Essick AirメーカーECR 7200の使用説明書/サービス説明書
ページ先へ移動 of 16
ESSICK AIR PRODUCTS LITTLE ROCK, ARKANSAS 72209 50209-3 O WNERS MANU AL MODEL NO . ECR 3301 ECR 4000 ECR 4500 ECR 5200 ECR 6600 ECR 7200 CA UTION: Read All Instructions Carefully Bef ore Star ting The Installation.
2 INST ALLA TION T ools and Supplies Y ou Need ......................................... 3 Saf ety Rules ................................................................... 3 Data .......................................................................
3 T OOLS AND SUPPLIES Y OU WILL NEED • Pliers • Screwdriv ers • Adjustable Wrenches • T ubing Cutter • 5 / 32 He x Ke y Wrench • Electric Dr ill • Drill Bits • Hammer • Duct Caulking • #10 Sheet Metal Screws • Wiring Supplies, as Required by Local Electrical Code •L e v e l • Duct.
4 LOCA TING Y OUR COOLER This new design Essic k cooler may be installed as a bot- tom or side air outlet cooler . The cooler must be securely f astened to a frame or pad mount. A roof kit is av ailable from Essick. A duct must be attached to the cooler outlet.
5 1. Remove both louv ers and set them where they will not fall. See pg. 11. 2. Remove f our louver clips on side opposite motor . 3. Remov e a reser voir b y pushing the water crossov er tube from the grommet and lifting out the reservoir . 4. Remov e the second reser voir as abov e.
6 INST ALLA TION Lift at cabinet cor ners. The cooler may be lifted by putting a bar or strap through the panel hole and lifting by means of the bar or strap . LIFTING COOLER CA UTION: DO NO T LIFT ON THE LOUVERS. REMO VE THE LOUVERS BEFORE LIFTING. DO NO T LIFT ON THE CENTER OF THE CABINET FLANGES.
7 INST ALLA TION ELECTRICAL CONNECTIONS The wiring must comply with local codes. If you are not f amiliar with the codes or wiring practices, get prof essional help. Use only an Essick ECR-5 or ECR-7 w all mounted switch. This new cooler does not require pre wetting the pads bef ore star ting cooling and does not hav e a pump .
8 INST ALLA TION FINAL ASSEMBL Y AND ADJUSTMENT PUT FLO A T V AL VE IN COOLER Put the float valv e through the spout hole and cabinet hole. Tighten the ring nut. Be sure the float mov es straight up and do wn. TURN THE FLO A T UNTIL A NARRO W SIDE IS UP .
9 IMPOR T ANT NO TE: When checking amperage with the ampmeter , all louv ers must be in place in the cooler , otherwise incorrect setting of the drive pulle y will occur .
10 HO W Y OUR COOLER WORKS Y our cooler evaporates water to cool air . Evaporative air cooling is the same natural cooling that happens when a breeze springs up after a summer shower . Y ou f eel cool because the rain water e vaporates and carries aw ay heat.
11 CARE OF Y OUR COOLER NEVER WEAR SHOES WITH SLICK SOLES WHEN Y OU W ORK ON A ROOF . Y OU MA Y SLIP WHEN Y OU LEAST EXPECT IT . NEVER DRAIN W A TER ONTO A R OOF . W A TER RESIDUE MA Y CA USE Y OU T O SLIP OR MA Y ST AIN Y OUR ROOF . USE A DRAIN HOSE T O R UN W A TER TO A RAIN GUTTER OR T O THE GROUND .
12 Operation of Roto Belt Coolers in “Hardwater” Areas. 1. Clean the cooler frequently . 2. Remov e mineral buildup from water troughs and Roto Belt to prev ent clogging. 3. A water analysis will determine: mineral content, what water treatments can be used, what cleaning agents should be used.
13 REPLA CEMENT P ADS MODEL NUMBER P AD NUMBER ECR 3301 EP-30 ECR 4000 EP-40 ECR 4500 EP-40 ECR 5200 EP-50 ECR 6600 EP-60 PUTTING ON NEW P AD (Fig. 20) THE P ADS NEED NO PREWETTING. 1. Put the lower roller in pad. 2. Fit the low er roller into the bottom slots in the frame.
14 ESSICK CONVERTIBLE DO WN/FRONT OUTLET EV APORA TIVE AIR COOLER MODEL NOS. ECR 3301, ECR 4000, ECR 4500, ECR 5200, ECR 6600, ECR 7200 REP AIR P ARTS.
15 ESSICK CONVERTIBLE DO WN/FRONT OUTLET EV APORA TIVE AIR COOLER MODEL NOS. ECR 3301, ECR 4000, ECR 4500, ECR 5200, ECR 6600, ECR 7200 NO TICE: Order by P AR T NUMBER, not by K ey Number . Refer to the bac k cover of this man ual for par ts ordering information.
ESSICK AIR PRODUCTS 5800 MURR Y • LITTLE ROCK, ARKANSAS 72209 501-562-1094 owners manual MODEL NO . ECR 3301 ECR 4000 ECR 4500 ECR 5200 ECR 6600 ECR 7200 HO W T O ORDER REP AIR P ARTS ESSICK CONVER TIBLE DO WN/FR ONT OUTLET EV APORA TIVE AIR COOLER The model number of y our cooler will be found on a label fastened to the housing.
デバイスEssick Air ECR 7200の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Essick Air ECR 7200をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEssick Air ECR 7200の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Essick Air ECR 7200の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Essick Air ECR 7200で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Essick Air ECR 7200を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEssick Air ECR 7200の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Essick Air ECR 7200に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEssick Air ECR 7200デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。