EminentメーカーEM6225の使用説明書/サービス説明書
ページ先へ移動 of 27
EM6225 e-CamVie w Pan/Tilt HD IP camera.
2 | ENGLISH EM6225 – e-CamV ie w Pan/Tilt HD IP camera Table of contents 1.0 Introduction ....... ...... ...... ...... ....... ...... ...... ...... ....... ...... ...... ...... ...... ....... ...... ...... ...... . 3 1.1 Packing conten ts ...... ...
3 | ENGLISH 6.2 The layou t of e-CamView ...... ....... ...... ...... ...... ...... ....... ...... ...... ...... ...... ....... ..... 23 6.3 FTP setting ........ ...... ...... ...... ...... ....... ...... ...... ...... ...... ....... ...... ...... ...
4 | ENGLISH 1.3 Major hardwa re compone nts. The major co mponents on the fron t panel of the EM6225 are: 1. Microphone – for receiving the audio/voice. 2. Lens – the len s is inside the ca mera body and the focus of the lens is fix ed, you do not need to spend time to adju st the focus.
5 | ENGLISH The major co mponents on the bo ttom of the EM6225 are: 1. Reset button – thi s is the button to reset the EM6 225 to default fa ctory settings. You need to use a small stick like pencil or tooth stick to pres s the reset button for more than 15 se conds to enable the reset function .
6 | ENGLISH 2.2 Installing the e-CamV iew App on an Apple/Andro id device Before you can vie w the video of the camera, you need to dow nload and install the app “e-CamView ” from the “Play Store” or “App Store”. 1. Down load and install the app “e-C amView ” from the “Play S tore” or “App S tore”.
7 | ENGLISH 2.3 Installing the software and camera on a PC or notebook (W indows). Before you can vie w the video of the camera, you need to install the softw are ”e- CamView” fro m the CD-ROM . 1. Insert the CD in the CD-ROM . 2. If auto-run is enab led the Wizard should star t.
8 | ENGLISH 2.4.2 Connectin g to Wi-Fi us ing the A pp. 1. Ensure the ca mera is conne cted to the netw ork with a Ether net cable. 2. Start the App “ e-C amView ”. 3. Select the “ Camera settings ” me nu by pre ssing the arrow next to the camera you would like to configure.
9 | ENGLISH 2.5 Mounting the camera on the wall 1. Once the ca mera is connected correctly w ith your computer, you can mount the camera on a w all or ceiling. 2. Use the mounting stand to mark the holes at the location w here you w ant to mount the camera.
10 | ENGLISH 4.0 e-CamVie w for iPhone/iPad/A ndroid 4.1 The Layout of e-CamVie w Edit Camera Add Camera View Camera Camera settings View snapshots View Recordings App information Hor.
11 | ENGLISH 4.2 WIFI sett ing You can select i f the camera w ill use a WiFi conne ction and w hat AP or Rou ter it will connect to..
12 | ENGLISH 4.3 User setting Here you can change the user settings of the Ca m era. 4.4 Time setting Set the time and select the ti me zone or set the N TP server settings to sync w ith that server.
13 | ENGLISH 4.5 Alarm setting Here you can enab le the Alar m, set the alar m triggers and ev ents. 4.6 FTP setting Here you can set your FTP server settings to enable recording to FTP serv er Example of a FTP server add ress: ftp.server.co m Note: If you wish to store in a spe cified folder plea se use the WebUI (see section 6.
14 | ENGLISH 4.7 Mail setting Here you can set your mail se ttings to enable the e-mail alar m notifications to the email addresse s you have set. 4.8 SD-card se tting Configure you r recording setting s for your SD-Card. You can a lso check the total capacity and availab le capacity o f your SD-C ard or format your SD-Card.
15 | ENGLISH 5.0 e-CamVie w for PC soft ware 5.1 The layou t of e-CamV iew Hor. & vert. Patrol Mirror/Flip image Open Camera list Go to camera preset Set camera preset Pan/Tilt control On Screen Display Open Rec. settings Enable/disable speaker Enable/disable mic.
16 | ENGLISH 5.2 Recording se ttings By default the ca mera saves the snapshot and re cordings to the follow ing path D:Picture, D:Record . Note: Please m ake sure the drive letter D: can be used for re cording (HDD dr ive) if this is not the ca se please change the drive letter to the correspondin g drive letter of the HDD drive.
17 | ENGLISH 5.4 Time setting Set the time and select the ti me zone or set the N TP server settings to sync w ith that server. 5.5 Network This feature allow s you to change the Networ k configuration manu ally after you uncheck the “Obtain IP fro m DHCP server” .
18 | ENGLISH 5.6 SD record s cheme Configure you r recording setting s for your SD-Card. You can a lso check the total capacity and availab le capacity o f your SD-C ard or format your SD-Card. The following re cording settings are availab le: Cyclic recording: Overw rite older recordings if the SD-card capac ity is full.
19 | ENGLISH 5.8 Email sett ing Here you can set your mail se ttings to enable the e-mail alar m notification and to send these notifications to the email addresses you have set. 5.9 FTP setting Here you can set your FTP server settings to enable recording to FTP serv er Example of a FTP server add ress: ftp.
20 | ENGLISH 5.10 PTZ Here you can set the Pan/Tilt: boo t preset, Speed and the amou nt of cruise cycles 5.11 Alarm set ting Here you can enab le the Alar m, set the alar m triggers and ev ents. Note: The fea ture IO linkage on al arm is not supported by this de vice.
21 | ENGLISH 5.12 WIFI sett ing You can select i f the camera w ill use a WiFi conne ction and w hat AP or Rou ter it will connect to. Al so you can set the e ncryption setting s of the WiFi connection you wish to connect to. 6.0 The webpage of the ca mera The Eminent ca mera is also an IP camera w ith its own w ebpage.
22 | ENGLISH 3. Enter the IP addre ss in the addre ss bar of your w eb brow ser followed by : and port number e.g. 192 .168.100.101:81 4. Login with user: admin Passw ord: (Leave blan k).
23 | ENGLISH 6.2 The layou t of e-CamV iew The menu options are the same a s the settings menu of the PC software with the exception of FTP service setting s and Maintenan ce. 6.3 FTP setting Here you can enter the settings of your FTP server. Example of a FTP server add ress: ftp.
24 | ENGLISH 6.4 Maintenance This menu option provides the po ssibility to reb oot the device, re store factory defaults, create a backup of the configura tion, restore the backup of your configura tion or update the fir mware.
25 | ENGLISH 8.0 Upgrade Dev ice Firm w are If there is a new firmware available for the EM6 225, you can upgr ade the fir mware via the Web UI Main tenance page. A status message about the percen tage don e in the upgrade pr ocedure is displayed. Please note: do not power off the EM62 25 during the upgrade pr ocedure.
26 | ENGLISH 11.0 Warning and po ints of attention Due to laws, dire ctives and regu lations set out by the Europea n parliament, some (wire less) devices could be subjec t to limitations concerning its u se in certain European member states. In certai n European member states the use of su ch devices could be prohibi ted.
27 | ENGLISH 12.0 Warranty conditions The five-year Eminent warr anty applies to all Eminent produc ts, unless mentione d otherw ise before or during the moment of purcha se. After buying a second- hand Eminent produc t the remaining per iod of warr anty is measured from the moment of purchase by the pr oduct’s initial owner.
デバイスEminent EM6225の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Eminent EM6225をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEminent EM6225の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Eminent EM6225の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Eminent EM6225で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Eminent EM6225を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEminent EM6225の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Eminent EM6225に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEminent EM6225デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。