American Water HeaterメーカーDIRECT VENT GAS WATER HEATERの使用説明書/サービス説明書
ページ先へ移動 of 40
238-45839-00D REV 07/07 DIRECT VENT GAS WATER HEATER WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone.
2 CONGRATULATIONS! You have just purchased one of the finest water heaters on the market today! This installation, operation and instruction manual will explain in detail the installation and maintenance of your new Direct Vent Gas Water Heater.
3 TABLE OF CONTENTS page GENERAL INFORMATION ........................................................... 4 INSTALLATION ........................................................................... 5 Locating The Water Heater ...........................
4 GENERAL INFORMATION This gas-fired water heater’s design is certified by CSA International under the American National Standard Z21.10.1 - (as indicated on the rating plate) and CSA 4.
5 General Information continued- IMPORTANT Before proceeding, please inspect the water heater and its components for possible damage. DO NOT install any damaged components. If damage is evident then please contact the supplier where the water heater was purchased or the manufacturer listed on the rating plate for replacement parts.
6 Installation (Locating The Water Heater) c ontinued - Water heaters in residential garages must be installed and located, or protected, to avoid phy sical damage. For other installations refer to local codes. In the absence of local codes, the w ater heater must be installed in compliance w ith the National Fuel Gas Code, (ANSI Z223.
7 Installation (Locating The Water Heater) c ontinued - WARNING Liquefied petroleum gases/propane gas are heavier than air and will remain at floor level if there is a leak. Basements, crawl spaces, closets and areas below ground level will serve as pockets for accumulation of leaking gas.
8 Installation (Locating The Water Heater) c ontinued- The water heater must be located close enough to the outside wall to keep the venting distance within the maximum distance described in the installation instructions. Note: The direct vent-air intake terminal must be installed on a vertical wall.
9 OPTIONAL DIRECT VENT-AIR INTAKE TERMINAL GUARD WARNING The direct vent-air intake terminal is HOT while the w ater heater is in operation. Do not touch.
10 Installation continued- Figure 2 Figure 3.
11 VENTING This is a Direct Vent Gas Water Heater where all air for combustion is obtained from the outside atmosphere and all flue gases are discharged to the outside atmosphere.
12 Venting continued- Canadian Installations 1 US Installations 2 I= Clearance to service regulator vent outlet or oil tank vent 36 inches (91 cm) *b J= Clearance to non-mechanical air supply inlet to.
13 Venting continued- The co-axial vent-air intake tubes of this water heater can be installed in any 360 ° configuration as long as the proper clearances for installation, plumbing, operation and servicing are maintained. (See Figure 5). Figure 5 Note: Maintain proper clearances for installation, plumbing, operation and service.
14 Installation (Horizontal and Vertical Vent-Air Intake L en g th s) continued- The water heater is shipped with the following standard vent and air intake system: 239-41097-00.
15 Installation (Horizontal and Vertical Vent-Air Intake L en g th s) continued- Figure 6.
16 VENT-AIR INTAKE SYSTEM INSTALLATION WARNING The vent-air intake sy stem must be properly installed. Failure to properly install the v ent-air intake system could result in property damage, personal injury or death. Do not install any damaged v ent-air intake system components.
17 Installation (Vent-Air Intake System Installation) con tin u ed- 1. Measure the vertical height “Y” requi red in your installation. (See Figure 6). Reference the appropriate Table A to determine number of vent-air intake kits required in your installation.
18 Installation (Vent-Air Intake System Installation) con tin u ed- 5. Insert the straight end of the three (3) inch (7.6 cm) diameter elbow into the flue reducer until firmly seated and oriented in the correct direction.
19 Installation (Vent-Air Intake System Installation) con tin u ed- Figure 9 7. Extend the three (3) inch (7.6 cm) diameter telescopic tube to its maximum length and slide the backing plate over it. Place the large end of the three (3) inch (7.6 cm) diameter telescopic tube through the hole in the outside wall.
20 Installation (Vent-Air Intake System Installation) con tin u ed- Figure 10 8. Extend the five (5) inch (12.7 cm) diameter telescopic tube to its maximum length. Place the large end of the five (5) inch (12.7 cm) diameter telescopic tube over the co llar on the outer wall mount plate.
21 Installation (Vent-Air Intake System Installation) con tin u ed- 9. From outside the building, slide the five (5) inch (12.7 cm) diameter telescopic tube through the opening in the wall until the outer wall mount plate is flush with the wall (See Figure 12).
22 Installation (Vent-Air Intake System Installation) con tin u ed- Figure 13 11. From inside the building, slide the backing plate over the five (5) inch (12.7 cm) diameter telescopic tube until it is flush with the wall. Adjust the length of the five (5) inch (12.
23 Installation (Vent-Air Intake System Installation) con tin u ed- 12. Mark the mounting screw hole locati ons for the backing plate. Rotate the backing plate in order to gain access to the markings. With a 3/16 inch diameter drill bit (not suppli ed), drill holes for the supplied wall anchors.
24 WATER CONNECTIONS Note: BEFORE PROCEEDING WITH THE INSTALLATION, CLOSE THE MAIN WATER SUPPLY VALVE. After shutting off the main water supply, open a faucet to relieve the water line pressure to prevent any water from leaking out of the pipes while making the water connections to the water heater.
25 Water Connections continue d- WARNING For protection against excessive temperatures and pressure, install temperature and pressure protective equipment required by local codes, but not less than a .
26 Water Connections continue d- WARNING FAILURE TO INSTALL AND MAINTAIN A NEW, LISTED 3/4” X 3/4” TEMPERATURE AND PRESSURE RELIEF VALVE WILL RELEASE THE MANUFACTURER FROM ANY CL AIM, WHICH MIGHT RESULT FROM EXCESSIVE TEMPERATURES AND PRESSURES.
27 Water Connections continue d- .
28 Gas Connections The gas supply lines must meet all requi rements of the National Fuel Gas Code (ANSI Z223.1-Latest Edition), or in Canada CAN/CGA B149.1 Natural Gas Installation Code (Latest Edition) or CAN/CGA B149.2 Propane Installation Code (Latest Edition).
29 GENERAL OPERATION WARNING Water heaters are heat producing appliances. To avoid damage or injury, do not store materials against t he water heater or vent-air intake system. Use proper care to avoid unnecessary contact (especially by children) with the water heater and vent-air intake system.
30 Lighting & Shutdown Instructions TO TURN OFF GAS TO APPLIANCE LIGHTING INSTRUCTIONS FOR YOUR SAFETY READ BEFOR E LIGHTING WARNING: If you do not follow these instruct ions ex actly, a fire or explosion m ay result causing pr operty dam age, personal inj ury or loss of life.
31 THERMOSTAT ADJUSTMENT 160°F Control 180°F Control Figure 16 The thermostat dial is set to its lowest te mperature setting when shipped from the factory. Remember that lower temperature settings are more energy efficient . Adjust the temperature by turning the thermostat dial.
32 Thermostat Adjusting continue d- Hotter water increases the risk of scald injury. Scalding may occur within five (5) seconds at a temperature setting of 140 ° F (60 ° C). To protect against hot water injury, install an ASSE approved mixing valve in the water system.
33 MAINTENANCE WARNING Water heaters are heat producing appliances. To avoid damage or injury, do not store materials against t he water heater or vent-air intake system. Use proper care to avoid unnecessary contact (especially by children) with the water heater and vent-air intake system.
34 Maintenance c ontinued- 6. Annually remove the inner door and main burner assembly to clean orifices and related parts of any dirt or other foreign material. Inspect the burner ports for obstructions or debr is and clean with a wire brush as needed.
35 Maintenance c ontinued- CAUTION FOR YOUR SAFETY, DO NOT ATTEMPT REPAIR OF COMBINATION GAS CONTROL, BURNERS OR GAS PIPING. REFER REPAIRS TO A QUALIFIED SERVICE TECHNICIAN. Contact your supplier or plumbing professional for replacement parts or contact the company at the address gi ven on the rating plate of the water heater.
36 PARTS LIST PART NAME & DESCRIPTION 1. Direct Vent-Air Intake Terminal 21. Piezo Ignitor Assembly 2. Outer Wall Mount Plate 22. Drain Valve 3. Backing Plate 23. Outer Door 4. Five (5) inch (12.7 cm) Diameter Telescopic Air Intake Tube 24. Jacket 5.
37 DIRECT VENT WATER HEATER.
38 VENT-AIR INTAKE KITS.
39 THE FOLLOWING INSTRUCTIONS ARE FOR INSTALLATION OF: GAS WATER HEATERS SUITABLE FOR WATER (POTABLE) HEATING AND SPACE HEATING 1. All piping components connected to th is water heater for space heating applications must be suitable for use with potable water.
40 NOTES.
デバイスAmerican Water Heater DIRECT VENT GAS WATER HEATERの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
American Water Heater DIRECT VENT GAS WATER HEATERをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAmerican Water Heater DIRECT VENT GAS WATER HEATERの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。American Water Heater DIRECT VENT GAS WATER HEATERの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。American Water Heater DIRECT VENT GAS WATER HEATERで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
American Water Heater DIRECT VENT GAS WATER HEATERを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAmerican Water Heater DIRECT VENT GAS WATER HEATERの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、American Water Heater DIRECT VENT GAS WATER HEATERに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAmerican Water Heater DIRECT VENT GAS WATER HEATERデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
