EnviroメーカーMaxxの使用説明書/サービス説明書
ページ先へ移動 of 16
PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET-BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH. Contact your building or fire officials about restrictions and installation inspection requirements in your area.
T able of Contents 2 Introduction........................................................................................3 Rating Label Location................................................................3 P ellet Quality .........................
3 Introduction * This manual is designed for the home owner in conjunction with the technical manual. * R ATING L ABEL L OCATION : The rating label is located on the inside of the hopper . P ELLET Q UALITY : Pellet quality is important, please read the following: Your Enviro pellet stove has been designed to burn ” (6mm) dia wood pellets only.
4 Safety W arnings & R ecommend a tions Please read this entire Owner’s Manual before installing or operating your Enviro Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death.
5 Safety W arnings & R ecommend a tions ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord should be connected to a standard 110-120 volts (3.6 Amps), 60 hertz electrical outlet and also must be accessible.
21 13 / 16 " (554mm) 15 15 / 16 " (404mm) 21 9 / 16 " (548mm) 41 1 / 4 " (1047mm) 41 13 / 16 " (1063mm) 23 13 / 16 " (605mm) 25 5 / 8 " (650mm) 26 3 / 4 " (680mm) 25 1 / 16 " (637mm) Oper a ting Instructions D IMENSIONS & S PECIFICATIONS : Figure 1: Dimensions of Maxx.
7 Oper a ting Instructions C ONTROL B OARD F UNCTIONS : 1. AUGER TRIM: Used to change feed rates on LOW ONL Y for poorer quality fuels. Push the Auger T rim button until the number 1 and 5 lights appear on the Heat Lev el Indicator . This will increase the feed r ate to 4 seconds ON time Auger pulse.
Oper a ting Instructions O PERATING Y OUR P ELLET S TOVE : DO NOT OPERATE THE UNIT WITH THE DOOR OR ASH PAN OPEN. Keep hopper lid closed except during re-fuelling. CAUTION: When oper ating during adverse weather , such as high winds or freezing r ain, if the unit exhibits dr amatic changes in combustion stop using the unit immediately .
9 too much air – Close slider (push in) slightly . • If the flame is in the middle of these two characteristics with a bright yellow/orange, active flame with no black tips then the air is set for proper operation, r efer to Figure 7 . The combustion exhaust blower is a variable speed blower controlled by the heat output button.
Check the Burn Pot Liner DAIL Y Weekly Bi-annually or 2 T ons of Fuel Burn Pot and Liner - Empty Exhaust V ent Heat Exchanger T ubes Fresh Air Intake T ube Ash Box Blower Mechanisms Door Glass Heat Ex.
11 R outine Cleaning and Maintenance DOOR GLASS CLEANING (W eekly) Cleaning of the glass must only be done when stove is cold. Open the door by lifting the handle. The glass can be cleaned by wiping down the outside and inside of the glass with a dry soft cloth.
R outine Cleaning and Maintenance EXHAUST VENT (Biannually) This v ent should be cleaned every year or after two tons of pellets. W e recommend contacting your dealer for professional cleaning. T o clean the v ent pipe, tap lightly on the pipe to dislodge any loose ash.
13 W arr anty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to the highest level of quality and customer service is the most important thing we do.
W arr anty Exclusions and Limitations: 1. This W arr anty does not cov er tarnish, discoloration or wear on the plating or paint. 2. This W arr anty excludes wear and tear or br eakage caused by cleaning, moving or service on log set. 3. A qualified installer must install this stove or fireplace.
15 W arr anty 17 . Damage to plated surfaces caused b y fingerprints, scratches, melted items, or other external scores and residues left on the plated surfaces fr om the use of abrasiv e cleaners or polishes is not covered in this warr anty . 18. The Limited W arr anty does not cover tarnish, discolor ation or wear on the plated surfaces.
16 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE.
デバイスEnviro Enviro Maxxの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Enviro Enviro Maxxをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEnviro Enviro Maxxの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Enviro Enviro Maxxの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Enviro Enviro Maxxで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Enviro Enviro Maxxを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEnviro Enviro Maxxの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Enviro Enviro Maxxに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEnviro Enviro Maxxデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。