HealthriderメーカーH450Iの使用説明書/サービス説明書
ページ先へ移動 of 32
Model No. HRTL61706.1 Sedal No. Serial Number Decal As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or if parts are damaged or missing, PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT DIRECTLY. CALL TOLL-FREE: Mon.
TABLE OF CONTENTS iMPORTANT PRECAUTIONS ................................................................ 3 BEFORE YOU BEGIN ...................................................................... 5 ASSEMBLY .............................................
iMPORTANT PRECAUTIONS WAR NmNG: To reduce the .s. of burns, f re, e ectde shoe., or injury to persons, read the following important precautions and information before operating the treadmill. 2, 3. it is the responsibility of the owner to ensure that all users of 1his treadmill are adequately informed of aH warnings and precautions.
19. Never leave the treadmill unattended while it 23. Inspect and properly tighten all parts of the is running. Always remove the key, unplug the power cord, and switch the reset/off cir= cuit breaker to the off position when the treadmill is not in use.
BEFORE YOU BEGIN Thank you for sebcting the revoUutionary HeaUthRide¢_ PRO H450i treadmill The PRO H450i treadmHU offers an impressive array of features designed to make your workouts at home more en.
AssembJy requires two persons. Set the treadmill in a cbared area andremove all packing materials, Do not dispose of the packing matedaJs until assemMy is completed.
2. 2 _ SHde a Front Endcap (80) onto the Base (81). Partiafly tighten a Endcap Screw (79)into the Front Endcap andthe base, Sfide a WheeU Housing (86)onto the Base (81).
5, 5 With the heUp of a second person, carefully raise the LeftUpright (70) and the Right Upright (not shown) to a vertbaU position, Remove the knob from the pin, Make sure that the collar andthe spri.
While a second person holds the console as° sembly near the Pulse Bar (66), connect the Ground Wire (107) on the Pulse Barto the ground wire from the console assembly, Connect the wire from the console assembly to the Upright Wire (75), Make sure to connect the connectors properJy (see the inset draw- ing}.
11, Lower the Uprights (70, 76) as shown, Start the two indicated Console Screws (67) into the Left andRight Uprights (70, 76) and the con- sob assembly, if necessary, pull back on the console assembl.
mf you purchase the optional chest puJse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor. 1, Remove the key from the console and unplug the power cord.
OPERATION AND ADJUSTMENT THE PRE-LUBRmCATED WALKmNG BELT Your treadmHU features a waUking beUtcoated with high° performance Uubrbant, IMPORTANT: Never apply sil- icone spray or other substances to the waJking beJt or the walking platform. Such substances will deteriorate the walking belt and cause excessive wear.
CONSOLE DmAGRAM / z L L _J J Note: If there is a sheet of clear plastic on the face of the console, remove it. FEATURES OF THE CONSOLE The treadmill console offers an impressive array of features designed to make your workouts more effec- tive.
HOW TO TURN ON THE POWER Hug in the power cord (see page 12), Locate the reset/off circuit breaker near the power cord, Make sure that the circuit breaker is in the reset position, Reset Position Stan.
Follow your progress with the display. When the manual __ mode is se- m bcted, the bwer part of Track the dispUay wHU show a 1/4-mile track. As you waUk or run, the indicators around the track wH] appear in succession until the entire track appears.
HOW TO USE A PRESET PROGRAM insert the key fuity into the consote. See HOW TO TURN ON THE POWER on page 14. Enter your weight if desired. See step 2 on page 14. Select one of the preset programs. To select one of the preset pro- grams, press the P5, P6, P7, or P8 button.
Fottow your progress with the display. NOW TO USE A CALORIE PROGRAM See step 6 on page 15, Measure your heart rate if desired. See step 7 on page 15, Turn on the fan if desired. See step 8 on page 15, When you are finished exercising, remove the key from the consote.
When only three seconds remain in the first seg- ment of the program, both the Current Segment column and the column to the right will flash and a series of tones will sound, if the speed and/or in- c.
THE INFORMATION MODE/DEMO MODE THE OPTIONAL CHEST PULSE SENSOR The consoUe features an information mode that keeps track of the totaU number of hours that the treadmHU has been operated and the totaU number of miles that the waUking beUthas moved.
HOW TO FOLD AND MOVE THE TREADMmLL HOW TO FOLD THE TREADMmLL FOR STORAGE Before foJding the treadmill, adjust the incline to the towest position, mf this is not done, the treadmill may be per- manently damaged. Next, unplug the power cord. CAUTmON: You must be abJe to safely lift 45 pounds (20 kg) to raise, tower, or move the treadmill.
HOW TO LOWER THE TREADMmLL FOR USE 1, HoUdthe upper end of the treadmHUwith your right hand, PuN the latch knob to the bft and hoUd it, Pivot the frame down° ward until the catch is past the Uatch pi.
TROUBLESHOOTmNG Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed, mf you need further assistance, please see the front cover of this manual.
With the heUp of a second person, carefully raise the Uprights (70, 76) as shown, Carefully pivot the Hood (28) off, Locate the Reed Switch (39) and the Magnet (6) on the bft side of the Pulley (7), T.
CONDiTiONiNG GUiDELiNES WARNING: Before beginning the or any exercise program, consuJt your physi° ciano This is especially important for individu_ als over the age of 35 or individuals with pre_ existing health problems. The puJse sensor is not a medical device.
SUGGESTED STRETCHES The correct form for several basic stretches is shown at the right, Move slowly as you stretch--never bounce, 1. Toe Touch Stretch Stand with your knees bent slightly and slowly be.
PART LIST--Model No. HRTL61706.1 Roto7A To Uocate the parts Hsted beUow, see the EXPLODED DRAWUNG on pages 28 to 31, Key No. Qty. Description Key No. 1 2 Foot Rail Cover 51 2 10 Foot Rail Cover Screw .
Key No. Qty. Description Key No. Qty. Description 101 1 Console Fan 109 102 2 Fan Screw # 103 1 Static Decal # 104 1 Rear Roller # 105 1 Controller Wire # 106 1 Front Roller Nut # 107 1 Console Ground.
co 18 26 23 24 21 23 19 4 rT'l X 0 II"1"1 l Z [ 0 i Z 0 m Z ,-4 0 m o o.
EXPLODED DRAWING B--Model No. HRTL61706.1 Rolo7A 11 ---.%. 28 32 33 -- 41 48 53 _54 31 29 36 .35 37 43 44 54 46 4O 59 55 57 11 13 58 47 29.
EXPLODED DRAWING C--Model No. HRTL61706.1 Rolo7A 69 _65 23 70 23 67 ---107 J 23 °3 i i i i 62 66 _65 H 23 J J 71 69 73 _---79 76 87 83 i i i 88 85 42 _89 &-108 77 97 109 78 41 _77 86 42 {_8_ 84 4.
EXPLODED DRAWING D--Model No. HRTL61706.1 nolo7A 96 102 101 102 98 23 23 103 ,,' 31.
LiMiTED WARRANTY WHAT IS COVERED--The entire HealthRider PRO H450i treadmill ("Product") is warranted to be free of ail defects in material and workmanship, WHO IS COVERED--The original purc.
デバイスHealthrider H450Iの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Healthrider H450Iをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHealthrider H450Iの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Healthrider H450Iの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Healthrider H450Iで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Healthrider H450Iを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHealthrider H450Iの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Healthrider H450Iに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHealthrider H450Iデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
