Hans Groheメーカー35115801の使用説明書/サービス説明書
ページ先へ移動 of 16
Installation Instructions / W arranty Steel 35115801 Steel 35116801.
2 W all Mounted Single-Handle Lav Set with Base Plate 35115801 W all Mounted Single-Handle Lav Set 35116801 35115801 35116801 T echnical Data Max. flow rate: 2 .2 g p m Max. water pressure: 147 psi Recommended pressure: 14.7 - 72 psi T est pressure: 232 psi Max.
3 Installation with 38111181 rough manufactured before 03/2004 T urn the water off at the supply before beginning this installation. Remove the covers from the plaster shields (1). T rim the plaster shields so that they extend 1/16” out- side the surface of the finished wall (2).
4 Install the new cup washers and springs in the rough. Install the cartridge assembly . Installation with 38111181 rough manufactured after 04/2004 Remove the covers from the plaster shields. T rim the plaster shields so that they extend 1/16” outside the surface of the finished wall.
5 Install the cartridge and anti-twist device in the housing. Install the cup washers and springs in the rough. Install the cartridge assembly . Installation with all models: Push the handle over the cartridge stem. Tighten the handle screw with a 2 mm Allen wrench.
6 Model 35115801 only: Measure the distance between the wall surface and the end of the handle (x). If x is between 3 1/4” and 3 7/8”, select the two “A” sleeves (1 1/4”). If x is between 3 7/8” - 4 3/8”, select the two “B” sleeves (7/8”).
7 Connect the fixation nuts to the sleeves. Measure the distance from the rough to the outside surface of the finished wall (X) (1). Add 1 3/16” to X. Cut the spout connecting thread so that it is X + 1 3/16” long (2). W rap the connecting thread with T eflon tape.
8 T ighten the retaining nuts with the ser vice key . Lightly lubricate the o-rings on the spout and handle escutcheons with the enclosed lubricant (1). Push the escutcheons onto the baseplate (2). Push the baseplate against the wall (1). Thread the sleeves into the rough (2).
9 Push the spout over the connecting thread (1). T ighten the set screw with a 3 mm Allen wrench (2). Install the handle flange (3). 1. 2. 3..
10 Model 35116801 only: Measure the distance between the wall surface and the end of the handle (x). If x is between 3 1/4” and 3 7/8”, select the “A” sleeve (1 1/4”). If x is between 3 7/8” - 4 3/8”, select the “B” sleeve (7/8”). If x is greater than 4 3/8”, select the “C” sleeve (1/2”).
11 Push the sleeve / handle escutcheon assembly into place over the handle (1). T ighten it by rotating it clockwise (2). Push the flange over the handle. Push the sealing ring into the handle escutcheon (1). Install the handle escutcheon onto the sleeve (2).
12 Measure the distance from the rough to the outside surface of the finished wall (X) (1). Add 1 3/16” to X. Cut the spout connecting thread so that it is X + 1 3/16” long (2). W rap the spout connecting thread with T eflon tape. Install the spout connecting thread.
13 35115801 User Instructions Pivot the handle up to turn the water on, down to turn it off. Pivot the handle to the left for warmer water , to the right for cooler water .
14 Replacement Parts 35116801 1 flange 96908800 2 handle 35094800 3 handle escutcheon 96912800 4 spout escutcheon 96913800 5 baseplate 96927800 6 cartridge 96339000 7 aerator 96683800 8 spout 97282800.
15 Limited Lifetime Consumer W arranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 T el. 770 360-9880 • Fax 770 360 9887 www .hansgrohe-USA.com US - Installation Instructions • Part No.
デバイスHans Grohe 35115801の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Hans Grohe 35115801をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHans Grohe 35115801の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Hans Grohe 35115801の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Hans Grohe 35115801で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Hans Grohe 35115801を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHans Grohe 35115801の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Hans Grohe 35115801に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHans Grohe 35115801デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
