GEメーカーZEK757BWの使用説明書/サービス説明書
ページ先へ移動 of 20
GE Monogram ® Installation Instr uctions 27" Built-In Ovens Models ZEK757WW ZEK757BW ZEK737WW ZEK737BW.
Before you begin—Read these instructions completely and carefully . IMPOR TANT: Save these instructions for local inspector’s use. IMPOR TANT: OBSER VE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INST ALLER: Be sure to leave these instr uctions with the Consumer .
Models available ZEK757WW White double convection oven ZEK757BW Black double convection oven ZEK737WW White single convection oven ZEK737BW Black single convection oven Dimensions and clearances Doubl.
Cabinet style options Design Infor mation Built-In Ovens Front Framed Partial Overlay Door Front Framed Full Overlay Door Frameless Monogram ovens are installed directly into a wall or wall oven cabinetr y , 27" minimum width. The front sur face of the ovens will be nearly flush with sur - rounding cabinetr y .
Installation options Single Oven Installed Below A ZMC1090WV/ZMC1090BV Microwave Oven Single Oven Installed Below A ZEM200WV Microwave Oven Design Infor mation Built-In Ovens • Install a single oven alone or below any Monogram microwave oven.
Cabinetr y Built-In Oven s • 2" x 4" lumber for runners • Saw • Level • Phillips screwdriver and wood screws or other hardware for installing runners or shelf to support oven. Ovens are designed for installation in a cabinet 27" min.
Framed cabinet single oven DIMENSIONS A Cabinet Width 27" Min. B Cutout Width 25" Min. C Cutout Height 27-1/2" Min./28-1/8" Max. D Cutout Depth 23-5/8" Min.
Recessed installation: Front framed cabinets with inset doors and drawers Cabinetr y Built-In Ovens Front Framed Inset Flush Door 8 Rough opening for single and double ovens: • Depth 24-1/2" min. from inside back to front of cabinet frame. – If the cabinet is not 24-1/2" deep, the back of the cabinet should be cutout.
Frameless cabinets Frameless Use the infor mation in this dimension drawing for typical frameless cabinets. The front face of the oven will be flush with cabinetr y doors or drawers. Whenever possible, order 27" frameless cabinet with the cutout sized to fit the oven.
Single oven installed below a microwave oven Order a double oven cabinet. See the chart above for cutout dimensions and receptacle locations for each microwave oven. • Allow 1-7/8" clearance between microwave oven and single oven, for trim kit or oven overlap.
Single oven installed below a countertop Monogram 36" Halogen and ribbon cooktop can be installed over a single oven. Refer to cooktop installation instr uctions for cutout. • Locate the junction box 16" min. below the countertop. C 11 Cabinetr y Built-In Ovens Monogram ovens can be installed below a countertop.
Provide oven supports The ovens may be supported by either a solid bottom or 2 x 4 r unners. • The support must be level and rigidly mounted, flush with the bottom edge of the cutout. • The entire weight of the oven is supported by 2 x 4 r unners or the solid floor and must be capable of supporting 200 lbs.
Determine need for filler panels Filler panel construction If the cabinets being used have an opening that is taller than the maximum dimensions indicated for the ovens, filler panels can be made to fill the gaps. Stock filler strips are usually available or for larger gaps order an extra drawer front.
Cut rail for filler panel Cut the rail out of finished material: • The width should match cabinet opening width. • The height of the top rail should be enough to securely attach the rail to the appearance panel, plus 1/4" oven trim overlap.
Cut and secure cleats to filler panel 15 For the bottom filler panel: • Cut 2 cleats out of 3/4" thick material, approxi- mately 1-1/4" wide. • Cut the cleats to a length leaving approximately 1/2" at the top of the filler panel to attach the rail.
Installation Built-In Ovens 16 • Outlet box • Electrical cable—3-conductor or 4-conductor wire—as required by local codes • Flexible power cable connector • Electrician’s pliers Note: Do not use an extension cord with these appliances.
Finalize installation Caution: Do not lift oven or oven door by handle. Door glass breakage or handle damage may occur. Glass surface of door face extends beyond door frame on each side; be careful not to impact this exposed glass. Caution: When door is removed and hinge arms are at stop position, do not bump or try to move hinge arms.
Installation Built-In Oven s 18 • Slide oven into cabinet opening. • Drill 3/32" pilot holes through mounting holes in oven front frame. (2 screw holes for single ovens, 4 screw holes for double ovens.) • Secure oven in place with screws furnished.
Installation Built -In Ovens 19 • When connecting to a 4-conductor branch circuit: – Connect oven red lead to branch circuit red lead. – Connect oven black lead to branch circuit black lead. – Break connection between oven white lead and oven bare copper conductor .
Monogram. ® General Electric Company Louisville, KY 40225 Pub. No. 49-8804 1996 GE Appliances (N.D. 616) 9/96 NOTE: While performing installations described in this book, safety glasses or goggles should be worn.
デバイスGE ZEK757BWの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
GE ZEK757BWをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはGE ZEK757BWの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。GE ZEK757BWの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。GE ZEK757BWで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
GE ZEK757BWを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はGE ZEK757BWの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、GE ZEK757BWに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちGE ZEK757BWデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。