence, misuse , or accident. • Lack of performance due to incompatibility with the equipment of an y par ticular telephone compan y . • Modifications to the W alker Clarity to mak e it compatible with any particular telephone compan y .
The W alk er Clarity you send under these conditions will be r eturned in a lik e-new condition to y ou in four w eeks or less. W alk er Ser vice Continued Pur chaser’s Responsibility In or der to obtain ser vice under this w arranty , you must mail the W alker Clarity to: W alk er Equipment 4009 Cloud Springs Rd.
W -1000 P age 28 4009 Cloud Springs Rd. Ringgold, GA 30736 1-800-552-3368 E N G L I S H W1000_User_Guide 11/15/99, 9:39 PM 28.
デバイスClarity W-1000の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Clarity W-1000をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはClarity W-1000の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Clarity W-1000の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Clarity W-1000で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Clarity W-1000を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はClarity W-1000の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Clarity W-1000に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちClarity W-1000デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
