DymoメーカーLabelWriter 450の使用説明書/サービス説明書
ページ先へ移動 of 28
User Guide D YMO ® LabelW rit er ® Label P rint ers.
Copyright © 2009-2010 Sanford, L.P. All rights reserved. Revised 1/10. No part of this document or the software may be reproduced or transmitted in any form or by any means or translated into another language without the prior written consent of Sanford, L.
iii Contents About the LabelWriter Printer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 LabelWriter Printer Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
iv.
1 Chapter 1 About the LabelWriter Printer Congratulations on purchasing a DYMO LabelWriter label printer. Your LabelWriter printer will give you years of reliable label printing. We encourage you to take a few minutes to review how to use and care for your printer.
About the LabelWriter Printer 2 Top cover Label spool Label release Label feed path and tear bar Label roll Label guide Reverse label button Form-feed button and status light S/N 00000-0000000 DC powe.
System Requirements 3 The form-feed button on the front of the printer advances a single label. The reverse label button is used to remove labels from the printer when changing rolls. The LabelWriter SE450 does not include a reverse label button. The status light visually shows the current state of the printer.
About the LabelWriter Printer 4 LabelWriter CD. The SDK provides COM and .NET interfaces. For more information, visit the Developer Program page on the DYMO web site. www.dymo.com . You can check the Developer’s forum on the DYMO Web site at www.dymo.
5 Chapter 2 About Labels DYMO LabelWriter printers use advanced thermal printing technology to print on specially treated, heat-sensitive labels. This means you will never have to replace toner, ink cartridges, or a ribbon to print labels.
About Labels 6 Important! In order for the labels to feed properly during printing, pay attention to the following when loading labels on the spool and into the printer: • The label spool guide must be pushed flush against the label roll, with no gap.
Ordering Labels 7 To load a label cassette (LabelWriter Duo) 1 Press the button on the front of the printer to open the label cassette tray. Note The first time you use the printer, remove the protective cardboard insert from the label exit slot. See Figure 5.
About Labels 8 This page intentionally left blank for double-sided printing..
9 Chapter 3 Printing Over a Network This chapter describes how to print to a DYMO label printer over a network. The topics covered in this chapter are: • “Printing to a Shared Printer from Windows.
Printing Over a Network 10 To share the printer 1 Choose Printers and Faxes from the Start menu. The Printers and Faxes control panel is displayed. 2 Right-click the printer you want to share and select Sharing . The DYMO label printer Properties dialog boxappears with the Sharing tab selected.
Printing to a Shared Printer from Mac OS 11 To add a network printer ♦ Use the standard Windows Add Printer Wizard to add the shared label printer to your computer. Refer to your Windows documentation for more information about adding a network printer.
Printing Over a Network 12 3 Select the printer you want to share and then click Sharing . The Sharing pane is displayed. Note To share the DYMO LabelWriter Duo printer, which can print on both labels and tape, select both the LabelWriter DUO Label and the LabelWriter DUO Tape 128 printers.
Using a Print Server 13 4 Select the printer and then click Add . The shared printer is added to the Printer List dialog box. Note The LabelWriter Duo printer is actually two printers (Label and Tape), so you must add both printers separately. 5 Close the Printer List dialog box.
Printing Over a Network 14 Printer Firmware Versions that Support Print Servers Refer to the table below for information about the label printer firmware versions that support print servers. You can determine your printer’s firmware version by checking the serial number printed on the bottom of the printer.
15 Chapter 4 Caring for Your Printer The LabelWriter printer is designed to give you long and trouble-free service, while requiring very little maintenance. You will get the best possible performance from your LabelWriter printer if you follow the setup instructions that appear in the Quick Start Guide and the procedures described in this section.
Caring for Your Printer 16 To clean the tape print head (LabelWriter Duo only) 1 Press the button on the front of the label cassette tray. 2 Remove the label cassette. 3 Use a small, soft brush or cotton swab to wipe away paper dust and other stray particles from the inside of the tray.
17 Chapter 5 Getting Help Your LabelWriter printer should offer years of trouble-free printing with very little maintenance. However, in the event that you encounter a problem, this chapter offers suggestions for resolving problems that can occur when using the printer.
Getting Help 18 Performing a Printer Self-Test If you experience problems with broken characters or other print quality issues, perform a printer self-test. The self-test verifies that all elements of the print head and printing mechanism are in working condition.
Troubleshooting 19 • Make sure your labels are loaded properly and that the left edge of the label is aligned with the left edge of the label feed slot.
Getting Help 20 Limited Warranty Your DYMO ® LabelWriter ® printer comes with a warranty against defects in materials, design, or workmanship, for two years from the original date of purchase (LabelWriter SE450 for one year from the original date of purchasea), when used in accordance with all operating instructions.
21 Chapter 6 Technical and Environmental Information This chapter contains technical and certification information for the LabelWriter printer. Technical Specifications 450 450 Turbo 450 Twin Turbo 4XL 450 Duo (Label Printer) 450 Duo (Tape Printer) Print Method Direct Thermal Thermal Transfer Print Resolution 300 dots per inch (11.
Technical and Environmental Information 22 LabelWriter SE450 Printer Technical Specifications For complete information about connecting the LabelWriter SE450 printer to the host computer or other devi.
Declaration of Conformity 23 Declaration of Conformity Description: Direct Thermal Printer Model: DYMO LabelWriter 450, 450 Turbo, 450 Twin Turbo, and 4XL This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC (Federal Communications Committee) rules.
Technical and Environmental Information 24 Environmental Information The equipment that you bought has required the extraction and use of natural resources for its production.
デバイスDymo LabelWriter 450の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Dymo LabelWriter 450をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはDymo LabelWriter 450の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Dymo LabelWriter 450の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Dymo LabelWriter 450で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Dymo LabelWriter 450を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はDymo LabelWriter 450の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Dymo LabelWriter 450に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちDymo LabelWriter 450デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。