Hearth and Home TechnologiesメーカーMontana-36の使用説明書/サービス説明書
ページ先へ移動 of 28
01/04 4039-150 Rev B 1 INST ALLA TION & OPERA TING INSTRUCTIONS MONT ANA-36 AND MONT ANA-42 OUTDOOR WOODBURNING FIREPLACE This fireplace must be inst alled outside. Significant cold air infiltration will result if it is inst alled inside a structure.
2 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS TABLE OF CONTENTS A. Listings and Code Approvals ........................................................................................................................................ 3 B. Description of the Fireplace System .
01/04 4039-150 Rev B 3 MONT ANA INST ALLA TION INSTRUCTIONS W ARNING! This fireplace and its components are designed to be inst alled and operated as a system.
4 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS C. FIREPLACE SYSTEM COMPONENTS 1. Fireplace Component s Fireplace Dimensions # g o l a t a C: n o i t p i r c s e D 6 3 - A N A T N O M2 4 -.
01/04 4039-150 Rev B 5 MONT ANA INST ALLA TION INSTRUCTIONS 2. Chimney Components The following pictures show only those chimney components which may be safely used with this fireplace.
6 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS # g o l a t a CA B 6 0 1 1 L S" 6" ¾ 4 2 1 1 1 L S" 2 1" ¾ 0 1 8 1 1 1 L S" 8 1" ¾ 6 1 6 3 1 1 L S" 6 .
01/04 4039-150 Rev B 7 MONT ANA INST ALLA TION INSTRUCTIONS LDS33 (3 x 3) LDS46 (4 x 6) Decorative Shroud ST1 175 Square T ermination Cap CT56 Chase T op CAK5A Chimney Air Kit TR1 1T Round.
8 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS Figure 3 - Inst allation Along a W all or an Exterior Chase Figure 4 - Corner Installation W ARNING! T o prevent contact with sagging or loose insulation, the fireplace must not be installed against vapor barriers or exposed insulation.
01/04 4039-150 Rev B 9 MONT ANA INST ALLA TION INSTRUCTIONS W ARNING! Do not apply combustible finishing materials over any part of the st ainless face of this fireplace or a structure fire may result. The fireplace front may only be covered with noncombustible materials such as ceramic tile, brick or stone.
10 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS Figure 7 - Chimney Offset/Return Example: Y our A dimension from Figure 7 is 14½. Using T able 1 the dimension closest to, but not less than 14½ is 14 5 / 8 using a 30° offset/return.
01/04 4039-150 Rev B 11 MONT ANA INST ALLA TION INSTRUCTIONS Figure 8 - Chimney Height S T N E N O P M O C Y E N M I H C F O T H G I E H r e z i l i b a t S y e n m i h C 1 1 L S4 3 / 4 " s r e c.
12 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS F . INST ALLA TION OF THE FIREPLACE W ARNING! Before st arting, do the following: 1. W ear gloves and safety glasses for protection. 2. Keep hand tools in good condition. Sharpen cutting edges and make sure tool handles are secure.
01/04 4039-150 Rev B 13 MONT ANA INST ALLA TION INSTRUCTIONS Figure 1 1 Installing the Firestop Sp acer CAUTION: Firestop sp acers must be used whenever the chimney penetrates a ceiling/floor area.
14 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS W ARNING! Maintain a minimum of 2 air clearance to all parts of the chimney system at all times! Failure to maintain this 2 air clearance will cause a structure fire. CAUTION: Inner flue and outer liner sections cannot be disas- sembled once locked together .
01/04 4039-150 Rev B 15 MONT ANA INST ALLA TION INSTRUCTIONS 9. Inst all the T ermination Cap If a roof flashing is to be used, install the roof flashing appropriate to the roof pitch and install a round termination cap following the instructions shipped with the cap.
16 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS 1 1. Inst all the Chimney Air Kit When installing the chimney air kit, follow the instructions provided with this accessory . Figure 17- Cooling Air Location Note: The cooling air kit must terminate at least six feet above ground level.
01/04 4039-150 Rev B 17 MONT ANA INST ALLA TION INSTRUCTIONS Note: Use only a noncombustible material to finish the face of the fireplace below the level of the front standof fs. A noncombustible material such as USG MICORE CV230 Mineral Fiber Board, or USG DUROCK Cement Board is recommended for this purpose.
18 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS Figure 21 - Factory Built Hearth Extension Figure 22 - Field Constructed Hearth Extension W ARNING! Hearth extensions are to be inst alled only as illustrated to prevent high temperatures from occurring on concealed combustible materials.
01/04 4039-150 Rev B 19 MONT ANA INST ALLA TION INSTRUCTIONS Figure 23 - Position the Hearth Extension 15. Position the Hearth Extension Position and secure the hearth extension over the protective metal strips that have been placed partially under the fireplace front.
20 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS W ARNING! Never install a single wall slip section or smoke-pipe in a chase structure. The higher temperature of this single wall pipe may radiate sufficient heat to combustible chase materials to cause a fire.
01/04 4039-150 Rev B 21 MONT ANA INST ALLA TION INSTRUCTIONS Note: Save and p ass this instruction manual to subsequent home owners. The information provided is intended to notify and warn them about making unsafe future modifications such as the addition of shelves or the use of unauthorized part s and rep airs.
22 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS Figure 24 Proper Operating Positions of Bi-Fold Doors CAUTION: When left closed while burning your fireplace, firescreens and glass doors will be HOT .
01/04 4039-150 Rev B 23 MONT ANA INST ALLA TION INSTRUCTIONS SEASONING: Seasoned firewood is nothing more than wood that is cut to size, split and air dried to a moisture content of around 20%. The time it takes to season wood varies from around nine months for soft woods to as long as eighteen months for hardwoods.
24 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS CAUTION: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liq- uids to start or freshen up a fire in this fire- place. Keep all such liquids well away from the fireplace.
01/04 4039-150 Rev B 25 MONT ANA INST ALLA TION INSTRUCTIONS H. MAINTENANCE INSTRUCTIONS W ARNING! A chimney fire can permanently damage your chimney system. This damage can only be repaired by replacing the damaged component part s. Chimney fires are not cov- ered by the Limited W arranty and Buyer Protection Plan.
26 4039-150 Rev B 01/04 MONT ANA INST ALLA TION INSTRUCTIONS Homeowner s Notes.
01/04 4039-150 Rev B 27 MONT ANA INST ALLA TION INSTRUCTIONS INDEX A Air Clearance 14, 17 Ashes, Disposal of 25 Attic Insulation Shield 6, 14 B Building Codes 3, 19 C Chase T op 7, 19 Chimney Checking.
28 4039-150 Rev B 01/04 W ARRANTY FOR HEA T -N-GLO FIREPLACES The limited warranty will not become effective until you have mailed the completed warranty card to: Hearth & Home T echnologies Inc., A DIVISION OF HON Industries 20802 Kensington Blvd.
デバイスHearth and Home Technologies Montana-36の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Hearth and Home Technologies Montana-36をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHearth and Home Technologies Montana-36の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Hearth and Home Technologies Montana-36の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Hearth and Home Technologies Montana-36で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Hearth and Home Technologies Montana-36を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHearth and Home Technologies Montana-36の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Hearth and Home Technologies Montana-36に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHearth and Home Technologies Montana-36デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
