Harman Stove CompanyメーカーP61-2の使用説明書/サービス説明書
ページ先へ移動 of 24
P61-2 Pellet S tove Owners Manual SAFETY NOTICE PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INST ALL AND USE YOUR NEW ROOM HEA TER.
2 Fig. 1.
3 Please read this entire manual before you install and use your new room heater . Failure to follow instructions may result in property damage, bodily injury , or even death.
4 Unpacking The P61 is bolted to the skid to prevent move- ment during shipping. To free the stove from the skid you must re- move the hold-down bolts in the rear of the pedestal base.
5 Inst alling Place the stove on a noncombustible floor or UL approved floor protector that extends 6 inches to the front, 6 inches to the sides and 1 inch to the rear of the stove.
6 V enting Requirement s for T erminating the V enting W ARNING: V enting terminals must not be re- cessed into a wall or siding.
7 A combustion blower is used to extract the com- bustion gases from the firebox. This causes a nega- tive pressure in the firebox and a positive pressure in the venting system as shown in fig.
8 #2 Preferred method This method also provides excellent venting for normal operation but requires the stove to be installed farther from the wall.
9 #4 Inst alling into an existing chimney ( US only ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure.
10 #6 Inst alling into an existing fireplace chimney ( US and Canada ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure.
11 #8 Inst alling through the ceiling vent Through the ceiling vent, follow PLvent manufacturers recommendations when using wall and ceiling pass through.
12 Operation St arting First Fire Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red power light on the control panel.
13 When to use "Stove T emp Mode" In "S tove T emp Mode" the S tove T emp Dial de- termines the temperature of the stove. Heat output and fuel consumption will remain constant.
14 ESP CONTROL Feed adjuster Sets the maximum feed ra te Test Runs all motors at full speed for two minutes to check operation.
15 The room sensor is a small temperature sen- sor on the end of a 60" gray wire. This sensor is installed much like a standard wall thermostat.
16 Removing Ashes: When approximatly 1 ton of pellets has been burned it will be necessary to empty the ash pan. Ashes should be placed in a metal con- tainer with a tight fitting lid.
17 Latch "closed "with blower cover in place. Burn pot clean-out is closed. Latch "open "with blower cover partly removed. Burn pot clean-out is open. Exposed blower wheel and flue opening, NOTE: ESP probe is visible.
18 FEEDER DOES NOT FEED 1. No pellets in hopper . 2. Feed motor will not run until ESP senses 165 deg. F. Maybe you did not put enough pellets in the burn pot before lighting the fire.
19 Weight 249 lbs. Blower 135 cfm Feed Rate .75 to 7.5 lbs. per hr . Hopper Capacity 72 lbs. Fuel Wood Pellets Flue Size 3 inch Outside Air Size 2 3/8 I.D. inch Fuse Rating 5 amp 32.
20 P61-2 Wiring Diagram.
21 Door Options Optional T rim To install, lay the frame face down on a sof t surface. Fasten door frame by inserting the 4 threaded post s on the frame through the door .
22 OPTIONS Side Heat Shields Side heat shields are available to reduce the clearance to combustible materials.
23 Description Part Number Hopper Gasket(6 ft.) 0-88-00248 Ash Pan Assembly 1-10-05800 Burn Pot Weldment 1-10-05802 Right Rear Shield 2-00- 06468-1 Left Rea.
24 Harman S tove Company warrants its products to be free from defects in material or workmanship, in normal use and service.
デバイスHarman Stove Company P61-2の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Harman Stove Company P61-2をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHarman Stove Company P61-2の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Harman Stove Company P61-2の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Harman Stove Company P61-2で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Harman Stove Company P61-2を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHarman Stove Company P61-2の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Harman Stove Company P61-2に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHarman Stove Company P61-2デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
