ElectroluxメーカーEWS 106540 Wの使用説明書/サービス説明書
ページ先へ移動 of 27
user manual Washing Machine EWS 106540 W EWS 126540 W.
Electrolux. Thinking of you. Share more of our thinki ng at www.electrolux.com Contents Safety information 2 Product description 4 Control panel 5 Table of Symbols 7 First use 7 Personalisation 7 Dail.
Installation • This appliance is h eavy. Care should be taken when moving it. • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. • All packing and transit bolts must be re- moved before use.
Product description Your new appliance meets all modern requir ements for effective treatm ent of laundr y with low water, energy and detergent consum ption. Its new washing system allows total use of detergent and reduces wate r consumption so saving energy.
Programme Chart Various programme charts in different lan- guages are supplied with the appliance. One is on the front side of the detergent dispenser drawer and the others are attached into the user manual assy.
Display 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 2.9 2.12 2.11 2.10 The display shows the following information: 2.1: Temperature value 2.2: Temperature icons , Cold . During the washing cycle the display shows the temperature icon animated to indicate that the appliance ha s started the heating phase of the water in the tub.
In the event of operating problems, some alarm codes can be displayed, for example (see paragraph «What to do if...»). • Delay Time value 2.10: Soil de gree icons • Intensive • Normal • Daily • Light • Quick • Super Quick • Refresh • Super Refresh (see paragraph «Select Time Manager op- tion»).
By pressing the 4 and 5 buttons simultane- ously for about 6 seconds , the acoustic signal is deactivated (ex cept if there is a fault). By pressing these 2 buttons again, the acoustic signal is reactivated.
Select the required programme by turning the programme selector dial (1) Turn the programme selector dial to the re- quired programme. The washing machine will propose a temperature and automatically select the maximum spin value provided for the programme you have chosen.
Start the programme by pressing button 8 To start the selected programme, press the button 8 , the green pilot light of the button 8 stops blinking. The icon 2.8 appears on the display to indicate that the appliance starts operating and the door is locked.
If a programme or an option that ends with water left in the tub has been selected, the icon 2.8 remains displayed to indicate that the water must be emptied out before open- ing the door. Follow the below instru ctions to empty out the water: 1. Turn the programme selector dial to .
Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the en- vironment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of na ture.
Programme Maximum and Minimum Tempe rature Cycle Descrip tion Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment DELICATES 40° - Cold Main wash - Rinses Maximum spin speed: 700 rpm Max. load 3 kg - Reduced load 1,5 kg 1) Delicate fabr ics: acrylics, viscose, polyester.
Programme Maximum and Minimum Tempe rature Cycle Descrip tion Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment DRAIN Draining of wat er Max. load 6 kg For emptying out the w ater of the last rinse in pro- grammes with the option select ed, which ends with water left in th e tub.
Programme Maximum and Minimum Tempe rature Cycle Descrip tion Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment 14 MINUTES 30° Main wash - Rinses Maximum spin speed: 700 rpm Max. load 2 kg Short washing cycle ideal fo r laundry which only needs freshening up.
Cleaning the dispenser drawer The detergent dispense r drawer should be cleaned regularly. The washing powder an d additive dispenser drawer should be cleaned regularly. Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder.
Drain pump The pump sh ould be in spec ted regularly and particularly if: • the appliance does not empty and/or spin; • the appliance makes an unusual noise dur- ing draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “What to do if.
7. Remove foreign bodies and fluff from the pump seat and from the pump impeller. 8. Check caref ully whether the pump im- peller rotates (it rotates jerkily). If it doesn’t rotate , pl ease contact your Service Centre. 9. Replace the filter in to the pump by in- serting it correctly into the special guides.
Warning! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Nev er remove the pump cove r during a wash cycle, always wait until the appliance has finished the cycle, and is empty.
6. When yo u intend to start the machine up again, make sure that the room temper- ature is above 0°C. What to do if… Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without ca lling out an engineer.
Problem Possible ca use/Solution There is water on the fl oor: Too much detergent or unsuitable det ergent (creates too much foam) has been used. • Reduce the detergent quan tity or us e another one. Check whether there are any leaks fr om one of the inlet hose fittings.
Mod. ... ... ... Prod. No. ... ... ... Ser . No. ... ... ... M o d . . . . . .. .. . P ro d . N o . .. . .. . . . S e r. N o . . . . . . . .. . Technical data Dimensions Width Height Depth Depth (Over.
Installation Unpacking All transit bolts and packing must be re- moved before using the appliance. You are advised to keep all transit devices so that they can be refitt ed if the machine ever has to be transported again. 1. After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bot tom.
Positioning Install the machine on a flat hard floor. Ma ke sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Le vel the washing ma- chine by raising or lowe ring the feet.
The inlet hose must not be lengthened. If it is too short and you do not wis h to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
Electrical connection Information on the el ectrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domest ic electrical installa- tion can take the maximum load required, al- so taking into account any other appliances in use.
electrolux 27.
デバイスElectrolux EWS 106540 Wの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Electrolux EWS 106540 Wをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはElectrolux EWS 106540 Wの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Electrolux EWS 106540 Wの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Electrolux EWS 106540 Wで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Electrolux EWS 106540 Wを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はElectrolux EWS 106540 Wの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Electrolux EWS 106540 Wに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちElectrolux EWS 106540 Wデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
