Fordメーカー2004 Mustangの使用説明書/サービス説明書
ページ先へ移動 of 16
Introduction 2 Instrumentation 4 Servicing your vehicle 5 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company .
ABOUT THIS SUPPLEMENT This booklet supplements your Owner Guide and is part of the owner’ s portfolio. It describes the operation of your natural gas vehicle (NGV) and how it differs from a standard gasoline powered vehicle.
COMPRESSED NATURAL GAS (CNG) FUEL SYSTEM Y our vehicle is equipped with a dedicated compressed natural gas (CNG) fuel system that is under high pressure. Depending upon the application, the CNG fuel system is rated at a pressure of 20,700 kPa (3,000 psi) at 21 ° C (70 ° F) or 24,800 kPa (3,600 psi) at 21 ° C (70 ° F).
FUEL GAUGE The fuel gauge in your NGV behaves similarly to a typical gasoline fuel gauge. However , the gauge operation is based on the pressure and temperature of the natural gas, not on the level of liquid gasoline.
CNG FUEL SYSTEM COMPONENT IDENTIFICATION The following illustrations depict the major unique components of the CNG fuel system. All of these unique components are constructed of special materials that withstand the effects of CNG.
E-450 Cutaway 1. Fuel rail sensors - An injection pressure sensor and an engine fuel temperature sensor provide engine fuel information to the powertrain control module. 2. Isolation solenoid valve - Blocks fuel flow from supply line to injection manifold when the engine is off.
9. Aft axle fuel tanks - T wo steel fuel tanks located behind the rear axle. 10. Midship fuel tank - A steel fuel tank located underbody . 11. High pressure fuel lines - Delivers high pressure fuel to the fuel tanks and fuel pressure regulator .
vehicle ’ s inertia switch. If the engine cranks but does not start after a collision, the fuel solenoid valve inertia switch may have been activated. The inertia switch is a device intended to close the fuel solenoid valve when your vehicle has been involved in a substantial jolt.
2. Isolation solenoid valve - Blocks flow from the injection manifold when the engine is off. 3. Engine - Is a modified 4.6L engine with Sequential Electronic Fuel Injection (SEFI) and increased compression ratio. 4. Engine coolant lines - Provide required heat to high pressure regulator .
ADAPTERS DO NOT use fuel receptacle adapters when refueling your vehicle. The profiles of both the natural gas vehicle receptacle and the fuel station nozzles are specified by ANSI/AGA NGV1-1994, CGA NGV1-M94. These profiles are specified for compressed natural gas vehicles and fuel stations for safety purposes.
indication that refueling is nearly complete. Also, the station compression equipment may turn on at any time during the refueling process. FUEL QUALITY Do not use liquefied natural gas (LNG) or a CNG that is derived from a process such as flashing (heating LNG).
SERVICING YOUR NATURAL GAS VEHICLE Service to the CNG fuel system should be conducted at a qualified dealership by a trained NGV technician only . Failure to do so may cause damage to components or cause bodily harm. FUELING Do not fuel your vehicle with the ignition on the ON position.
Use caution when fueling your vehicle. Make sure the engine is turned off and all flammable material is extinguished. Observe all Dispensing Equipment Safety Standards and Operating Procedures. The procedure is the same for both fast-fill and slow-fill fueling.
E-Series Cutaway 158 ” Wheelbase (3600 psi) Fueling method Standard tanks W ith Extended Range - One In-body T ank W ith Extended Range - T wo In-body T anks Slow-fill 63.2L (16.7 gallons) 96.1L (25.4 gallons) 128.7 (34.0 gallons) Fast-fill 53.8L (14.
Crown V ictoria (3600 psi) Fueling method Standard tanks W ith extended range system 1 Slow-fill 45.0L (11.9 gallons) 59.1L (15.6 gallons) Fast-fill 38.
The purpose of the inspection is to check for exterior damage to the tank which would shorten its usable life span. This inspection should only be done by qualified NGV Ford service technicians. The expiration date for the tank replacement is stated on each tank label See instructions on fuel container for inspection and service life.
デバイスFord 2004 Mustangの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Ford 2004 Mustangをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはFord 2004 Mustangの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Ford 2004 Mustangの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Ford 2004 Mustangで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Ford 2004 Mustangを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はFord 2004 Mustangの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Ford 2004 Mustangに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちFord 2004 Mustangデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
