AlpineメーカーCDE-7853Eの使用説明書/サービス説明書
ページ先へ移動 of 19
.
.
1 -EN Contents Operating Instr uctions W ARNING W ARNING .................................................. 2 CA UTION ................................................... 2 PRECA UTIONS ......................................... 2 Basic Operation Detaching the Front Panel .
2 -EN WARNING The exc lamation point within an equilateral triangle and "W ARNING" are intended to aler t the user to the presence of important operating instructions. Failure to heed the instructions will result in severe injury or death. DO NOT DISASSEMBLE OR AL TER.
3 -EN Never Attempt the Following Do not grip or pull out the disc while it is being pulled back into the player by the automatic reloading mechanism. Do not attempt to insert a disc into the unit when the unit power is off. Inserting Discs Y our player accepts only one disc at a time for playback.
4 -EN Detaching the Fr ont P anel 1 Press the PWR (P ower) b utton for more than 3 seconds to turn off the power . 2 Press the (Release) button at lo wer left cor ner until the front panel pops out. 3 Grasp the left side of the front panel and pull it out.
5 -EN A udio Mute Function Activating this function will instantly lo wer the volume le vel b y 20 dB. 1 Press the MUTE button to activate the MUTE mode. The audio lev el will decrease by about 20 dB. Pressing the MUTE button again will bring the audio back to its pre vious lev el.
6 -EN Basic Operation CT H M CLK Displaying Time 1 Press the CLK (clock) b utton repeatedly until the clock time is displa yed. Each press changes the modes as f ollows: Radio mode. ↔ Clock priority mode Radio frequency CD Player/Changer(CDM-7854E onl y) modes → T rac k No.
7 -EN A utomatic Seek T uning 1 Press the SOURCE button until a r adio frequency appears in the displa y . 2 Press the BAND button repeatedly until the desired radio band is displa yed. Each press changes the band: → F1 → F2 → AM 3 Press the TUNE button to illuminate the DX and SEEK indicators in the displa y .
8 -EN Manual Storing of Station Presets 1 Select the radio band and tune in a desired radio station you wish to store in the preset memory . 2 Press and hold any one of the Preset b uttons (1 through 6) for at least 2 seconds until the station frequency on the display blinks.
9 -EN Storing into Direct Access Preset (D .A.P .) Band A combination of radio stations in any band (up to 6 stations) can be manuall y preset into the D .A.P . band. 1 Press and hold the D .A.P . button f or more than 2 seconds until the D .A.P . indicator appears.
10 -EN Inser ting/Ejecting Disc 1 Inser t a CD half wa y into the slot with the label side f acing up. The player automatically dr aws the disc into the disc compar tment. The Disc indicator appears to show that a disc is loaded. NOTE Thr ee-inch (8cm) CD's can be used.
11 -EN Contr olling CD Chang er (Optional) (CDM-7854E only) If an optional Alpine 6-disc CD Changer is connected to the 8-pin DIN connector (M-Bus) of the CDM-7854E, you can control the CD changer using the CDM-7854E.
12 -EN Inf or mation CD CD Player/Changer not functioning. • Out of operating temperature range +50˚C (+120˚F) for CD. - Allow the vehicle's interior (or trunk) temperature to cool. CD playback sound is wavering. • Moisture condensation in the CD Module.
13 -EN Specifications FM TUNER SECTION T uning Range 87.5 – 108 MHz Mono Usable Sensitivity 9.3 dBf (0.8 µV/75 ohms) 50 dB Quieting Sensitivity 13.5 dBf (1.3 µV/75 ohms) Alternate Channel Selectivity 80 dB Signal-to-Noise Ratio 65 dB Stereo Separation 35 dB AM TUNER SECTION T uning Range 531 – 1,602 kHz Sensitivity (IEC Standard) 22.
14 -EN Installation and Connections Before installing or connecting the unit, please read the follo wing and pages 2 and 3 of this manual thor oughly for pr oper use . W arning USE ONL Y VEHICLES WITH A 12 VOL T NEGA TIVE (–) GROUND. Check with your dealer if you are not sure.
15 -EN Installation 1 Remov e the Detachable F ront P anel (refer to page 4). Slide mounting slee ve from main unit (see “Removal” on this page). Slide the mounting slee ve into the dashboard. NOTE Please examine the installation. Make certain that no external pr essure is applied to either the top of the unit or the r emovable nosepiece.
16 -EN Grey SPEAKER RIGHT FRONT REMOTE TURN-ON Red IGNITION Y ellow BATTER Y Black GND Blue/White Grey/ Black SPEAKER RIGHT REAR Violet/ Black Green Violet SPEAKER LEFT REAR Green/ Black White/ Black .
17 -EN 1 Antenna Receptacle 2 P ower Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicable. 3 Remote T ur n-On Lead (Blue/White) (CDM- 7854E only) Connect this lead to the remote turn-on lead of your amplifier or signal processor .
デバイスAlpine CDE-7853Eの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Alpine CDE-7853Eをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAlpine CDE-7853Eの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Alpine CDE-7853Eの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Alpine CDE-7853Eで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Alpine CDE-7853Eを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAlpine CDE-7853Eの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Alpine CDE-7853Eに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAlpine CDE-7853Eデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。