Invacareメーカー At'mの使用説明書/サービス説明書
ページ先へ移動 of 44
Owner’s Operator and Maintenance Manual DEALER: This manual MUST be given to the user of the wheelchair. USER: BEFORE using this wheelchair, read this manual and save for future reference. For more information regarding Invacare products, parts, and services, please visit www.
At’m 2 Part No. 112 5035 WARNING A QUALIFIED TECHNICIAN MUST PERFORM THE INITIAL SET UP OF THIS WHEELCHAIR. ALSO, A QUALIFIED TECHNICIAN MUST PERFORM ALL PROCEDURES IN THE SERVICE MANUAL.
TABLE OF CONTENTS Part No. 1125035 3 At’m TABLE OF CONTENTS REGISTER YOUR PR ODUCT................................................................ 6 SPECIAL NOTES ................................................................................ 9 LABEL LOCATION .
TABLE OF CONTENTS At’m 4 Part No. 112 5035 TABLE OF CONTENTS SECTION 5—WHEELCHAIR OPERATION ....................................... .... 24 Operating the Wheelchair ................................................................... ..............
TABLE OF CONTENTS Part No. 1125035 5 At’m TABLE OF CONTENTS SECTION 10—WHEELS AN D CASTERS .............................................. 40 Replacing Front Casters .......................... ............................................. .........
At’m 6 Part No. 112 5035 REGISTER YOUR PRODUCT The benefits of registering: 1. Safeguard your investment. 2. Ensure long term maintenance and servicing of your purchase. 3. Receive updates with produc t information, maintenance tips, and industry news.
Name _______________________________________________________________ Address _____________________________________________________________ City ___________________ State/Province __________ Zip/Postal Code ________ Email ___________________________________ Phone No.
Fold here Fold here Cut Along Line Invacare Product Registration Form Please Seal with Tape Before Mailing.
SPECIAL NOTES Part No. 1125035 9 At’m SPECIAL NOTES W ARNING/CAUTION notices as used in th is manual apply to hazards or unsafe practices which could result in pers onal injury or property damage. NOTICE THE INFORMATION CONTAINED IN THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE.
LABEL LOCATION At’m 10 Part No. 112 5035 LABEL LOCATION NOTE: Wa rning label 1 125068 is also located on the opposite side NOTE: Warning label 1 125069 is also located on the opposite side.
TYPICAL PRODUCT PARAMETERS Part No. 1125035 11 At’m TYPICAL PRODUCT PARAMETERS *NOTE: Range will vary with battery conditions, surface, terrain, and operating weight. PARAMETERS At’m SEAT WIDTH: 16, 18 inches SEAT DEPTH: 14, 16 inches BACK HEIGHT: 18, 21 inches SEAT-TO-FLOOR: 20 inches OVERALL WIDTH (EXC LUDING JOYSTICK): 25.
SECTION 1—GENERAL GUIDELINES At’m 12 Part No. 112 5035 SECTION 1—GENERAL GUIDELINES WARNING SECTION 1 - GENERAL GUIDELIN ES contai ns important inform ation for the safe operation and use of this product.
SECTION 1—GENERAL GUIDELINES Part No. 1125035 13 At’m After the wheelchair has been se t-up, check to make sure that the wheelchair performs to the specifications entered du ring the set-up procedure. If the wheelchair does NOT perform to specifications, turn the wheelchair Off imme diately and reenter set-up specifications.
SECTION 1—GENERAL GUIDELINES At’m 14 Part No. 112 5035 Before performing any maintenance, adjustment or service verify that on/off switch on the joystick is in the off position.
SECTION 1—GENERAL GUIDELINES Part No. 1125035 15 At’m GROUNDING INSTRUCTIONS DO NOT , under any circumstance s, cut or re move the roun d grounding prong from any plug used with or for Inv acare products. Some devices are equi pped with three-prong (grounding) plugs for protection against po ssible shock hazards and fire.
SECTION 2—EMI INFORMATION At’m 16 Part No. 112 5035 SECTION 2—EMI INFORMATION WARNING CAUTION: IT IS VERY IMPORTANT THAT YOU READ THIS INF ORMATION REGARDING THE POSSIBLE E FFECTS OF ELECTROMAGNETIC INTERFERENCE ON YOUR POWERED WHEELCHAIR.
SECTION 2—EMI INFORMATION Part No. 1125035 17 At’m WARNING Powered Wheelchair Electrom agnetic Interference (EMI) Because EM energy rapidly becomes more intense as one moves closer to the transmitting antenna (source), the EM fi elds from hand-hel d radio wave sources (transceivers) are of special concern.
SECTION 3—SAFETY/HANDLING OF WHEELCHAIRS At’m 18 Part No. 112 5035 SECTION 3—SAFETY/HANDLING OF WHEELCHAIRS “Safety and Handling” of the wheelchair requir es the close attention of the wheelchair user as well as the assistant.
SECTION 3—SAFETY/HANDLING OF WHEELCHAIRS Part No. 1125035 19 At’m A NOTE TO WHEELCHAIR ASSISTANTS WARNING DO NOT attempt to lift the wheelchair by any removable (detachable) parts. Lift- ing by means of removable (detachable) part s of the wheelchair ma y result in injury to the user and/ or damage to the wheelchair.
SECTION 3—SAFETY/HANDLING OF WHEELCHAIRS At’m 20 Part No. 112 5035 PERCENTAGE OF WEIGHT DISTRIBUTION WARNING DO NOT attempt to reach object s if you have to move fo rward in the seat or pick them up from the floor by reac hing down between your knees.
SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING Part No. 1125035 21 At’m SECTION 4—SAFETY INSPECTION/ TROUBLESHOOTING NOTE: Every six (6) months or as necessary take your wheelchair to a qualified dealer for a thorough inspection and servicing.
SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING At’m 22 Part No. 112 5035 INSPECT/ADJUST WEEKLY ❑ Check pneumatic tires for proper inflation. ❑ Ensure all caster/wheel/fork/he adtube fasteners are secure. ❑ Inspect tires for fl at spots and wear .
SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING Part No. 1125035 23 At’m TROUBLESHOOTING GUIDE NOTE: For additional troublesh ooting information and explanation of err or codes, r efer to the Electronics Manual supplie d with each wheelch air .
SECTION 5—WHEELCHAIR OPERATION At’m 24 Part No. 112 5035 SECTION 5—WHEELCHAIR OPERATION WARNING After ANY adjustments, repa ir or service and BEF ORE use, make sure that all attaching hardware is tightene d securely - otherwise inju ry or damage may result.
SECTION 5—WHEELCHAIR OPERATION Part No. 1125035 25 At’m The joystick has proporti onal drive control, meaning that th e further it is pushed from the upright (neutral) position, the faster the wheelchair moves. The maximum speed, howev er , is limited by the setting of the speed-control knob.
SECTION 5—WHEELCHAIR OPERATION At’m 26 Part No. 112 5035 JOYSTICK SWITCHES AND INDICATORS NOTE: For the following inform ation, r efer to FIGURE 5.1. ON/OFF BUTTON This button is located on the joystick housing. SPEED CONTROL KNOB The speed control knob is locate d on the back of the joystick housing.
SECTION 5—WHEELCHAIR OPERATION Part No. 1125035 27 At’m DISPLAY DESCRIPTION DEFINITION COMMENTS All LEDs are off. Power is Off. All LEDs are on. Power is On. Fewer than three (3) LEDs on implies reduced battery charge. Left RED LED is flashing. Battery charge is low.
SECTION 5—WHEELCHAIR OPERATION At’m 28 Part No. 112 5035 MULTI FUNCTION CHARGER PORT WARNING Set-up/programming of the Electronic Control Unit is to be performed only by a qualified technician. The final adjust- ments of the controller may affect other activities of the wheelchair.
SECTION 6—SEAT Part No. 1125035 29 At’m SECTION 6—SEAT WARNING After ANY adjustments, repa ir or service and BEF ORE use, make sure that all attaching hardware is tightene d securely - otherwise inju ry or damage may result.
SECTION 6—SEAT At’m 30 Part No. 112 5035 FIGURE 6.1 - REMOVING /INSTALLING THE SEAT DETAIL “A” - SEAT TILTED BACK DETAIL “B” - SEAT REMOVED DETAIL “C” - FOLDING SEAT Fold Seat Front La.
SECTION 6—SEAT Part No. 1125035 31 At’m REPLACING SEAT POSITIONING STRAP WARNING ALWAYS wear your se at positioning strap. The seat positioning strap is a positioning be lt ONLY. It is not designed for use as a safety device withstanding hi gh stress loads such as auto or aircraft safety belts.
SECTION 7—JOYSTICK At’m 32 Part No. 112 5035 SECTION 7—JOYSTICK WARNING After ANY adjustments, repa ir or service and BEF ORE use, make sure that all attaching hardware is tightene d securely - otherwise inju ry or damage may result.
SECTION 7—JOYSTICK Part No. 1125035 33 At’m REPOSITIONING THE JOYSTICK NOTE: For this procedur e, r efer to FIGURE 7.2. 1. Disconnect the joystick. Refer to Disconnecting/Connec ting the Joystick on page 32. 2. Cut the tie-wraps that secure the joystick cable to the wheelchair arm and frame.
SECTION 8—BATTERIES At’m 34 Part No. 112 5035 SECTION 8—BATTERIES WARNINGS FOR HANDLING AND REPLACING BATTERIES WARNING After ANY adjustments, repa ir or service and BEF ORE use, make sure that all attaching hardware is tightene d securely - otherwise inju ry or damage may result.
SECTION 8—BATTERIES Part No. 1125035 35 At’m REMOVING/INSTALLING THE BATTERY PACK WARNING Never unplug the batte ry cables by pulling on the wi res. Unplug the battery cables by pulling on the connector ONLY. Othe rwise injury or da mage may result.
SECTION 8—BATTERIES At’m 36 Part No. 112 5035 REMOVING/INSTALLING THE BATTERIES FROM/ INTO THE BATTERY PACK NOTE: For this procedur e, r efer to FIGURE 8.3. REMOVING 1. Remov e the battery pack from the wheel chair . Refer to Removing/Install ing the Battery P ack on page 35.
SECTION 8—BATTERIES Part No. 1125035 37 At’m FIGURE 8.3 - REMOVING/INSTALLING THE BATTERIES FROM/INTO THE BATTERY PACK CHARGING BATTERIES WARNING Never attempt to recharge the batteries by attaching cables directly to the battery terminals. DO NOT attempt to recharge the batteries and operate th e wheelchair at the same time.
SECTION 8—BATTERIES At’m 38 Part No. 112 5035 Basic concepts which will help you understand this automatic process are: The amount of el ectric al current drawn within a given ti me to charge a battery is called “charge rate”. If, due to usage, the charge stor ed in the battery is low , the charge rate is high.
SECTION 9—MOTORS Part No. 1125035 39 At’m SECTION 9—MOTORS WARNING After ANY adjustments, repa ir or service and BEF ORE use, make sure that all attaching hardware is tightene d securely - otherwise inju ry or damage may result.
SECTION 10—WHEELS AND CASTERS At’m 40 Part No. 112 5035 SECTION 10—WHEELS AND CASTERS WARNING After ANY adjustments, repa ir or service and BEF ORE use, make sure that all attaching hardware is tightene d securely - otherwise inju ry or damage may result.
SECTION 10—WHEELS AND CASTERS Part No. 1125035 41 At’m ADJUSTING FORKS NOTE: For this procedur e, r efer to FIGURE 10.2. 1. Remov e the dust cov ers from the caster headtubes. 2. T o pro perly tighten the caster journal sy stem and guard against flutter , perform the following check: A.
SECTION 10—WHEELS AND CASTERS At’m 42 Part No. 112 5035 REMOVING/INSTALLING THE DRIVE WHEELS WARNING Maintain tire pres sure at 30 p.s.i. NOTE: For this procedur e, r efer to FIGURE 10.3. REMOVING 1. Disengage the motors. Refer to Engaging/Disengaging the Motors on page 39.
SECTION 11—TRANSPORTING THE WHEELCHAIR Part No. 1125035 43 At’m SECTION 11—TRANSPORTING THE WHEELCHAIR WARNING After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - othe rwise injury or damage may result.
LIMITED WARRANTY PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANU FACTURED AFTER JULY 4, 1975. This warranty is extended only to the or iginal purchaser/user of our products.
デバイスInvacare At'mの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Invacare At'mをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはInvacare At'mの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Invacare At'mの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Invacare At'mで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Invacare At'mを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はInvacare At'mの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Invacare At'mに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちInvacare At'mデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
