Ecom InstrumentsメーカーEx-GSM 01の使用説明書/サービス説明書
ページ先へ移動 of 29
ecom instruments GmbH Industriestr .2 97959 Assamstadt Germany T el.: +49 (0) 62 94 / 42 24-0 Fax: +49 (0) 62 94 / 42 24-90 E-Mail: sales@ecom-ex.com 0163AL01A01 1 1/05 Subject to change without notice! Safety instructions Ex-GSM 01 BAL Ex-GSM 01_US_Umschl #6 29.
1 1 Application 2 2 Safety instructions 2 3 Errors and load restrictions 2 4 Safety regulations 3 5 Ex-data 3 6 Accessories 3 7 T echnical Data 3 8 Operating instructions 4 8.1 Safety in traffic 4 8.2 Operating environment 4 8.3 Electronic equipment 4 8.
2 Note: The current safety instructions, and the Ex-certificate are available for download from the relevant product page under www .ecom-ex.com; alternatively they can be requested directly from the manufacturer .
3 4 Safety regulations Any person using the unit must observe the standard safety regulations and read the certificate to prevent incorrect operation or abuse of the unit. The following additional safety regulations must also be observed: - The unit must not be opened within the Ex-area.
4 Size: 4.1 in x 1.8 in x .9 in (10.6 cm x 4.7 cm x 2.4 cm) W eight: 3.5 ounces (101 grams) 8 Operating instructions Before using the equipment for the first time, please read the safety and ope- rating instructions very thoroughly .
5 8.3.1 Cardiac pacemaker The following instructions apply to persons fitted with a cardiac pacemaker: • When the mobile phone unit is switched-on, ensure that a minimum distance of 20 cm between the mobile- phone unit and the Pacemaker is maintained.
6 8.4 T ransport 8.4.1 Motor vehicles In certain circumstances, RF signals can interfere with the correct functioning of incorrectly installed or inadequately screened systems in your motor vehi- cle (e.g. electronically controlled fuel injection, electronic ABS - (Antilock Brake Systems), electronic speed controllers or airbag systems).
7 Procedure in the event of an emergency call: 1. Switch the telephone on if it is not already switched on. Check whether the signal strength is adequate. In certain networks it may be necessary to plug a valid SIM card into the telephone. 2. Press the red off / END key as many times as is necessary (e.
8 the FCC is 1.6 W/kg*. T ests for SAR are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certi- fied power level in all tested frequency bands.
9 standard incorporates a substantial margin of safety to give additional protec- tion for the public and to account for any variations in measurements. SAR values may vary depending on national reporting requirements and the net- work band. For SAR information in other regions please look under the pro- duct information at www .
10 1 – With the back of the phone facing you, press the indentations on both sides of the lower shell. 2 – Slide the bottom of the shell off to remove it. 3 – Grasp the removal flap, and gently pull it up. 4 – Lift the battery from the compartment.
11 12 – Place the phone into the lower shell, sliding the shell forward until it locks into place. 10.1.2 Charging the battery W arning: Use only batteries, chargers, and enhancements approved by Nokia for use with this particular model. The use of any other types may invalidate any approval or warranty , and may be dangerous.
12 Hold the phone as you would any other telephone with the antenna pointed up and over your shoulder . T o switch the phone on or off, press and hold the power key . If the phone displays Insert SIM card, even though the SIM card is properly inserted or SIM card not supported, contact your service provider .
13 9 — End key , to end a call, or to exit functions. 10 — Keys - , to enter numbers and characters. Keys and are used for various purposes in different functions.
14 5 – Slide the upper shell onto the phone. 6 – Slide the lower shell onto the phone until it clicks into place, meeting the upper shell. 10.1.6 Attaching the carrying strap to the phone 1 – Connect the elastic band to the holster . 2 – Connect the pins on the end of the hol- ster to the holes in the lower end of the phone.
15 1 - Shows the name of the network or the operator logo to indicate the cellu- lar network in which the phone is currently being used. 2 - Shows the signal strength of the cellular network at your current location. The higher the bar , the stronger the signal.
16 The stopwatch is running. The GPRS connection mode Always online is selected and the (E)GPRS service is available. The indicator for GPRS and EGPRS is the same. An (E)GPRS connection is established. The (E)GPRS connection is suspended (on hold), for example, if there is an active call during an (E)GPRS dial-up connection.
17 • T o lock the keypad in standby mode, press Menu and within 1.5 seconds. • T o unlock the keypad, press Unlock and within 1.5 seconds. • T o answer a call when the keyguard is on, press . During a call, the phone can be operated normally . When you end or reject a call, the keypad automatically locks again.
18 Enhanced GPRS (EGPRS), uses enhanced data rates for global evolution (EDGE), a radio interface modulation technique, to increase the data rates of GPRS. The functions of your phone that may use (E)GPRS are messaging, browsing pages, e-mail, remote synchronization, application downloading, and the PC dialup (for example, Internet and e-mail).
19 group of people having compatible devices. When your call is connected, the person or group you are calling does not have to answer the phone. Besides the GPRS counters, the phone registers only one-to-one calls in the recent call list in Call log .
20 The module PIN is required to access the information in the security module. The module PIN is supplied with the SIM card if the SIM card has a security module in it. The signing PIN is required for the digital signature. The signing PIN is supp- lied with the SIM card if the SIM card has a security module in it.
21 device does get wet, remove the battery and allow the device to dry comple- tely before replacing it. • Do not use or store the device in dusty , dirty areas. Its moving parts and electronic components can be damaged. • Do not store the device in hot areas.
22 equipment to the manufacturer . We reserve the right to repair , renew the set- tings or exchange the device. The above-mentioned warranty conditions are the sole and only right of the purchaser to compensation, are exclusively valid and replace all other con- tract or legal warranty obligations.
23 14 Certificate of Compliance 14.1 For USA.
24.
25 14.2 For Canada.
26.
27 15 Control Drawing How to connect the Ex-GSM 01 cell phone with the power outlet outside the hazardous areas see following diagram. Control drawing number: 0163EX04A.
ecom instruments GmbH Industriestr .2 97959 Assamstadt Germany T el.: +49 (0) 62 94 / 42 24-0 Fax: +49 (0) 62 94 / 42 24-90 E-Mail: sales@ecom-ex.com 0163AL01A01 1 1/05 Subject to change without notice! Safety instructions Ex-GSM 01 BAL Ex-GSM 01_US_Umschl #6 29.
デバイスEcom Instruments Ex-GSM 01の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Ecom Instruments Ex-GSM 01をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEcom Instruments Ex-GSM 01の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Ecom Instruments Ex-GSM 01の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Ecom Instruments Ex-GSM 01で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Ecom Instruments Ex-GSM 01を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEcom Instruments Ex-GSM 01の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Ecom Instruments Ex-GSM 01に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEcom Instruments Ex-GSM 01デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
