ElectroluxメーカーEWG 14550 Wの使用説明書/サービス説明書
ページ先へ移動 of 28
user manual Washing Machine EWG 14550 W.
Electrolux. Thinking of you. Share more of our thinki ng at www.electrolux.com Contents Safety information 2 Product description 4 Control panel 5 First use 7 Personalisation 7 Daily use 8 Helpful hints and tips 11 Washing programmes 12 Care and cleaning 15 What to do if.
Installation • This appliance is h eavy. Care should be taken when moving it. • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. • All packing and transit bolts must be re- moved before use.
Product description Your new appliance meets all modern requir ements for effective treatm ent of laundr y with low water, energy and detergent consum ption. Its new washing system allows total use of detergent and reduces wate r consumption so saving energy.
Control panel Below is a picture of the control panel. It shows the progra mme selector dial as well as the buttons, pilo t light and the display. These are presented by relevant numbers on the following pages.
up to a maximum of 20 hours by means of this button. Start Pause This button allows you to start or to interrupt the selected programme. Time Manager These buttons allows yo u to modify the pro- gramme duration automatically proposed by the appliance.
After having pressed button 8 only the icon of the running phase stays on. 7.3: Heating phase During the washing cycle the display shows a temperature icon indi cating that the appli- ance has started the heating phase of the water in the tub.
also when the washing machine is not work- ing. There are two different ways to set this op- tion: 1. Before pressing button 8 : it will be im- possible to start the machine. 2. After pres sing button 8 : it will be impos- sible to change any other programme or option.
will propose a temperature and automatically select the maximum spin value provided for the programme you have chosen. You can change these values by operating the corre- sponding buttons. The green pilot light of the button 8 starts to flash. The selector dial can be turned either clock- wise or counterclockwis e.
again . If you have chosen a delayed start, the machine will begin the countdown. If an incorrect option is selected, the red pilot light of the button 8 blinks for 3 times the message Err is displayed for a few seconds.
At the end of the programme The machine stops au tomati cally. Three blinking 0.00 appear on the display and the pilot light of button 8 goes off. Som e acoustic signals sound.
acid; treat any residual marks on white fab- rics with bleach and th en rinse thoroughly. Tar stains: first treat with stain remover, me- thylated spirits or benz ine, then rub with de- tergent paste.
Programme Maximum and Minimum Tempe rature Cycle Descrip tion Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Deter gent Co m- partment COTTONS ECONOMY 90° - 40° Main wash - Rinses Maximum spin speed 1400 rpm Max. load 6 kg White and fas t coloured c otton .
Programme Maximum and Minimum Tempe rature Cycle Descrip tion Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Deter gent Co m- partment WOOL 40° - Cold Main wash - Rinses Maximum spin speed 900 rpm Max. load 2 kg Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics.
Programme Maximum and Minimum Tempe rature Cycle Descrip tion Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Deter gent Co m- partment SPIN Drain and long spin Maximum spin speed 1400 rpm Max. load 6 kg Separate spin for hand wash ed garments and after pro- grammes with the RINSE HOLD and NO SPIN option selected.
2. Remove the conditio ner insert from the appropriate compartment. 3. Clean all parts with water. 4. Put the conditioner insert in as far as it will go, so that it is firmly in place 5. Clean all parts of the machine, especially the nozzles in the top of the washing-in chamber, with a brush.
Drain pump The pump sh ould be in spec ted regularly and particularly if: • the machine does not empty and/or spin • the machine makes an unusual noise dur- ing draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: 1.
Warning! When the appliance is in use and depending on the programme select ed there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty.
solved easily without ca lling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operatio n it is possible that the red pilot light.
Problem Possible ca use/Solution Unsatisfactory washing re- sults: Too little detergent or unsuitable detergent has been used . • Increase the detergent quantity or use another one. Stubborn stains have not been treated prio r to washing. • Use commercial products to treat the stubborn stains.
Mod. ... ... ... Prod. No. ... ... ... Ser . No. ... ... ... M o d . . . . . .. .. . P ro d . N o . .. . .. . . . S e r. N o . . . . . . . .. . Technical data Dimensions Width Height Depth (door inclu.
Installation Unpacking All transit bolts and packing must be re- moved before using the appliance. You are advised to keep all transit devices so that they can be refitt ed if the machine ever has to be transported again. 1. After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bot tom.
B B C C 5. Remove the bracket D an d tighten up the six smaller bolts C . D C C 6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. Positioning Install the machine on a flat hard floor.
Caution! Never place cardboard, wood or similar materials und er the machine to compensate for any unevenness in the floor. After having levelled the appliance, tighten the lock nuts. Water inlet An inlet hose is supplied and can been found inside the machine drum.
• Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooke d when the ma- chine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall.
Should the appliance power supply cable need to be replaced, this must be carried out by a Service Centre. Environment concerns The symbol on the pr oduct or on its packaging indicates that this product may not be treated as household waste.
- thickness 16-22 mm The height (C-Fig. C) depends on the height of the adjacent furniture's base. C b) Hinges To mount the hinges it is necessary to drill two holes (dia. 35 mm, dept h 12.5-14 mm depending on the depth of door furniture) on the inner side of the door.
132957250-0 0-092009 www.electrolux.com.
デバイスElectrolux EWG 14550 Wの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Electrolux EWG 14550 Wをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはElectrolux EWG 14550 Wの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Electrolux EWG 14550 Wの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Electrolux EWG 14550 Wで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Electrolux EWG 14550 Wを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はElectrolux EWG 14550 Wの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Electrolux EWG 14550 Wに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちElectrolux EWG 14550 Wデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
