GEメーカーZSC1201SSの使用説明書/サービス説明書
ページ先へ移動 of 20
Installation Instructions Advantium ® 120V Built-In SpeedCook Ovens PSB1200 PSB1201 ZSC1201 ZSC1202 For a Spanish version of this manual, visit our Website at ge.com. Para consultar una version en español de este manual de instrucciones, visite nuestro sitiode internet ge.
Safety Information 2 CONTENTS Design Information Models Available ......................................................................2 Product Dimensions and Clearances ............................3 T ools and Parts Required .......................
Design Information 3 PRODUCT DIMENSIONS AND CLE ARANCES NOTE: Appearance will v ary by model. 19 1/32” 29 3/4” T OOLS AND P AR TS REQUIRED (NO T SUPPLIED ) • #2 Phillips screwdriv er • Hand-he.
Installation Pr eparation 4 ELECTRICAL REQUIREMENTS Single Advantium 120 Installation: This product r equires a 120-volt , 60 Hz, 15-amp circuit and draws 1.8 kilowatts. This pr oduct must be connected to a supply circuit of the pr oper voltage and frequency.
5 Installation Pr eparation Pr eparation WITHOUT an Accessory Storage Drawer PREP ARE THE OPENING (cont .) Installation over a GE/Monogram Warming Drawer : NO TE: Additional clearances between the cutouts may be requir ed. Check to be sure the oven supports above the Warming Drawer location do not obstruct the requir ed interior depth and height .
Installation Pr eparation 6 Pr eparation WITHOUT an Accessory Storage Drawer PREP ARE THE OPENING (cont .) Installation over a GE/Monogram Oven and Warming Drawer : NO TE: Additional clearances between the cutouts may be requir ed.
7 Installation Pr eparation Pr eparation WITHOUT an Accessory Storage Drawer PREP ARE THE OPENING (cont .) Installation under a GE/Monogram Microwave Oven and over a W arming Drawer : NO TE: Additional clearances between the cutouts may be requir ed.
PREP ARE THE OPENING (cont .) Installation beside another GE/Monogram Built-in Speedcook Oven: • If you are mounting one Under -the-Counter GE/Monogram oven beside the other , use the dimensions shown. The middle rail separating the two openings may need to be larger than the 4-1/2 ″ minimum shown.
9 Installation Pr eparation Pr eparation WITH an Accessory Storage Drawer NO TE: MODEL ZSC1201 CAN ONL Y BE INST ALLED WITH AN AC CESSOR Y ST ORAGE DRA WER IF INST ALLED ABOVE 36-3/4 ″ . MODEL ZSC1202 CANNO T BE INST ALLED WITH AN ACCESSORY ST ORAGE DRA WER .
10 Installation Pr eparation Pr eparation WITH an Accessory Storage Drawer NO TE: MODEL ZSC1201 CAN ONL Y BE INST ALLED WITH AN AC CESSOR Y ST ORAGE DRA WER IF INST ALLED ABOVE 36-3/4 ″ . MODEL ZSC1202 CANNO T BE INST ALLED WITH AN ACCESSORY ST ORAGE DRA WER .
11 Installation Pr eparation Pr eparation WITH an Accessory Storage Drawer NO TE: MODEL ZSC1201 CAN ONL Y BE INST ALLED WITH AN AC CESSOR Y ST ORAGE DRA WER IF INST ALLED ABOVE 36-3/4 ″ . MODEL ZSC1202 CANNO T BE INST ALLED WITH AN ACCESSORY ST ORAGE DRA WER .
12 Installation Pr eparation Cooktop Cooktop 25 ″ 1-1/2 ″ Min. 4 ″ High T oekick 23-1/2 ″ 25-1/4 ″ 21 ″ 36 ″ Countertop Height PREP ARE THE OPENING (cont .) Installation beside another GE/Monogram Built-in Speedcook Oven: • If you are mounting one Under -the-Counter GE/Monogram oven beside the other , use the dimensions shown.
REMOVE THE P ACKA GING AND P AR TS 1 13 Installation Instructions • Remove all packing material and tape. • Locate parts package containing mounting screws. • Remove the oven fr om the carton. Do not lift unit by handle or conduit . Tw o people are r equired to lift this oven.
Installation Instructions 14 SLIDE THE OVEN INT O THE CUTOUT CA UTION: Two people are requir ed to lift the oven into the opening. Grasp the bottom at front and r ear . DO NOT USE THE HANDLE T O LIF T THE OVEN. DAMA GE WILL OCCUR . • Lift and hold the oven at the fr ont of the opening.
15 Installation Instructions INST ALL MOUNTING SCREWS • Slide the oven the remaining w ay into the opening so that the side flanges and control panel ar e against the cabinet frame. Make sure that the ov en is centered in the opening. • Open the door , place a turntable tray in the oven and make sure that the tray in the unit is lev el.
16 GE Consumer & Industrial Appliances Assembly Instructions Advantium ® Built -In Accessory St orage Drawer JX2200, JX2201, ZX2201 NO TE: Appearance will vary by model.
UNDER-THE-COUNTER (UT C) MOUNTING BRACKET INST ALL A TION NO TE: For UT C models PSB1200, PSB1201 and ZSC1201 only. Open the accessory drawer so you have access to the top bracket . Remove the three scr ews securing the top bracket . Install the new UTC mounting brack et using the screws r emoved previously.
18 ASSEMBLING THE OVEN T O DRA WER (cont .) Remove the fr ont two bottom screws on each side of the oven and the top center screw on each side of the storage drawer . Place the side supports into the tabs on the drawer and secure using the scr ews supplied and the screws r emoved in Step C.
19 Notes.
Printed in Korea NOTE: While performing installations described in this book , safety glasses or goggles should be worn. NOTE: Product improv ement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.
デバイスGE ZSC1201SSの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
GE ZSC1201SSをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはGE ZSC1201SSの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。GE ZSC1201SSの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。GE ZSC1201SSで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
GE ZSC1201SSを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はGE ZSC1201SSの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、GE ZSC1201SSに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちGE ZSC1201SSデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。