Garminメーカー190-00004-00の使用説明書/サービス説明書
ページ先へ移動 of 27
Av. Kit Install. Manual 190-00004-00 Rev. G Page 1 GPS100 AVIATION KIT INSTALLATION MANUAL COMMUNICA TION & NA VIGA TION S M GARMIN INTERNATIONAL, INC.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 2 © Copyright 1992 Garmin International, Inc. All Rights Reserved This publication is the proprietary property of Garmin International Inc. It may not be reproduced or transmitted in any form whether printed or electronic, without the expressed written consent of Garmin International.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 3 GPS 100 AVIATION KIT INSTALLATION MANUAL TABLE OF CONTENTS SECTION 1 GENERAL DESCRIPTION 1.1 INTRODUCTION 1.2 TECHNICAL CHARACTERISTICS 1.2.1 PHYSICAL CHARACTERISTICS 1.2.2 OPERATIONAL CHARACTERISTICS 1.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 4 LIST OF ILLUSTRATIONS FIGURE 1-1 AVIATION RACK PINOUT DEFINITION 1-2 INTERCONNECT SCHEMATIC 2-1 ANTENNA INSTALLATION CONSIDERATIONS 2-2 GPS INSTALLAT.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 5 SECTION 1 GENERAL DESCRIPTION 1.1 INTRODUCTION This manual describes the physical, mechanical, and electrical characteristics and the installation requirements for the GPS 100 Aviation Kit.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 6 1.2.3 Interfaces The aviation rack contains an electronic module which provides interfaces to various general aviation instruments. Figure 1-1 defines the function of each pin on the 15 pin DSUB connector located at the back of the rack.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 7 2.1.2 NOISE SOURCES The antenna should be located at least 3 ft from transmitting antennas such as VHF Comm, HF transmitter, DME, Transponder, and Radar. Cabling for the GPS 100 should not be routed near components or cabling which are sources of electrical noise.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 8 SECTION 3 INSTALLATION PROCEDURE 3.1 INSTALLATION KIT CONTENTS One of the following two installation kits is required for aircraft installation, depending on the type of antenna used.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 9 3.2 ANTENNA INSTALLATION The Blade Antenna outline and footprint dimensions are shown in Figure 3-1. The Low Profile Antenna outline and footprint dimensions are shown in Figure 3-1A. Both antennas require the same Installation procedure.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 10 3.5 AVIATION INTERFACE SET-UP Before installing the GPS 100 into the aviation rack, several operating parameters need to be set-up so that the GPS 100 can interface properly with the aviation rack and other avionics.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 11 With power applied to the aviation rack turn the GPS 100 on. The Self-Test Page will be displayed followed by the Initialization Page. The GPS 100 must be properly set- up per the instructions in Section 3.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 12 FIGURE 1-1 AV. RACK PINOUT DEFINITION.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 13 FIGURE 1-2 INTERCONNECT SCHEMATIC.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 14 f:antpl ace.cdr Antenna mus t be on top of air craft. Antenna masked by verti cal fin , T tail, or d orsal fin OK FIG 2-1 ANTENNA INSTALLATION CONSIDERATIONS Maintain 6"(16 cm) compass safe distance Unit to be mounted in aircraft radio rack as high as possible.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 15 FIGURE 3-1 BLADE ANTENNA INSTALLATION.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 16 FIGURE 3-1A LOW PROFILE ANTENNA INSTALLATION.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 17 FIGURE 3-2 COAX CABLE INSTALLATION.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 18 FIGURE 3-3 AVIATION RACK DIMENSIONS.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 19 FIGURE 3-4 AVIATION RACK INSTALLATION.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 20 This page was intentionally left blank..
Av. Kit Install. Manual 190-00004-00 Rev. G Page 21 APPENDIX A INSTALLATION DETAILS FOR BEECH B60 1.0 INTRODUCTION: This appendix provides airframe specific information which is necessary to install the GARMIN GPS 100 navigation system in the Beech Duke Model B60 in accordance with STC (tbd).
Av. Kit Install. Manual 190-00004-00 Rev. G Page 22 2.4 PLACARDS After completion of the GPS 100 system installation, affix a durable placard on the instrument panel in the location shown in Figure A-3 which states GPS limited to VFR use only".
Av. Kit Install. Manual 190-00004-00 Rev. G Page 23 FIG A-1 FUNCTIONAL BLOCK DIAGRAM.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 24 FIG A-2 FUSELAGE STATIONS AND WEIGHT AND BALANCE DATA.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 25 FIG A-3 PANEL LAYOUT.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 26 FIG A-4 WIRING DIAGRAM.
Av. Kit Install. Manual 190-00004-00 Rev. G Page 27 FIG A-5 BREAKER LOCATIONS.
デバイスGarmin 190-00004-00の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Garmin 190-00004-00をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはGarmin 190-00004-00の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Garmin 190-00004-00の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Garmin 190-00004-00で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Garmin 190-00004-00を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はGarmin 190-00004-00の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Garmin 190-00004-00に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちGarmin 190-00004-00デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。