EpsonメーカーML 3320/3321の使用説明書/サービス説明書
ページ先へ移動 of 23
English QUIET PARK TEAR FF/LOAD LF SEL SEL POWER ALARM MENU GROUP EXIT ITEM SET PRINT MENU SHIFT TOF Micro Feed Up Micro Feed Down PRINT QUALITY CHARACTER PITCH HSD NLQ UTL SSD 10 12 15 17 20 PROP ML 3320/3321 Read Me First 3320rmf1.
Ev ery ef fort has been made to ensure that the informa tion in this document is complete, accurate, and up-to-date. Oki assumes no responsibility for the results of error s be yond its control.
English i Read Me First Saf ety Y our Oki printer has been carefully designed to gi ve you years of safe, reliable performance. As with all electrical equipment, there are a few basic precautions you should take to a void hurting yourself or damaging the printer: • Read the setup and operating instructions in this manual carefully .
ii ML3320/21 • Do not poke anything into the ventilation slots on the sides of the printer; you could get a shock or cause a fire. • Aside from the routine maintenance described in this handbook, do not try to service the printer yourself; opening the cov er may expose you to shocks or other hazards.
English iii Read Me First Contents Safety .................................................................................. i Features .............................................................................. 1 Optional Accessories .............
iv ML3320/21 3320rmf2.pm6 13/03/96, 16:07 4.
English 1 Read Me First Features • Four printing speeds, from super-speed draft printing to near letter quality printing • Rear tractor feed for continuous forms • T op feed for single sheets .
2 ML3320/21 QUIET PARK TEAR FF/LOAD LF SEL SEL POWER ALARM MENU GROUP EXIT ITEM SET PRINT MENU SHIFT TOF Micro Feed Up Micro Feed Down PRINT QUALITY CHARACTER PITCH HSD NLQ UTL SSD 10 12 15 17 20 PROP.
English 3 Read Me First Installing the Ribbon Car tridge 1. Make sure the printer is turned OFF . 2. Centre the printhead ( ➊ ). Remo ving the Shipping Restraints 1. Open the access cov er and remove the printhead shipping retainer and the pull-up roller shipping retainer .
4 ML3320/21 4. Install the new ribbon cartridge. Connecting to the Computer Note: Y ou m ust suppl y a shielded cable for connecting your printer to your computer . 1. When using the parallel interface cab le, it needs to be fitted with an in-line f ilter .
English 5 Read Me First Connecting to the P o wer 1. Make sure both the printer and the computer are OFF . 2. Plug the power cable into an earthed (3-pin) outlet. Note: The printer must be installed near to a pow er outlet switch whic h will remain easily accessible.
6 ML3320/21 1. Mov e the paper le ver to the position mar ked “REAR. ” 3. Pull up on the lock le ve rs and open the tractor co ver s. P TEA R FF/LOAD LF GR Micro Feed U Micro Feed Down PRIN QUIET P ARK TEAR D U SET PRINT TOF d PRINT QUALITY CHARACTER PITCH HSD NLQ UTL SSD 10 12 15 17 20 PROP 2.
English 7 Read Me First 5. Place the first two holes in the pa per o ver the tractor pins on either side and close the tractor cov e rs. 7. Adjust the right tractor to centre the paper holes on the pins, and push back the lock lev e r . ➊ ➊ ➋ 6.
8 ML3320/21 QUIET PARK TEAR FF/LOAD LF SEL SEL POWER ALARM MENU GROUP EXIT ITEM SET PRINT MENU SHIFT TOF Micro Feed Up Micro Feed Down PRINT QUALITY CHARACTER PITCH HSD NLQ UTL SSD 10 12 15 17 20 PROP.
English 9 Read Me First M QUI ET PARK PRINT QUALITY HSD UTL QUIET PARK TEAR FF/LOAD LF SEL SEL POWER ALARM MENU GROUP EXIT ITEM SET PRINT MENU SHIFT TOF Micro Feed Up Micro Feed Down PRINT QUALITY CHARACTER PITCH HSD NLQ UTL SSD 10 12 15 17 20 PROP ➊ ➊ 5.
10 ML3320/21 SEL SEL EX T MENU SEL SEL EX T MENU LF GROUP Micro Feed Down 3. Press SEL to re-select the printer . T emporarily Changing the T op of Form Setting T o set the T op of Form position lo wer for one page only: 1. Press SEL to deselect the printer .
English 11 Read Me First ➊ Switching P aper P aths T o switch from continuous-f orms to single-sheet f eed: 1. T ear of f any printed pages. 2. Press P ARK . 3. Move the pa per separator to the single-sheet feed position. 4. Place the wire feed guide in the paper separator .
12 ML3320/21 LF GROUP Micro Feed Down QUIET TOF Running the Self T ests Font Sample T est T o run the test: T urn the printer of f, then press and hold LF while turning the printer on. T o stop the test: If you wish to stop the test before it is complete, press SEL .
English 13 Read Me First QUIET PARK TEAR FF/LOAD LF SEL SEL POWER ALARM MENU GROUP EXIT ITEM SET PRINT MENU SHIFT TOF Micro Feed Up Micro Feed Down LF GROUP Micro Feed Down 4. P r ess LF . The following line will print: Printer Control Emulation Mode IBM PPR 5.
14 ML3320/21 3320rmf3.pm6 13/03/96, 16:09 14.
English 15 Read Me First Inde x F F actory setting, top of form ............ 10 F ont sample test .............................. 12 F orms, head gap settings ................ 11 G Guides, paper .................................... 2 Guide, wire ......
16 ML3320/21 R Rear feed paper , loading ................ 5-7 Ribbon installation ........................ 3-4 Rolling ASCII test .......................... 12 S Self tests ......................................... 12 Setting top of form .............
English 17 Read Me First Oki Systems Compan y Oki Systems (UK) Limited 550 Dundee Road Slough T r ading Estate Slough Berks. SL1 4LE T el: 01753-819819 Fax: 01753-819899 3320rmf3.
デバイスEpson ML 3320/3321の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Epson ML 3320/3321をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEpson ML 3320/3321の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Epson ML 3320/3321の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Epson ML 3320/3321で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Epson ML 3320/3321を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEpson ML 3320/3321の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Epson ML 3320/3321に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEpson ML 3320/3321デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。