FrymasterメーカーCombinationsの使用説明書/サービス説明書
ページ先へ移動 of 30
Frymaster, a member of the Co mmercial Food Eq uipment Service Asso ciation, recomm ends using CFESA Certified Tec hnicians. Price: $6.00 *8195700* 24-Hour Service Hotline 1-800-551-8633 819-5700 Marc.
Please read all sections of this manual and retain for future reference. NOTICE IF, DURING THE WARRANTY PERIOD, THE CUST OMER USES A PART FOR THIS ENODIS EQUIPMENT OTHER TH AN AN UNMODIFIED NEW OR REC.
DANGER Improper installation, adjustment, maintenance or service, and unauthorized alterations or modifications can cause property damage, injury , or death. Read the installation, operating and service instructions thoroughly before installing or servicing this equipment.
TABLE OF CONTENTS Page # 1 INTRODUCTION ........................................................................................ 1-1 1.1 General ..........................................................................................................
1-1 FLATBOTTOM SERIES ELECTRIC FRYERS CHAPTER 1: INTRODUCTION 1.1 General Read the instructions in this manual thoroughly before attempting to operate this equipm ent. This manual covers the Flatbottom Series of electr ic fryers, including th e 1824E family, the 2424E family, and their associated built-in filtration system s.
1-2 DANGER DANGER boxes contain information about actions or conditions that may cause or result in injury to personnel , and which may cause damage to your system and/or cause your system to malfunction. Fryers in this series are equipped w ith automatic safety features: 1.
1-3 1.5 Shipping Damage Claim Procedure What to do if your equipment arrives damaged: Please note that this equipment was carefully inspected and pack ed by skilled personnel before leaving the factory. The freight company assu mes full responsibility for safe delivery upon acceptance of the equipment.
2-1 FLATBOTTOM SERIES ELECTRIC FRYERS CHAPTER 2: INSTALLATION INSTRUCTIONS 2.1 General Proper installation is essential for the safe, effici ent, trouble-free op eration of this appliance. Any unauthorized alteration of this equipment w ill void the Dean warranty.
2-2 2.3 Fryer Inst allation DANGER The electrical power supply for this applia nce must be the same as indicated on the rating and serial number plate located on the inside of the fryer door. DANGER This appliance must be connected to the voltage and phase as specified on the rating and serial number plate located on the inside of the fryer door.
2-3 When the fryer is leveled in its final position, install th e restraints provided with the unit to limit its movement so that it does not depend on or transmit stress to the electrical conduit or connection. Install the restraints in accordance with the provided instructi ons (see illustration below).
2-4 SINGL E PHASE (NO NEUTRAL ) FIELD CONNECTION L1 L2 L3 1 1HV 1C1 2HV 1C2 2 3 3HV 1C3 4 5 6 FROM TRANSFOR MER FROM TRANSFORMER SINGL E PHASE FIELD CONNECTION NEUTRAL TO L3 L1 L2 L3 1 1HV 1C1 2HV 1C2.
2-5 fryers without the built-in boil out option, the power switch is on the front panel. For those with the option, the switches are located inside the door.
2-6 6. Press the fryer POWER switch to the OFF position. If the unit is equipped with a boilout switch, press that switch to the OFF position. 7. Add two gallons of cold water. Drain the solu tion into a suitable con tainer (not the filte r pan) and clean any remaining stubborn spot s with a brush or scouring pad.
3-1 FLATBOTTOM SERIES ELECTRIC FRYERS CHAPTER 3: OPERATION AND ROUTINE MAINTENANCE 3.1 Start-up NOTE: If this is the first tim e the unit is being opera ted after installation, perform the boil-out procedure found in Section 2.3 of Chapter 2 before proceeding.
3-2 3.2 General Use of the Fryer 1. For consistent product quali ty and long-term savings, use a high-quality cooking oil or shortening. 2. When satisfied that the cooking oil/shortening is at the proper cooking temperature, carefully lower a basket of product into the frypot.
3-3 3.4 Draining and Manual Filtering of Fryers without Built-In Filtration NOTE: For fryers with built-in filt ration, refer to Chapter 4. DANGER Allow oil/shortening to cool to 100ºF (38ºC) or lower before draining into an appropriate container for disposal.
3-4 2. When shutting down for longer than overnight, filte r the cooking oil or shorten ing and then drain it into suitable storage containers o r discard it. Press the POWER switch to th e OFF position and allow the fryer to cool. Clean the fryer inside and out in accordance with the procedures in Section 3.
4-1 FLA TBOTT OM SERIES ELECTRIC FR YERS CHAPTER 4: UNDER FRYER FILTER (UFF) OPERATION 4.1 General Upon initial installation and before each use, remove all loose parts from the filter, wash the filter pan and loose parts in hot, soapy water, and dry thoroughly.
4-2 4. Place the leaf filter asse mbly into the bottom of the filter pan, ensuring that th e pan outlet is to the left and the standpipe is to the right as you face the fryer. Pan o utl et to left. Standpi pe to right . 5. Sprinkle 16 ounces (2 cups) of Magnasol XL filter powder evenly over the filter sc reen.
4-3 4.3 Filtering Procedure DANGER THE ON-SITE SUPERVISOR IS RESPONSIBLE FOR ENSURING THAT OPERATORS ARE MADE AWARE OF THE INHERENT DANGERS OF OPERATING A HOT OIL FILTER SYSTEM, PARTICULARLY ASPECTS OF OIL FILTRATION, DRAINING, AND CLEANING OF THE FILTER.
4-4 8. Leave the fryer drain valve open for approxima tely 5 minutes, allowing the oil to circulate through the frypot and back into the filter. This step is commonly referred to as polishing and it extends oil life and improves cooking flavor. 9. Close the fryer drain valve.
4-5 4.4 Disassembly, Cleaning, and Reassem bly of the Magnum Leaf Filter Flatbottom Series electric f ryers with built-in filtration come equipped with a Magnasol Magnum Leaf Filter, which eliminates the ne ed for filter pape r. Follow the instru ctions below to disassemble, clean, and reassemble the filte r.
4-6 Reassembly 1. Place the two outer screens together and align their edges. Ensure hole is on same side as handle. Steps 1 and 2 - St ack ou ter sc reens and ins ert edges into fr ame. Step 3 - Insert grid be tween scree ns after screens have been positioned in frame.
4-7 4.5 Filter Troubleshooting Pump w on't start. y Return valve not fully open. y Tripped circuit breaker. y Incorrect or no line voltage. y Failed return valve microswitch. Pump stops during filtering process. Motor is hot. y Allow motor to cool for at least 45 min utes and then press thermal overload switch on motor.
5-1 FLATBOTTOM SERIES ELECTRIC FRYERS CHAPTER 5: WIRING DIAGRAM AND COMMON REPAIR PARTS LIST 5.1 Wiring Diagram Optional.
5-2 5.2 Common Repair Parts 1 2 4 5 6 7 8 9 10 11 12 13 16 14 15 3.
5-3 ITEM PART # COMPONENT 1 807-3764 Element, 208VAC 6.3 kW Heating 2 823-3760 Element Assembly, 208 VAC 6.3 kW Heating 3 200-3435SP Element/Probe Guard, Left or Right 4 106-2120 Fuse Assembly, 5 Amp .
5-4 2 6 7 8 9 10 1 3 4 5.
5-5 ITEM PART # COMPONENT 1 106-1683 Hose Assembly, Complete Vacuum 2 810-2245 Hose Assembly, 16 ¾-inch Flexible 3 810-2170 Quick-Disconnect, ½-inch Male 4 810-2173 Quick-Disconnect, ½-inch Female .
Frymaster, L.L.C., 8700 Line Av enue, PO Box 51 000, Shreveport, Louisiana 71135-1000 Shipping Address: 8700 Line Av enue, Shreveport, Louisiana 71106 TEL 1-318-865-1711 FAX (Parts) 1-31 8-219 -7140 (Tech Support) 1-31 8-2 19-7135 Price: $6.
デバイスFrymaster Combinationsの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Frymaster Combinationsをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはFrymaster Combinationsの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Frymaster Combinationsの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Frymaster Combinationsで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Frymaster Combinationsを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はFrymaster Combinationsの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Frymaster Combinationsに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちFrymaster Combinationsデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。