Aga RangesメーカーF107411-01の使用説明書/サービス説明書
ページ先へ移動 of 32
Elec tric R ange Ser vice Instruc tions F107411-01 ww w .aga-ranges .com This book contains man y impor tant safety messages. Always r ead and obey all safety messages.
W ARNING If the information in this manual is not follo wed exactly , a fi re ma y result causing propert y damage, personal injury or death. W ARNING The anti-tip device supplied with this range must be corr ectly fi tted when the range is installed .
3 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. Sec tions Diagnostics 5 Ser vicing P roc edures 11 T echnical Data 27 Schematic.
4 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished..
5 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. Diagnostics Check ing the Multifunc tion O ven 6 Check ing the Con vection O ve.
6 Check 1 Result P ossible Cause Open the oven door and turn on the o ven light Light does not work 1 No power to range 2 Light bulb failed (most likely cause) 3 F ault in power supply t o switch 4 F .
7 Check ing the Multifunc tion O ven.
8 Check 1 Result P ossible Cause Open the oven door and turn on the o ven light Light does not work 1 No power to range 2 Light bulb failed (most likely cause) 3 F ault in power supply t o switch 4 F .
9 Check ing the Con vection O ven.
10.
11 Contents 1. T o change oven light bulb . 12 2 How to Mov e the R ange for Servicing 12 3. T o Remove a Side P anel 13 4. T o Lift up the Ceramic Hob 14 5. T o replace a hob element. 15 6. T o replace a C ooktop W armer element. 15 7. T o replace the cooktop neon indicat or lights pack 16 8.
12 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. Ser vicing Notes Disconnect from electricity supply before commencing servicin.
13 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. Replaceing the Range Reverse proc edure to reinstall the range and low er the front roller . Make sure the an ti-tip device is re- engaged properly when the range is r eplaced.
14 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 4. T o Lift up the Ceramic Hob Pull the range f or ward. Pull off the push fi t control panel end caps at each end and remov e the end fi xing screws under the end cap .
15 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 5. T o replace a hob element. Lift up the ceramic hob see 4. The elements are now accessible . Remove the scr ew in the center of the element and slide it out to the side.
16 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 7. T o replace the c ooktop neon indicator lights pack Lift up the ceramic hob see section 4. The neon indicator light pack is held to the support bracket by two clips.
17 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 9. T o Remove Oven Light S witch Remove c ontrol panel (see 8).
18 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 12. T o Remove a Thermostat Lift up the cooktop - see 4. Remove the c ontrol panel - see 8 Remove the ov en shelves. Undo the range rear cov er screws and lift covers clear .
19 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 13. T o Change Cooktop or Broiler C ontroller Lift up the ceramic hob top (see 4). Remove c ontrol panel (see 8). Disconnect wiring from controller – make a note of the wire colors and t erminal connections.
20 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 15. T o Remove an Oven Door Door is heavy - take care. Open oven door and r emove Handyrack (where fi tted) by springing one side out of the bracket on the door and sliding the other side free.
21 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 16 T o Adjust the Oven Door Angle The ov en doors are heavy . T ransit of the range can cause the oven doors t o move so that they are not correctly aligned.
22 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 17. T o Change O ven Door Outer P anel Remove the two plastic blanking plugs from the door handles. Remov e the 4mm Hex headed screws holding the handle to the door with the hexagon key tool.
23 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 19. T o Remove the Oven Door Seal Open oven door . The seal is held in place by small hooks on the rear face . At the corner pull seal diagonally away fr om the door centre until that hook is released.
24 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 22. T o Remove an Oven Inner Back Open the oven door .
25 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. 25. T o Remove the L eft Hand Multifunc tion Oven Bottom and T op Elements Bottom Element Pull the range f or ward to access the r ear of the range, see the section ‘How T o Move the Range for Servicing’ .
26 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished..
27 SERVICING W ARNING Disconnect from electricity before servicing. Check appliance is saf e when you hav e finished. T echnical Data DA T A BADGE L OCA TION: Inside base of drawer ca vit y - remov e drawer . For r emoval of drawer see installation instructions.
28 Schematic diagram of the R ange Caution: Label all wires prior to disconnection when servicing controls . Wiring err ors can cause improper and dangerous operation.
29 Code Description BRE Broiler elements BSB Br oiler switch block BT C Broiler contr oller CFM Cooling fan motor IGS Ignition swit ches ISG Ignition spark generat or LBE Left hand bottom element LFE .
30.
31.
Aga Ranges 110 W oodcrest Road Cherr y Hill, NJ 08003 USA 1.866.4AGA.4USA ww w .aga-ranges.c om Email suppor t@aga-ranges.com.
デバイスAga Ranges F107411-01の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Aga Ranges F107411-01をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAga Ranges F107411-01の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Aga Ranges F107411-01の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Aga Ranges F107411-01で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Aga Ranges F107411-01を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAga Ranges F107411-01の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Aga Ranges F107411-01に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAga Ranges F107411-01デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
