Cub CadetメーカーLTI050の使用説明書/サービス説明書
ページ先へ移動 of 39
Operator's Manual SERIES 1000 Hydrostatic Lawn Tractor Models LT1042 LT1045 LT1046 LTI050 IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal c.
TABLE OF CONTENTS Content Important Safe Operation Practices Slope Gauge Tractor Set-up Know Your Lawn Tractor Operating Your Lawn Tractor Making Adjustments Maintaining Your Lawn Tractor Service Page.
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine.
23. Muffler and engine become hot and can cause a burn. Donot touch. 24. Check overhead clearances carefully before driving under low hanging tree branches, wires, door openings etc., where the operator may be struck or pulled from the unit, which could result in serious injury.
e. Use extreme care when approaching blind corners, doorways, shrubs, trees or other objects thatmay block your vision ofa child who may run into the machine. f. To avoid back-over accidents, always disengage the cutting blade(s) before shifting into reverse.
8. Never tamper with the safety interlock system or other safety devices. Check their proper operation regularly. 9. After striking a foreign object, stop the engine, disconnect thespark plug wire(s) andground against the engine. Thoroughly inspect themachine for any damage.
I.IJ I.IJ Q. &i Z I.IJ Sight and hold this levelwith a vertical tree... or a corner of a building... i _------ or a fence post | Sonts a 15o ! 15 °.
SECTION 3: TRACTOR SET-UP Shipping Brace Removal _, WARNING: Make sure the riding mower's engine is off, set the parking brake and remove the ignition key before removing the shipping brace. Locate the shipping brace, if present, and warning tag found on the right side of the cutting deck.
SECTION 4: KNOW YOUR LAWN TRACTOR A B C H J D F NOTE: Steering Wheel not shown for clarity, Figure I A Systems Indicator Monitor/Hour Meter B Throttle Control Lever C Choke Control D Parking Brake Lev.
Throttle Control Lever The throttle control lever is located on the left side of the tractor's dash panel. This lever controls the speed of the engine.
Systems Indicator Monitor / Hour Meter j / jr BATT. OIL 42.0 /// HOURS 1/10 PTO / BLADE PARKING .J ...... J LCD Located in the center of the tractor's console, the systems indicator monitor records, and displays on its LCD, hours of tractor operation whenever the ignition key is rotated out of the STOP position.
SECTION 5: OPERATING YOUR LAWN TRACTOR WARNING AVOID SERIOUS INJURY OR DEATH • GO UP AND DOWN SLOPES, NOT ACROSS. • AVOID SUDDEN TURNS. • DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIR • IF MACHINE STOPS GOING UPHILL, STOP BLADE(S) AND BACK DOWNHILL SLOWLY.
Setting the Gauge Wheels Select the height position of the cutting deck by placing the deck lift lever in any of the six different cutting height notches on the right fender. Adjust the deck wheels so that they are between l_-inch and _/2-inchabove the ground as follows.
Engaging the Parking Brake To engage the parking brake: • Fully depress the brake pedal and hold it while gently pushing the parking brake lever downward. • Hold the parking brake lever down while removing your foot from the brake pedal. • Once engaged, the parking brake lever and the brake pedal will lock in the "down" position.
Disengage the cruise control using one of the following methods: • Depress the brake pedal to disengage the cruise control and stop the tractor. • Lightly depress the drive pedal.
• For best results it is recommended that the first two laps be cut with the discharge thrown towards the center. After the first two laps, reverse the direction to throw the discharge to the outside for the balance of cutting. This will give a better appearance to the lawn.
SECTION 6: MAKING ADJUSTMENTS WARNING: Shut the engine off, remove the ignition key and engage the parking brake before making adjustments. Protect your hands by using heavy gloves when handling the blades. Leveling the Deck NOTE: Check the tractor's tire pressure before performing any deck leveling adjustments.
Parking Brake Adjustment If the tractor does not come to a complete stop when the brake pedal is completely depressed, or if the tractor's rear wheels can roll with the parking brake applied (and the hydrostatic relief valve open), the brake is in need of adjustment.
SECTION 7: MAINTAINING YOUR LAWN TRACTOR NOTE: Refer to Maintenance Chart on page 30 for a reference of recommended maintenance intervals. WARNING: Before performing any maintenance or repairs, disengage PTO, set parking brake, stop engine and remove key to prevent unintended starting.
Changing the Engine 011 The engine oil and oil filter should be changed after every 50 hours of tractor operation. WARNING: If the engine has been recently run, the engine, muffler and surrounding metal surfaces will be hot and can cause burns to the skin.
• Slowly pour oil into the fill tube. Fill the crankcase until the oil level reaches the full (F) mark on the dipstick (Refer to Page 19). • Reinstall the oil fill cap/dipstick securely into the oil fill tube. IMPORTANT: The oil fill cap/dipstick must be installed securely onto the tube at all times when the engine is operating.
Paper Element(Twin Cylinder Engine) The paper element should be replaced at least once a season, or every 100 hours of operation. Replace more frequently if the tractor is operated under extremely dusty conditions.
2. Disengage the PTO (Blade Engage), set the parking brake and stop the engine. 3. Thread the hose coupler (packaged with your tractor's Operator's Manual) onto the end of your garden hose. 4. Attach the hose coupler to the water port on your decks surface.
Carburetor NOTE: Carburetor adjustments should be made only after the engine has warmed up. The engines on Cub Cadet Series 1000 tractors are equipped with a fixed main jet carburetor. Carburetors are equipped with a idle speed adjustment screw and a low idle fuel mixture screw.
SECTION 8: SERVICE Tires WARNING: Never exceed the maximum inflation pressure shown on the sidewall of the tire. The recommended operating tire pressure is approximately 10 psi for the rear tires and 14 psi for the front tires. Refer to the tire sidewall for exact tire manufacturer's recommended or maximum psi.
Battery California Proposition 65 Warning: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. The battery is sealed and is maintenance-free.
Changing TheTransmission Drive Belt NOTE: Several components must be removed and special tools used in order to change the tractor's transmission drive belt. See your Cub Cadet dealer to have your drive belt replaced. Hydrostatic Transmission Keep the area around the transmission cooling fan free of grass and debris at all times.
50-inch Decks • To ease in removing the belt in later steps, loosen, but do not remove, the bolt which secures the pivoting idler pulley to the idler bracket.
LT1042 LT1045 & LT1046 LTI050 29.
SECTION 9: OFF-SEASON STORAGE Clean and lubricate the tractor as instructed in Section 7: MAINTAINING YOUR LAWN TRACTOR on page 19 of this manual before storing for an extended period. Engine If the engine will be out of service for two months or more, use the following storage procedure: • Clean the exterior surfaces of the engine.
SECTION 11: MAINTENANCE LOG Please keep a record of the maintenance performed on your tractor. Date Hour Meter Maintenance Performed by 31.
SECTION 12: TROUBLESHOOTING Trouble Engine fails to start Engine runs erratic Possible Cause(s) PTO/Blade Engage knob engaged. Parking brake not engaged. Spark plug wire(s) disconnected. Throttle control lever not in correct starting position. Choke not activated Fuel tank empty, or stale fuel.
SECTION 13: ATTACHMENTS & ACCESSORIES The following attachments and accessories are compatible for Series 1000 Lawn Tractors. See your Cub Cadet dealer or the retailer from which you purchased your tractor for information regarding price and availability.
SECTION 14: REPLACEMENT PARTS NOTE: Phone (800) 965-4CUB to order replacement parts or a complete Parts Manual (have your full model number and serial number ready).
SECTION 15: SPECIFICATIONS* LT1042 Capacities Fuel Tank Engine Crankcase (w/filter) Transmission Hydrostatic Transmission Make and Model Gear Ratio Forward Speed Reverse Speed Engine (Air-cooled, 4-cycle) Make Kohler Courage Model SV590 Cylinders Single Bore 3.
CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS TheCalifornia Air Resources Board and MTD Consumer Group Inc.are pleased to explainthe evaporative emission controlsystem warranty on your 2007 lawn mower.
KOHLER CO. FEDERAL AND CALIFORNIA EMISSION CONTROL SYSTEMS LIMITED WARRANTY UTILITY AND LAWN AND GARDEN ENGINES The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Kohler Co. are pleased to explain the Federal and California Emission Control Systems Warranty on your small off-road equipment engine.
CUB CADET LLC MANUFACTURER'SLIMITED WARRANTY FOR SERIES 1000 & SERIES 1500 TRACTORS IMPORTANT: To obtain warranty coverage ownermust present an original proofof purchase and applicable maintenance records to the servicing dealer. Please seethe operator's manual for information on requiredmaintenance and service intervals.
CUB CADET LLC, P.O. BOX 361131CLEVELAND, OHIO 44136-0019.
デバイスCub Cadet LTI050の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Cub Cadet LTI050をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCub Cadet LTI050の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Cub Cadet LTI050の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Cub Cadet LTI050で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Cub Cadet LTI050を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCub Cadet LTI050の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Cub Cadet LTI050に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCub Cadet LTI050デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。