DesaメーカーCB36Nの使用説明書/サービス説明書
ページ先へ移動 of 36
VENTED GAS FIREPLACE INST ALLA TION AND OWNER’S OPERA TION MANU AL 4" B-VENT DECORA TIVE GAS FIREPLACES MODELS (V)CB36N(E) AND (V)CB36P(E) W ARNING: If the information in this manual is not followed exactly , a re or explosion may result causing property damage, personal injury or loss of life.
www .desatech.com 1 17437-01D 2 W ARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property dam - age. Refer to this manual for correct installation and operational proce - dures. For assistance or additional information consult a qualified in - staller , service agency or the gas supplier .
www .desatech.com 1 17437-01D 3 Due to high temperatures, the appliance should be located out of trafc and away from furni ture and draperies. Do not place clothing or other ammable material on or near the appliance. Never place any objects on or around replace.
www .desatech.com 1 17437-01D 4 3. If you smell gas • shut off gas supply • do not try to light any appliance • do not touch any electric al switch; do not use any phone in your building • immediately call your gas supplier from a neighbor’s phone.
www .desatech.com 1 17437-01D 5 PRODUCT FEA TURES These are a few facts that can help you un- .
www .desatech.com 1 17437-01D 6 .
www .desatech.com 1 17437-01D 7 Figure 5 - Framing Clearances for Flush Wall Installation 36" (91.4 cm) 36 1 / 4 " (92.1 cm) 14 3 / 4 " (37.5 cm) Figure 6 - Framing Clearances for Corner Installation 28 5 / 8 " (72.7 cm) 21" (53.
www .desatech.com 1 17437-01D 8 Figure 9 - Clearances for Combustible Mantels Figure 8 - Side Clearances for Combustible Mantels PRE-INST ALLA TION PREP ARA TION Continued 1 1 / 2 " (3.8 cm) 3 1 / 2 " (8.9 cm) Outer Surround Combustible Material May Be Used Perpendicular Side Wall 5 1 / 4 " (13.
www .desatech.com 1 17437-01D 9 INST ALLA TION PRECA UTIONS NO TI C E: F ai lu re t o f o ll ow th es e i n- st ruc ti ons wi ll vo id th e w arr a nt y .
www .desatech.com 1 17437-01D 10 In each case the offsets must be supported .
www .desatech.com 1 17437-01D 1 1 VENTING INST ALLA TION Continued CHECKING FOR PROPER VENTING .
www .desatech.com 1 17437-01D 12 W ARNING: This appliance, when installed must be electri - cally grounded in accordance with local code or in the ab - sence of local code, with the current National Electric Code, ANSI/NFP A 70, or the Canadian Electric Code, CSA C22.
www .desatech.com 1 17437-01D 13 4. Connect one wire from receiver to male connector on high limit harness and one page 12).
www .desatech.com 1 17437-01D 14 Fi gu re 2 0 - Mi ll iv ol t Ig ni ti on W ir in g Di ag ra m Figure 21 - Electronic Ignition Wiring Diagram TH TP TH/TP WHITE RED DO NOT CONNECT TO 120V HIGH LIMIT SW.
www .desatech.com 1 17437-01D 15 FI REP LA CE I N ST AL LA TI ON Figure 22 - External Regulator with V ent Pointing Down (Propane/LP Only) Propane/LP Supply T ank External Regulator with V ent Pointing Down CAUTION: Use only new , black iron or steel pipe.
www .desatech.com 1 17437-01D 16 FI REP LA CE I N ST AL LA TI ON Continued IMPORT ANT : Install main gas valve (equip- ment shutoff valve) in an accessible location.
www .desatech.com 1 17437-01D 17 T est Pressures Equal T o or Less Than 1/2 PSIG (3.5 kPa) 1. Close equipment shutoff valve (see Fig- ure 25). .
www .desatech.com 1 17437-01D 18 Figure 28 - Removing Louver Panel Louver Panel Spring Latch Removing/Replacing Glass Door WAR N I N G : H a n d l e g l a s s door panel with care. Do not strike, slam or otherwise abuse glass. Do not operate fire - place with glass door removed, cracked or broken.
www .desatech.com 1 17437-01D 19 INST ALLING LOGS AND GLOWING EMBERS A 4 piece ceramic log set comes packed in - necessary to unpack and assemble logs and add hearth treatments.
www .desatech.com 1 17437-01D 20 O F F P I L O T O N OPERA TING FIREPLACE MANU AL IGNITION Sy STEM FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not fol- low these instructions exactly , a re or explosion may result causing property damage, per - sonal injury or loss of life.
www .desatech.com 1 17437-01D 21 OPERA TING FIREPLACE Continued MANUAL LIGHTING PROCEDURE 1. Remove glass door (see Removing/Re- placing Glass Door 2. Follow steps 1 through 8 under Lighting Instructions 3.
www .desatech.com 1 17437-01D 22 OPERA TING FIREPLACE Continued O F F P I L O T L O I H ON OFF REMOTE ON OFF O N Blower Control Knob (Optional Accessory) V ariable Control Knob Selector Switch in Remo.
www .desatech.com 1 17437-01D 23 INSPECTING B URNERS Thermocouple Thermopile 1/4" Pilot Burner Ignitor Figure 38 - Pilot Assembly (Millivolt Ignition System) 3/8" to 1/2&q.
www .desatech.com 1 17437-01D 24 CLEANING AND MAINTENANCE W ARNING: T urn off replace and let cool before cleaning. CAUTION: Y ou must keep control areas, burners, and cir - cu lat in g ai r pas sa ge s of r ep lac e clean. Inspect the se areas of replace before each use.
www .desatech.com 1 17437-01D 25 LOGS Installing Logs an.
www .desatech.com 1 17437-01D 26 TROUBLESHOO TING W ARNING: T urn off heater and let cool before servicing. Only a qualied service person should service and repair heater . CAUTION: Never use a wire, needle or similar object to clean ODS/pilot. This can damage ODS/pilot unit.
www .desatech.com 1 17437-01D 27 TROUBLESHOO TING Continued POSSIBLE CAUSE 1. Gas control knob not fully pressed in 2. G a s c o n t r o l k n o b n o t pressed in long enough 3.
www .desatech.com 1 17437-01D 28 TROUBLESHOO TING Continued POSSIBLE CAUSE 1. Turning gas control knob to HI position when burner is cold 2. Air in gas line 3. Dirty or partially clogged 1 . Flame impingement on logs 2.
www .desatech.com 1 17437-01D 29 TROUBLESHOO TING Continued POSSIBLE CAUSE valve is OFF 2. Air in gas line 3. Construction debris clog- 4.
www .desatech.com 1 17437-01D 30 TROUBLESHOO TING Continued W ARNING: If you smell gas • Shut off gas supply . • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor ’ s phone.
www .desatech.com 1 17437-01D 31 the factory .
www .desatech.com 1 17437-01D 32 P ARTS FIREPLACE ASSEMBL Y FOR MODELS (V)CB36N, (V)CB36P , (V)CB36NE AND (V)CB36PE 12 14 1-2 1-1 1-4 1-3 20 8 1 1 10 5 6 7 18 9 13 26 27 17 21 22 25 26 3 24 4 16 23 2 .
www .desatech.com 1 17437-01D 33 P ARTS .
www .desatech.com 1 17437-01D 34 P ARTS BURNER ASSEMBL Y FOR MODELS (V)CB36N (V)CB36P , (V)CB36NE AND (V)CB36PE H IG H V O L T A G E 3 4 5 6 7 8 9 1 21 20 24 28 25 26 29 27 30 31 22 15 23 2 Piezo Igni.
www .desatech.com 1 17437-01D 35 P ARTS .
117437 01 2701 Industrial Drive P .O. Box 90004 www .desatech.com WARRANTy KEEP THIS WARRANTy Always specify model and serial numbers when communicating with the factory .
デバイスDesa CB36Nの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Desa CB36Nをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはDesa CB36Nの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Desa CB36Nの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Desa CB36Nで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Desa CB36Nを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はDesa CB36Nの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Desa CB36Nに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちDesa CB36Nデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。