AiwaメーカーXR-EC10の使用説明書/サービス説明書
ページ先へ移動 of 16
U XR-EC10 XR-EC12 8C-CL3-903-01 020301ASW-H-M For assistance and information (United States and Puerto Rico) Owner’ s record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below .
2 En W ARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equ.
3 En Outdoor Antenna Power lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits.
4 En Before starting connection, check that the protective tag has been taken off (see page 3). Connection Plug in the AC power cord to the AC outlet after all other connections are made. 1 Connect the speaker cords to the speakers. Connect the copper cords to the + terminals and the silver cords to the – terminals.
5 En PA RTS AND CONTROLS Main unit 1 4 5 6 8 3 2 7 5 VOLUME Adjusts the volume. 6 s CLEAR CD: stops playback. Radio: clears a preset station. CD E Starts and pauses play . f / r , t / g (TUNING DOWN, UP) CD: skips to a previous or a succeeding track when pressed, searches a track in fast forward or reverse playback when held down.
6 En Remote control 1 8 5 6 4 ! 9 # 0 @ 2 3 7 Buttons with the same or similar names on the main unit basically have the same function. 1 POWER 2 0–10, +10 CD: selects a track of the specified number . Radio: tunes in the station with the specified preset number .
7 En ADJUSTMENTS BEFORE OPERA TION Power Tu rning the unit on Press POWER 6 ST ANDBY/ON (POWER on the remote control). Alternatively , press TUNER/BAND, AUX, DISC DIRECT PLA Y or CD. Playback will start automatically if a disc is loaded. Tu rning the unit off Press POWER 6 ST ANDBY/ON again.
8 En This unit plays back finalized CD-R/RW discs as well as audio CDs. Playing CDs 1 Press CD1 z OPEN/CLOSE to open the disc tray . Place a disc with the label side up.
9 En Random/Repeat play In random play mode the unit plays all the tracks in random order . In repeat play mode it plays repeatedly all the discs or the track being played. Y ou can select random and r epeat a ll play at the same time. 1 Press RANDOM/REPEA T repeatedly on the remote control.
10 En RADIO OPERA TIONS Manual tuning 1 Press TUNER/BAND repeatedly to select a band. The unit switches to the radio from any other function and alternates between FM and AM. 2 Press f or g repeatedly to tune in a station. " TUNE " is displayed when a station is tuned in.
11 En Adjustments To switch to monaural FM reception Hold down SHIFT and press TUNER MODE on the remote control so that " MONO " is displayed. To cancel, r epeat the above so that “ STEREO ” is displayed. Tip : When FM stereo reception is poor , switching to monaural reduces noise.
12 En TIMER OPERA TIONS Setting the clock 1 Hold down SHIFT and press CLOCK on the remote control. When the unit is turned off, you can also press SET . 2 Within 6 seconds, press f or g to set the time. Each press changes the time in 1-minute steps. Holding these buttons down will vary the time in 10-minute units.
13 En To check the timer setting Press TIMER on the remote control so that " 5 PLAY " appears on the display . After 6 seconds, the timer -on time, the source and the timer- activated duration are displayed for 6 seconds. To change the timer setting Reset the timer again.
14 En Care and maintenance Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit. To clean the cabinet Use a soft and dry cloth. If the unit surfaces are extremely dirty , use a soft cloth lightly moistened with mild detergent solution.
15 En Specifications MAIN UNIT CX-LEC10, CX-LEC12 TUNER FM tuning range 87.5 MHz to 108 MHz FM usable sensitivity (IHF) 13.2 dBf FM antenna terminal 75 ohms (unbalanced) AM tuning range 530 kHz to 171.
Printed in Malaysia NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
デバイスAiwa XR-EC10の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Aiwa XR-EC10をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAiwa XR-EC10の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Aiwa XR-EC10の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Aiwa XR-EC10で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Aiwa XR-EC10を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAiwa XR-EC10の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Aiwa XR-EC10に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAiwa XR-EC10デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
