Heat & Glo LifeStyleメーカーST-38GTVの使用説明書/サービス説明書
ページ先へ移動 of 18
1 - Do not store or use gasoline or other flam- mable vapors and liquids in the vicinity of this or any other appliance. - What to do if you smell gas Do not try to light any appliance. Do not touch any electrical switch. Do not use any phone in your building.
2 These units MUST use one of the vent systems described in the Installing the Fireplace section of the Installers Guide . NO OTHER vent systems or components MA Y BE USED . This gas fireplace and vent assembly MUST be vented directly to the outside and MUST NEVER be attached to a chimney serving a separate solid fuel burning appliance.
3 Safety and Warning Information ..................................... 2 Service Parts List ............................................................ 4 Section 1: Approvals and Codes .................................... 6 Appliance Certification ..
4 ST -38GTV Exploded Parts Diagram / V ue éclatée des pièces * Part number list on following page. * La liste des numéros de pièce se trouve à la page suivante.
5 ST -38GTV Service Parts List / Liste des pièces de rechange IMPORT AN T : THIS IS DA TED INFORMA TION. The most current information is located on your dealers VIP site. When ordering, supply serial and model numbers to ensure correct service parts.
6 Appliance Certification The Heat-N-Glo fireplace model discussed in this Installers Guide has been tested to certification standards and listed by the applicable laboratories. Certification MODEL: ST -38GTV LABORA T OR Y : Warnock Hersey Listed TYPE: B V ent Decorative ST ANDARD: ANSI Z21.
7 2 Getting St arted Introducing the Heat-N-Glo Gas Fireplaces Heat-N-Glo B vent gas fireplaces are designed to operate with all exhaust gases expelled to the outside. The information contained in this Installers Guide , unless noted otherwise, applies to all models and gas control systems.
8 Figure 1. Diagram of the ST -38GTV 19 5 /16 (491m m ) 22 1 /6 (560mm) VENT CO LLAR 1 1 1/32 (280 m m) 38 1 /4 (972mm) GAS LINE ACCESS 8 (2 0 3mm) 1 1 (279m m) 31 1 /2 (800mm) 38 5 /8 (981mm) 35 3 /4.
9 3 Inst alling the Fireplace Step 1. Locating the Fireplace The diagram below shows space and clearance require- ments for locating a fireplace within a room. Minimum Clearances from the Fireplace to Combustible Materials Inches mm Glass Front ......
10 Negative Pressure warning : When negative pressure is present, an atmospherically vented fireplace (with a draft hood) may not function properly and it may down draft. In the case of a gas appliance, spillage of the combustion gases may occur . This may create a dangerous carbon monoxide situation in the house.
11 ! ! Step 4. Inst alling the V ent System A. V ent System Approvals Model ST -38GTV is approved to use 5-inch (127mm) diameter B-type vent. B-type vent must be used when the vent system is within combustible construction.
12 Step 5. Positioning, Leveling, and Securing the Fireplace The diagram below shows how to properly position, level, and secure the fireplace. Figure 7. Proper Positioning, Leveling and Securing of a Fireplace Place the fireplace into position (see Figure 7).
13 ! Figure 9. Gas Supply Line At the gas line access hole, use insulation to re-pack the space around the gas pipe. Insert insulation from the outside of the fireplace and pack the insulation tightly to totally seal between the pipe and the outer casing.
14 ! Step 9. Wiring the Fireplace NOTE: Electrical wiring must be installed by a licensed electrician. CAUTION: DISCONNECT REMOTE CONTROLS IF YOU ARE ABSENT FOR EXTENDED TIME PERIODS.
15 Figure 1 1. Fan Wiring Diagram OU TER CAS TING IN NER CASTING BLO WER FLANGE LOWER MOUNTING FLA NGE BLO WER ASSEMBL Y #6 X 1/2" SCRE W UPPER MOUNTING BRACKET ( B) OIL H O LE S BLOWER ASSEMBL Y.
16 CAUTION: IF JOINTS BETWEEN THE FINISHED W ALLS AND THE FIREPLACE SURROUND (TOP AND SIDES) ARE SEALED, A 300° F . MINIMUM SEALANT MA TE- RIAL MUST BE USED. THESE JOINTS ARE NOT RE- QUIRED TO BE SEALED. ONL Y NON-COMBUSTIBLE MA TERIAL (USING 300° F .
17 Step 12. Before Lighting the Fireplace Before lighting the fireplace, be sure to do the following: Remove all paperwork from underneath the fireplace. Review safety warnings and cautions Read the Safety and Warning Information section at the beginning of this Installers Guide .
18 4 Maint aining and Servicing Y our Fireplace Fireplace Maintenance Although the frequency of your fireplace servicing and main- tenance will depend on use and the type of installation, you should have a qualified service technician perform an appli- ance check-up at the beginning of each heating season.
デバイスHeat & Glo LifeStyle ST-38GTVの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Heat & Glo LifeStyle ST-38GTVをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHeat & Glo LifeStyle ST-38GTVの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Heat & Glo LifeStyle ST-38GTVの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Heat & Glo LifeStyle ST-38GTVで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Heat & Glo LifeStyle ST-38GTVを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHeat & Glo LifeStyle ST-38GTVの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Heat & Glo LifeStyle ST-38GTVに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHeat & Glo LifeStyle ST-38GTVデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
