DesaメーカーCRL3124PA/NAの使用説明書/サービス説明書
ページ先へ移動 of 40
Sav e this manual for future reference. For more information, visit www .desatech.com UNVENTED (VENT -FREE) GAS LOG HEA TER OWNER’S OPERA TION AND INST ALLA TION MANU AL Biltmore Split Oak, Seasonal.
www .desatech.com 1 13097-01E 2 - .
www .desatech.com 1 13097-01E 3 SAFETY INFORMATION - .
www .desatech.com 1 13097-01E 4 4. If you smell gas • shut off gas supply • do not try to light any appliance • do not touch any electrical switch; do not use any phone in your building • immediately call your gas supplier from a neighbor’s phone.
www .desatech.com 1 13097-01E 5 Figure 1 - V ent-Free Gas Log Heater (Logs May V ary by Model, Seasonal Oak Single Burner Model Shown) Base Grate Log Set Control Knob Burner Piezo Ignitor PRODUCT IDENTIFICATION PRODUCT FEA TURES OpERA TION This heater is clean burning.
www .desatech.com 1 13097-01E 6 Exhaust fans, replaces, clothes dryers and fuel burni ng appl iances draw a ir fro m the h ouse t o operate. Y ou must provide adequate fresh air for these appliances. This will insure proper venting of vented fuel-burning appliances.
www .desatech.com 1 13097-01E 7 Example: Gas water heater ____________ Btu/Hr V ent-free replace + ___________ Btu/Hr T otal = ___________ Btu/Hr 4.
www .desatech.com 1 13097-01E 8 INST ALLA TION .
www .desatech.com 1 13097-01E 9 W.
www .desatech.com 1 13097-01E 10 Y ou must have noncombustible material(s) above the replace opening. Noncombustible materials (such as slate, marble, tile, etc.) must be at least 1/2 inch thick. With sheet metal, you must have noncombustible material behind it.
www .desatech.com 1 13097-01E 1 1 not meet the minimum clear- ances shown, you must do o.
www .desatech.com 1 13097-01E 12 Se e c ha rt bel ow for mi ni mum p erm an ent ue opening you must provide. Attach damper clamp so the minimum permanent ue opening will be maintained at all times.
www .desatech.com 1 13097-01E 13 INST ALLA TION Continued 7. Mark screw locati ons through holes in mount - ing brackets (see Figure 12 and 13). If install - ing in a brick-bottom replace, mark screw locations in mortar joint of bricks. 8. Remove heater base from replace.
www .desatech.com 1 13097-01E 14 For propane/LP units, the installer must supply an external regulator. The external regulator will reduce incoming gas pressure. You must reduce inco min g gas press ure to betwee n 11 and 14 inch es of water. If you do not reduce incoming gas pres - sure, heater regulator damage could occur.
www .desatech.com 1 13097-01E 15 INST ALLA TION Continued - .
www .desatech.com 1 13097-01E 16 INSTALLING LOGS - .
www .desatech.com 1 13097-01E 17 INST ALLA TION Continued Figure 22 - Installing Crossover Log #4 (CCL3930PTB/NTB Shown) Middle Log (#2) Back Log (#3) Pins Crossover Log (#4) 5.
www .desatech.com 1 13097-01E 18 INST ALLA TION Continued .
www .desatech.com 1 13097-01E 19 OPERATING HEATER MANUALLY-CONTROLLED MODELS FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not fol- low these instructions exactly, .
www .desatech.com 1 13097-01E 20 5. Slightly depress and turn control knob counterclockwise to the PILOT position. Press in control knob for ve (5) seconds (see Figure 30). Note: You may be running this heater for the rst time after hooking up to gas sup - ply.
www .desatech.com 1 13097-01E 21 THERMOST A T -CONTROLLED MODELS FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not fol- low these instructions exactly , .
www .desatech.com 1 13097-01E 22 5. Tu rn co nt ro l kno b co unt ercl ockw ise to the PILOT position. Press in control knob for ve (5) seconds (see Figur e 32). Note: Y ou may be running this heater for the rst time after hooking up to gas sup - ply .
www .desatech.com 1 13097-01E 23 INSPECTING B URNERS Check pilot ame pattern and burner ame pat - terns often. pILOT FLAME p A TTERN Figure 34 sh ows a cor rec t pil ot a me pa tt ern . Figure 35 sh ow s an in co rr ec t pi lo t am e pa tt er n.
www .desatech.com 1 13097-01E 24 2. Ins pect bur ner , pil ot and primar y air inlet hole s on injector holder for dust and dirt (see Figure 36). 3. Blow air through the ports/slots and holes in the burner . 4. Check the injector holder located at the end of the burner tube again.
www .desatech.com 1 13097-01E 25 TROUBLESHOO TING .
www .desatech.com 1 13097-01E 26 TROUBLESHOO TING Continued 1. Burner orice clogged 2. Inlet gas pressure is too low 1. Manifold pressure is too low 2. Burner orice clogged 1. Burner orice is clogged or damaged 2.
www .desatech.com 1 13097-01E 27 TROUBLESHOO TING Continued .
www .desatech.com 1 13097-01E 28 OPTIONAL POSITIONING OF THERMOST A T SENSING B ULB .
www .desatech.com 1 13097-01E 29 4. The mounting clip must be a minimum of 3" from bottom of replace to prevent crimping of capillary . Once you have decided on a location, clean the area thoroughly . Remove the paper backing from the adhesive on back of mounting clip.
www .desatech.com 1 13097-01E 30 ILL USTRA TED P ARTS BREAKDOWN .
www .desatech.com 1 13097-01E 31 P ARTS LIST This list contains replaceable parts used in your heater.
www .desatech.com 1 13097-01E 32 ILL USTRA TED P ARTS BREAKDOWN .
www .desatech.com 1 13097-01E 33 P ARTS LIST This list contains replaceable parts used in your heater.
www .desatech.com 1 13097-01E 34 ILL USTRA TED P ARTS BREAKDOWN .
www .desatech.com 1 13097-01E 35 P ARTS LIST This list contains replaceable parts used in your heater.
www .desatech.com 1 13097-01E 36 ILL USTRA TED P ARTS BREAKDOWN .
www .desatech.com 1 13097-01E 37 P ARTS LIST This list contains replaceable parts used in your heater.
www .desatech.com 1 13097-01E 38 REPLACEMENT P ARTS Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty .
www .desatech.com 1 13097-01E 39 5 Manila A ve Hamden, CT 06514-0322 1-800-397-7553 203-248-7553 342 N. County Rd. 400 East V alparaiso, IN 46383-9704 219-462-7441 1-888-619-7060 www .
Model Serial No. Date Purchased WARRANTY INFORMA TION KEEP THIS WARRANTY Always specify model and serial numbers when communicating with the factory . W e reserve the right to amend these specications at any time without notice. The only warranty applicable is our standard written warranty .
デバイスDesa CRL3124PA/NAの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Desa CRL3124PA/NAをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはDesa CRL3124PA/NAの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Desa CRL3124PA/NAの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Desa CRL3124PA/NAで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Desa CRL3124PA/NAを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はDesa CRL3124PA/NAの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Desa CRL3124PA/NAに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちDesa CRL3124PA/NAデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
