Frigidaireメーカー316495064の使用説明書/サービス説明書
ページ先へ移動 of 24
or Visit our W ebsite at: READ CAREFULL Y . KEEP THESE INSTRUCTIONS . Installation Over the Range Instructions Microwave Oven Read these instr uctions completely and carefully . • IMPORT ANT – Save these instructions for local inspector’ s use. • IMPORT ANT – Obser ve all governing codes and ordinances.
2 Before Y ou Use Y our Micr owave CONTENTS General information Important Safety Instr uctions .................................. 3 Electrical Requirements .......................................... 3 Damage – Shipment/Installation .................
This product requires a three-prong grounded outlet. The installer must per form a ground continuity check on the power outlet box before beginning the installation to insure that the outlet box is properly grounded.
PA R T QUANTITY T op Cabinet 1 T emplate Rear Wall 1 T emplate Installation 1 Instructions Separately 2 Packed Filters P ART QUANTITY Wood Screws 2 ( 1 ⁄ 4 “ x 2“) T oggle Bolts (and 4 wing nuts.
TOOLS YOU WILL NEED # 1 Phillips screwdriver Pencil Ruler or tape measure and straight edge Carpenter square (optional) T in snips (for cutting damper , if required) Electric drill with 3 ⁄ 16 “ ,.
Find the studs, using one of the following methods: A. Stud finder – a magnetic device which locates nails. OR B. Use a hammer to tap lightly across the mounting sur face to find a solid sound. This will indicate a stud location. After locating the stud(s), find the center by probing the wall with a small nail to find the edges of the stud.
DETERMINING W ALL PLA TE LOCA TION UNDER YOUR CABINET C. Y our cabinets may have decorative trim that inter feres with the microwave installation. Remove the decorative trim to install the microwave properly and to make it level. THE MICROW A VE MUST BE LEVEL.
ALIGNING THE W ALL PLA TE Draw a vertical line on the wall at the center of the 30 ″ (76.2 cm) wide space. Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are touching the bottom of the cabinet or the level line drawn in Step C for cabinets with front overhang.
A INST ALLA TION TYPES This microwave oven is designed for adaptation to the following three types of ventilation: A. Outside T op Exhaust (V er tical Duct) B. Outside Back Exhaust (Horizontal Duct) C. Recirculating (Non-V ented Ductless) proceed to that section.
EQUIV ALENT NUMBER EQUIV ALENT DUCT PIECES LENGTH x USED = LENGTH Roof Cap 24 Ft. (7.3 m) x (1) = 24 Ft. (7.3 m) 12 Ft. (3.6 m) Straight Duct 12 Ft. (3.6 m) x (1) = 12 Ft. (3.6 m) (6”/15.2 cm Round) Rectangular -to-Round 5 Ft. (1.5 m) x (1) = 5 Ft. (1.
EQUIV ALENT NUMBER EQUIV ALENT DUCT PIECES LENGTH x USED = LENGTH Rectangular -to-Round 5 Ft. (1.5 m) x ( ) = Ft. or m T ransition Adaptor* Wall Cap 40 Ft. (12.2 m) x ( ) = Ft. or m 90° Elbow 10 Ft. (3 m) x ( ) = Ft. or m 45° Elbow 5 Ft. (1.5 m) x ( ) = Ft.
Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw , make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet.
13 USE TOP CABINET TEMPLA TE FOR PREP ARA TION OF TOP CABINET Y ou need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor . A2. • Read the instructions on the TOP CABINET TEMPLA TE.
3 MOUNT THE MICROW A VE OVEN FOR EASIER INST ALLA TION AND PERSONAL SAFETY , WE RECOMMEND THA T TWO PEOPLE INST ALL THIS MICROW A VE OVEN. IMPORT ANT : Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.
4 Attach the microwave oven to the top cabinet. 8 7 6 Cabinet Front Cabinet Bottom Shelf Tighten the outer two screws to the top of the microwave oven.
INST ALLA TION OVER VIEW B1. Prepare Rear W all B3. Attach Mounting Plate to W all B4. Prepare T op Cabinet B5. Adjust Blower B6. Mount the Microwave Oven IMPORT ANT NOTES: • Make sure the screws for the blower motor and blower plate are securely tightened when they are reinstalled.
A TT ACH THE MOUNTING PLA TE TO THE W ALL B3. USE TOP CABINET TEMPLA TE FOR PREP ARA TION OF TOP CABINET B4. • Read the instructions on the TOP CABINET TEMPLA TE. • T ape it underneath the top cabinet. • Drill the holes, following the instructions on the TOP CABINET TEMPLA TE.
Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven. AFTER: Fan Blade Openings Facing Back Place the blower unit back into the opening. Replace the blower plate in the same position as before with the screw .
Attach the microwave oven to the top cabinet. Installation Instructions 3 MOUNT THE MICROW A VE OVEN B6. FOR EASIER INST ALLA TION AND PERSONAL SAFETY , WE RECOMMEND THA T TWO PEOPLE INST ALL THIS MICROW A VE OVEN. IMPORT ANT : Do not grip or use handle during installation.
USE TOP CABINET TEMPLA TE FOR PREP ARA TION OF TOP CABINET C2. INST ALLA TION OVER VIEW C1. Attach Mounting Plate to W all C2. Prepare T op Cabinet C4. C5. Mount the Microwave Oven IMPORT ANT NOTES: • Make sure the screws for the blower motor and blower plate are securely tightened when they are reinstalled.
Attach the microwave oven to the top cabinet. Cabinet Front Cabinet Bottom Shelf Filler Block Microwave Oven T op Equivalent to Depth of Cabinet Recess Installation Instructions 3 MOUNT THE MICROW A VE OVEN FOR EASIER INST ALLA TION AND PERSONAL SAFETY , WE RECOMMEND THA T TWO PEOPLE INST ALL THIS MICROW A VE OVEN.
5 MOUNT THE MICROW A VE OVEN (cont.) Installation Instructions 8 7 6 Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.) Insert 2 self-aligning screws through outer top cabinet holes.
KEEP INST ALLA TION INSTRUCTIONS FOR THE LOCAL INSPECTOR’S USE. Plug power cord into a dedicated 15- to 20-amp electrical outlet. 7. 6. Replace house fuse or turn breaker back on. 4. Remove all packing material from the microwave oven. 2. Make sure the microwave oven has been installed according to instructions.
24 Printed in China.
デバイスFrigidaire 316495064の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Frigidaire 316495064をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはFrigidaire 316495064の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Frigidaire 316495064の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Frigidaire 316495064で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Frigidaire 316495064を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はFrigidaire 316495064の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Frigidaire 316495064に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちFrigidaire 316495064デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。