Empire Comfort SystemsメーカーDV-210-7SGの使用説明書/サービス説明書
ページ先へ移動 of 20
12433-7-0107 Page 1 DIRECT VENT W ALL FURNACE MODELS DV -210-7SG DV -215-7SG EFFECTIVE DA TE JANUAR Y 2007 This appliance may be installed in an after - market, permanently located, manufactured home (USA only), or mobile home, wher e not prohibited by state or local codes.
12433-7-0107 Page 2 SECTION P AGE Important Safety Information ......................................................................................................................3 Safety Information for Users of LP Gas .............................
12433-7-0107 Page 3 • Due to high temperatures the appliance should be located out of traffic and away from furnitur e and draperies. • Childr en and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.
12433-7-0107 Page 4 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. Y ou must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can af fect your sensitivity or ability to detect that odor .
12433-7-0107 Page 5 REQUIREMENTS FOR MASSACHUSETTS For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residentia.
12433-7-0107 Page 6 Introduction Al w ay s co n su lt y ou r l oc al B u il di ng D ep ar t me nt r eg ar d in g regulations, codes or ordinances which apply to the installation of a direct vent wall furnace. Instructions to Installer 1. Installer must leave instruction manual with owner after installation.
12433-7-0107 Page 7 Locating Gas Supply The gas line can enter the unit either through the floor or outside wall. The gas line opening should be made at this time. Location of the opening will be determined by the position of floor joists and the valve and union used for servicing.
12433-7-0107 Page 8 The vent terminal of a direct vent appliance, with an input of 10,000 Btu per hour (3 kW) or less shall be located at least 6" (150mm) from any air opening into a building, and such an appliance with an input over 10,000 Btu per hour (3 kW) but not over 50,000 Btu per hour (14.
12433-7-0107 Page 9 3" (76mm) diameter flue outlet tube. Attach vent cap to outside wall plate with (3) #10 x 1/2" (13mm) screws provided. 5 . Reassembly and resealing vent-air intake system is completed. Ins tal lin g a V ent Near a Wind ow Ledge , Oth er T ype of Proj ection or on Siding (vinyl, aluminum, etc.
12433-7-0107 Page 10 These heating thermostats are specially designed for use on self- generating systems. They should never be used on line or low voltage A.
12433-7-0107 Page 1 1 1. STOP! Read the safety information above. 2. Set the thermostat to lowest setting. 3. T urn off all electric power to the appliance (if appli - cable). 4. Remove control access panel (front panel). 5. Push in gas control knob slightly and turn clockwise to "OFF".
12433-7-0107 Page 12 On the main burner , the burning gas forms a primary flame and a secondary flame. The primary flame is blue and about 3/16" (5mm) high. The secondary flame is very pale blue, 3 inches (76mm) to 5 inches (127mm) high. Dust in the combustion air will produce an orange flame.
12433-7-0107 Page 13 1. Lit match goes out as it enters lighter port. a. Certain wind conditions will blow out match. Ignite match, and as it flares, thrust match through opening. b. Open nearby door or window and relight pilot. 2. Pilot flames but goes out when knob is released.
12433-7-0107 Page 14 Parts can be ordered only through your service person or dealer . For best results, the service person or dealer should order parts through the distributor . Parts can be shipped directly to the service person/dealer . All parts listed in the Parts List have a Part Number .
12433-7-0107 Page 15 P AR TS VIEW.
12433-7-0107 Page 16 DVB-1 For Direct V ent W all Furnaces DV -210-(7, 9)SG and DV -215-(7, 9)SG BLOWER MOUNTING T A B Cleaning the Blower Wheel In some areas, such as near bedrooms and on floors with a hard surface, the blower wheel will be filled with lint very quickly .
12433-7-0107 Page 17 SER VICE NOTES.
12433-7-0107 Page 18 SER VICE NOTES.
12433-7-0107 Page 19 SER VICE NOTES.
12433-7-0107 Page 20 Empire Comfort Systems, Inc. 918 Freeburg A ve. Belleville, IL 62220 PH: 618-233-7420 or 800-851-3153 F AX: 618-233-7097 or 800-443-8648 info@empirecomfort.
デバイスEmpire Comfort Systems DV-210-7SGの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Empire Comfort Systems DV-210-7SGをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEmpire Comfort Systems DV-210-7SGの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Empire Comfort Systems DV-210-7SGの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Empire Comfort Systems DV-210-7SGで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Empire Comfort Systems DV-210-7SGを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEmpire Comfort Systems DV-210-7SGの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Empire Comfort Systems DV-210-7SGに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEmpire Comfort Systems DV-210-7SGデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
