HP (Hewlett-Packard)メーカーXU800の使用説明書/サービス説明書
ページ先へ移動 of 16
HP Kayak XU800 T echnical Notes.
Notice The infor mation contained in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this material, incl uding, but not lim ited to, the implied war ranties of merchantability and f itness for a particul ar purpose.
HP Kayak XU800 PC Workstat ion Technical Information This section pro vides technical info rmation about your PC W orkstation. Features Feature: Description: System Board Extended-A TX with a dimension o f 12.8-inch x 11.4-in ch. Microprocessor All models have supp ort for up to two Intel Pentium® III p rocessor with either a i256 KB.
Features 2 English Operating Syst em All models are preloaded with Windows NT® 4.0 SP5. Main Memory Maxi mum a mount of memory t hat can be installed is: 2 GB (4 x 512 MB). Models include either: • Four RIMM soc kets supporting RDRA M ECC memory modules installed in pairs.
English 3 Features Video Controllers Models include either: • ELSA GLoria Syn ergy® II AGP video cont roller wit h 32 MB of installed SGRAM video memory (m aximum configuration ). • Matrox® Millennium G250 AGP video controller with 8 MB SGRAM video memory which can be upgraded to 16 MB.
Features 4 English System Board Connectors • One flexible disk drive connect or • Two ATA-66 IDE connect ors (for up to four IDE d evices) • One 16-bit U-160SCS I connector and one SCSI terminator.
English 5 Features Physical Char acteristics (standard configuration) Characteristics: Description: Weight (ex cl. keyboard and display) 14.4 kilo grams (31.68 p ounds). Dimensions 47.0 cm max. (D) by 21,0 c m (W) by 49.0 cm ( H) (18.50 inch es by 8.26 inc hes by 19.
System Specificatio ns 6 English System Speci fications Power Cons umption Inf ormation The power consum ption and acoustics given in the belo w table is valid for a standard co nfiguration as shi pped (one processor , 256 MB of memory, 300 W power supply, on e hard disk dri ve, video card, LAN card).
English 7 System Specificatio ns Maximum Loads Availab le for Accessory Slo ts PCI Accessory Slots The maximum supported po wer consumption per slot i s 25W , either from the 5 V or the 3. 3V supply and m ust respect the electrical specifications of th e PCI 2.
System Specificatio ns 8 English If a standard AGP ( Accelerated Graphic Port) card is install ed in the AGP PRO slot, the maximum power consumption for the PCI accessory and AGP slot must not excee d 75 W .
English 9 System Specificatio ns IRQs, DMAs, and I/O Addresses Used by Your PC Workstation The IRQ, DMA, and I/O address mappings shown here are for a basic configuration. The resources used by your PC W orkstation may vary , depending on which accessory boar ds are bundled with the PC W orkstation.
System Specificatio ns 10 English I/O Addresses used by PC Workstation 0000 - 000F DMA controller 1 0020 - 0021 Master interrupt controller 002E - 002 F Configurat ion regi sters 0040 - 0043 Timer 1 0.
English 11 System Board Con nectors System Board Conn ectors The following diagram shows wher e the different chips and connectors are located on the E-A TX sy stem board. PCI 64-b it Hub (P64H) PCI Slo t 1 (32-bit 33 MHz, 5V) One AGP 4x Slot PCI Slot 2 (32- bit 33 MHz, 5V) PCI Slot 5 (32- bit 33 MHz, 5V) PCI Slot 3 (64 -bit 66 MHz, 3.
System Bo ard Switche s 12 English System Board Switches There are ten sy stem board switches used for configurati on, numbered from 1 to 10. Of these a cer tain number are reserve d and should not be modified, otherwise it coul d lead to a sy stem failure.
English 13 Configurin g Your Networ k Con nection Configuring Yo ur Network Connection Y ou need to use the PC W orkstation’s Setup program to change the integrated Ethernet interface settings. T o access the Setup pr ogram, Press while the ini tial “Kayak” logo is d isplayed immedi ately after restarting the PC Workstation.
Configurin g Your N etwor k Con nectio n 14 English 3 Highlight t he line 1st Device and press or to change the option to Lan . T o disable boot optio ns: 1 Press while the ini tial “Kayak” logo is d isplayed immedi ately after restarting the PC Workstation to access the Setu p pr ogram.
デバイスHP (Hewlett-Packard) XU800の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
HP (Hewlett-Packard) XU800をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHP (Hewlett-Packard) XU800の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。HP (Hewlett-Packard) XU800の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。HP (Hewlett-Packard) XU800で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
HP (Hewlett-Packard) XU800を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHP (Hewlett-Packard) XU800の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、HP (Hewlett-Packard) XU800に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHP (Hewlett-Packard) XU800デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
