Directed Electronicsメーカー5101の使用説明書/サービス説明書
ページ先へ移動 of 44
Remote Start Keyless Entr y Model 5101 Owner’ s Guide © 2009 Directed Electronics, Vista, CA G4102V 2009-08.
.
i © 2009 Directed Electronics. All rights reserved. Contents Government regulations .................................................................................... iii W arning! Safety first ......................................................
ii © 2009 Directed Electronics. All rights reserved. Using the remote start ......................................................................................17 Manual transmission vehicles ........................................................
iii © 2009 Directed Electronics. All rights reserved. Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device ma.
iv © 2009 Directed Electronics. All rights reserved. This device complies with the Industr y Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interference to ser vices authorized by IC.
v © 2009 Directed Electronics. All rights reserved. W ar ning! Safety first The following safety warnings must be obser ved at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer .
vi © 2009 Directed Electronics. All rights reserved. Use of this product in a manner contrar y to its intended mode of operation may result in property damage, personal injur y , or death. (1) Never remotely start the vehicle with the vehicle in gear , and (2) Never remotely start the vehicle with the keys in the ignition.
1 © 2009 Directed Electronics. All rights reserved. What’ s included T wo five-button/1-way Supercode remotes • The control module (installed out-of-sight) • Control Center with integrat.
2 © 2009 Directed Electronics. All rights reserved. ➢ System maintenance The system requires no specific maintenance. Y our remote is powered by a small coin cell lightweight 3-volt lithium batter y that lasts approximately one year under normal use.
3 © 2009 Directed Electronics. All rights reserved. T urn both the unit 2. front and circuit board over , remove battery from clip and replace. Note: V erify that the bat- ter y polarity is correct when replacing. Reposition all parts and snap together .
4 © 2009 Directed Electronics. All rights reserved. 1-way remote 1 3 4 5 6 2 A U X Feature Description 1 T ransmit indicator 2 Lock button Press for one second to lock. 3 Unlock button Press for one second to unlock. 4 Remote start button Press for one second to activate remote start.
5 © 2009 Directed Electronics. All rights reserved. ➢ T ransmitter configuration Basic Commands Advanced Commands Function Level 1 Function Level 2 Function Level 3 Function Level 4 Button Level D.
6 © 2009 Directed Electronics. All rights reserved. Control Center The Control Center , typically located on the upper par t of the front windshield sends and receives commands or messages to and from your system. It consists of: The In-vehicle system antenna, for 1-way communication to the system.
7 © 2009 Directed Electronics. All rights reserved. Basic commands ➢ Lock A U X Command : Press one time to Lock. Notes: Press/hold for 1.5 seconds to lock the system and then activate the Panic output. For Panic to work, the optional horn honk feature must be connected.
8 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 1 ➢ Silent lock Command : Press A U X one- time and then press A U X Notes : Locks the system without horn honks* ➢ Silent unlock Command : Press A U X one- time and then press A U X .
9 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 2 ➢ V alet mode Command : Press A U X two-times and then A U X . Notes: Prevents the system from automatically activating the Failsafe Starter Kill and locking the door passively .
10 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 3 ➢ Car finder Command : Press A U X three-times and then A U X . Notes : The vehicle emits 1 long horn honk and the parking lights flash 10 times. Lock/Unlock cancels the parking light flashes.
11 © 2009 Directed Electronics. All rights reserved. Advanced commands: function level 4 ➢ Rear defogger* Command : Press A U X four times, and then A U X . (after remote start is on.) Notes : Manually turns on the defogger when remote start is on.
12 © 2009 Directed Electronics. All rights reserved. Using the system ➢ Locking the vehicle T o lock the vehicle, press the button on the remote control. The horn in the vehicle honks one-time, and the parking lights flash one-time. If the power door locks are connected, the doors lock and the optional Failsafe Starter Kill activates.
13 © 2009 Directed Electronics. All rights reserved. ➢ V alet mode Y ou can prevent your system from automatically activating the Failsafe® Star ter Kill. When the system is in V alet mode, the feature is disabled. The doors do not automatically lock.
14 © 2009 Directed Electronics. All rights reserved. ➢ Configuring your remote The remote control has a menu for programming user features. Before you start make sure the keypad is unlocked. (See Button Auto Lock ) T o configure the remote user features: Press and hold the 1.
15 © 2009 Directed Electronics. All rights reserved. ➢ Programming T o enter: hold the A U X button for 8 seconds, the transmit LED turns on, the pro- gramming main menu has been accessed. T o exit: press and release the A U X button to go back and repeat to exit.
16 © 2009 Directed Electronics. All rights reserved. Placing the remote into the remote pair mode: Press and hold the 1. button for 8 seconds. If the transmit LED flashes at 3 seconds, disregard and continue to hold. W ait for the T ransmit LED to light solid.
17 © 2009 Directed Electronics. All rights reserved. Using the remote star t Read this user guide, including the W arnings section at the beginning of this guide before using the remote start . Ensure that the vehicle is parked in an open area, not in a garage.
18 © 2009 Directed Electronics. All rights reserved. ➢ Manual transmission vehicles When installed into a manual transmission vehicle, the system requires that the MTS mode is properly set when parking. If MTS mode is not properly set or is defeated after being properly set the system will not start the engine.
19 © 2009 Directed Electronics. All rights reserved. ➢ Timer mode This unit can be programmed to start and run the engine ever y three hours, for a maximum of six cycles. The engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine.
20 © 2009 Directed Electronics. All rights reserved. T o exit timer mode without the transmitter: Make sure the remote start system is not operating the engine. 1. T ur n the ignition on. Timer Mode is exited and the parking lights flash 2. slowly four times.
21 © 2009 Directed Electronics. All rights reserved. After exiting the vehicle, lock the system. The vehicle remains running for the programmed runtime. (The remote start feature is still enabled). Y ou can still remote star t the vehicle after the turbo timer has timed out and shut Off the vehicle.
22 © 2009 Directed Electronics. All rights reserved. Use one of the below methods to exit Smart Star t mode: Perform the same steps you followed to activate Smar t Start mode • T ur n the ignition On • Press the brake pedal • The parking lights flash 5 times slowly to confirm the remote has exited Smart Start mode.
23 © 2009 Directed Electronics. All rights reserved. ➢ Pit Stop mode The Pit Stop mode feature allows the vehicle to remain running after the key has been removed from the ignition.
24 © 2009 Directed Electronics. All rights reserved. Safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components.
25 © 2009 Directed Electronics. All rights reserved. Diagnostics The microprocessor at the heart of the system is constantly monitoring the switches that are connected to the main unit.
26 © 2009 Directed Electronics. All rights reserved. Owner recognition Owner recognition lets up to four users of the system have unique settings to meet their specific needs. It is almost like having four separate systems in your vehicle, one for each user .
27 © 2009 Directed Electronics. All rights reserved. Programming options Y our system has many custom programmable options. Some may require instal- lation labor . Ask your authorized dealer for details. The following is a list of the programmable options, with the factor y settings in Bold .
28 © 2009 Directed Electronics. All rights reserved. Convenience expansions Listed below are some of the expansion options available. Please consult your dealer for a complete explanation of all the options available to you.
29 © 2009 Directed Electronics. All rights reserved. Glossar y of terms Control Center: The Control Center contains the system’ s radio-frequency antenna, the Control button, and the Status LED. For maximum remote-control range, the Control Center is usually located at the top of the windshield, centered near the rear-view mirror .
.
31 © 2009 Directed Electronics. All rights reserved. Quick reference guide Locking • T o lock press for one second. The doors lock. The LED on the Control Center flashes and the horn honks one time. (if connected). The parking lights flash once to confirm locking.
32 © 2009 Directed Electronics. All rights reserved. Remote Start • Press A U X . The parking lights turns on (if connected). The vehicle starts and runs for the programmed duration. Rear Defogger* • Press four-times, and then press A U X (only after remote start is On.
33 © 2009 Directed Electronics. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’ .
34 © 2009 Directed Electronics. All rights reserved. WITHOUT LIMIT A TION, LIABILITY FOR THEFT , DAMAGE AND/OR V ANDALISM. THIS W ARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOV AL OR REINST ALLA TION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND.
.
G4102V 2009-08 Vista, CA 92081 www .directed.com © 2009 Directed Electronics—All rights reser ved The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available.
デバイスDirected Electronics 5101の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Directed Electronics 5101をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはDirected Electronics 5101の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Directed Electronics 5101の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Directed Electronics 5101で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Directed Electronics 5101を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はDirected Electronics 5101の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Directed Electronics 5101に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちDirected Electronics 5101デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。