Henny PennyメーカーOFE-321の使用説明書/サービス説明書
ページ先へ移動 of 14
Model OFE-321,322 SECTION 2. MAINTENANCE 2-1. INTRODUCTION This section provides procedures for the checkout and replacement of the various parts used within the fryer. Before replacing any parts, refer to the Troubleshooting Section. It will aid you in determining the cause of the malfunction.
Model OFE-321,322 2-4. POWER SWITCH 1. Remove electrical power supplied to fryer. To avoid electrical shock or property damage, move the POWER switch to OFF and disconnect main circuit breaker, or unplug cord at wall receptacle. 2. Remove control panel.
Model OFE-321,322 2-6. I/O POWER SUPPLY BOARD ASSEMBLY The input/output power supply board assembly distributes voltage to the various components in the fryer. The board also receives information from com ponents in the fryer. 1. Remove electrical power supplied to the unit.
Model OFE-321,322 2-7. DRAIN MICROSWITCH (Continued) 2. The following check should be made to determine if the drain microswitch is defective. a. Remove the two screws securing the microswitch to the drain rod valve bracket. b. Remove wires from the switch.
Model OFE-321,322 2-9. HEATING ELEMENTS Heating elements are available for 208 , 480 and 230 volts. Check data plate to determine correct voltage. C h e c k o u t : If the shortenings temperature recovery is very slow or at a slower rate than required, this may indicate defective heating element(s).
Model OFE-321,322 2-9. HEATING ELEMENTS (Continued) 3. Remove the heating element wires from the term inals by removing the nuts and washers. Label each so it can be replaced on the new element in the same position. 4. Remove the bolts from the five elem ent spreaders.
Model OFE-321,322 2-9. HEATING ELEMENTS (Continued) 13. Connect the power cord to the wall receptacle or close wall circuit breaker. Heating elements should never be energized without shortening in the frypot, or damage to the elements could result. 14.
Model OFE-321,322 2-10. HEATING CONTACTORS Each well of an electric fryer requires two switching contactors. The first in line is the primary contactor and the second in line is the heat contactor. When open, the primary contactor does not allow power to flow to the heat contactor.
Model OFE-321,322 2-10. HEATING Checkout (Power Supplied) CONTACTORS (Continued) To avoid electrical shock, make connections before applying power, take reading, and remove power before removing meter leads. The following checks are performed with the wall circuit breaker closed and the main power switch in the ON position.
Model OFE-321,322 2-11. SPEAKER ASSEMBLY The speaker assembly emits audible signals to let the operator know when cooking and hold times are finished. 1. Remove electrical power supplied to unit. To avoid electrical shock or property damage, move the POWER switch to OFF and disconnect main circuit breaker, or unplug cord at wall receptacle.
Model OFE-321,322 2-12. HIGH TEMPERATURE LIMIT CONTROL The electric units, models OFE-321/2/3/4, use the same high temperature control limits as the gas units, but the m ounting of the capillary tube is different on the electric units compared to the gas u n i t s .
Model OFE-321,322 2-12. HIGH TEMPERATURE LIMIT CONTROL (Continued) Be sure capillary bulb of high limit is located behind capillary bulb of thermostat. Both capillary bulbs and bulb holders should be positioned as not to interfere with basket or when cleaning the frypot wall, or damage to capillary tube could result.
Model OFE-321,322 2-13 707.
Model OFE-321,322 707 2-14.
デバイスHenny Penny OFE-321の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Henny Penny OFE-321をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHenny Penny OFE-321の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Henny Penny OFE-321の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Henny Penny OFE-321で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Henny Penny OFE-321を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHenny Penny OFE-321の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Henny Penny OFE-321に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHenny Penny OFE-321デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
