Jura Capressoメーカー601の使用説明書/サービス説明書
ページ先へ移動 of 22
IMPRESSA S90/S95/S9 IMPRESSA X90/ X95 IMPRESSA 601 Instructions for use 12/2001 Art. Nr. 61956.
Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. = Note = Important = Tip Jura Impressa S90/S95/S9 – X90/X95 – 601 English ..............................................................................
Fig. 1 Fig. 4 Fig. 2 Fig. 9 Fig. 3 Fig. 7 Fig. 10 Fig. 6 Fig. 5 A B Fig. 8 1 2 3.
7 8 9 17 18 12 13 14 15 16 19 10 11 20 22 21 6 5 4 3 2 1 23 D C B A E F G H.
Instructions for use 1 Drip tray / residual water container 2 Drip tray cover 3 Cover for programming keys 4 Coffee key for 2 large cups 5 Coffee key for 1 large cup 6 Coffee key for 2 small cups 7 Co.
6 T able of contents Jura Impressa 1. Description ...................................................... page 7 2. Safety instructions ............................................ page 7 2.1 Warnings .................................................. page 7 2.
7 Important information for the user Thank you for choosing this Jura product. Please study these instructions carefully before using your new machine and keep them in a safe place for easy reference in the future.
8 If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especially natural stone and wooden surfaces, or take corresponding pre- cautions. 3. Check before use 3.1 Checking mains voltage The machine is set for the correct voltage before leaving our factory.
9 When you switch on the machine or press any key, the cup illumi- nation is activated for 3 minutes. To switch on the cup illuminati- on, with the machine switched off, press any key. 5. Rinsing the machine RINSE UNIT Place an empty cup under the coffee-spout (15).
10 Pull down cartridge mounting, until it engages audibly. Fill water tank with cold, fresh tap-water and replace it. Switch the machine on by pressing key ON/OFF.
11 8.1 Drawing off powder coffee Open cover (3) Press selector key for pre-ground powder coffee . FILL POWDER Now put 1 or 2 level measuring spoons of pre-ground coffee into the pre-ground powder funnel (14). Put 1, respectively 2 cups under the coffee-spout (15) and press the required key.
12 With the flow-adjustment you can set the optimum frothing. Turn the handle slightly to the right or to the left until you obtain the required result. 11.3 Drawing off hot milk using the Auto-Cappuccinatore S9 The Auto-Cappuccinatore of the S9 can be used to draw off hot milk.
13 13.1 Programming powder quantity Switch the machine on by pressing ON/OFF key . Press key until you can hear an acoustic signal. POWDER QUANTITY / SELECT KEY Now press the key that you want to programme.
14 The required portion of tea-water is programmed now. By pressing the button, you can select the next phase, or press the button in order to leave the programming.
15 13.10 Programming automatic switch on time A programming of the timer clock is necessary if an automatic switch on is needed. UNIT ON —.— Press key . By briefly pressing key or you can set the hours and then confirm by pressing key .
16 14.2 Empty grounds container Coffee grounds are collected in the grounds container. EMPTY GROUNDS If this message shows on the display no more coffee can be drawn off. It is necessary to empty the grounds container. Remove drip tray carefully as there is water in it.
17 14.9 General cleaning instructions Never use abrasive articles or corrosive chemicals to clean your machine. Wipe down the casing inside and out using a soft, damp cloth. Clean the pivoting nozzle after every use. After warming milk, draw off some hot water to clean the pivoting nozzle inside.
18 Run the decalcifying program only after the machine has been switched off for at least 5 hours and has cooled down completely. The running decalcifying program must not be interrupted.
19 17. Disposal For correct disposal, you should return your coffee machine to your dealer, Jura service centre or Jura Elektroapparate AG. 18. Tips for a perfect coffee Height adjustable coffee-spout You can adjust the height of the coffee-spout to the size of your cups.
20 19. Messages Cause Action FILL WATER Water tank is empty Top up with water Water level indicator in tank is jammed Empty tank, rinse out, fill up and replace Tank is calcified, water level indicato.
21 Cause Action CLEAN UNIT You have drawn off coffee 220 times or run Clean as described in chapter 14 the rinsing program 180 times Message still displayed, although machine Run cleaning program agai.
22 Problem Cause Action Not enough froth while – Unsuitable milk-type – Use full cream milk frothing up milk – Frothing nozzle blocked – Clean frothing nozzle – Clean Auto-Cappuccino – Clean Auto-Cappuccino as described in chapter – 10.
デバイスJura Capresso 601の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Jura Capresso 601をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJura Capresso 601の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Jura Capresso 601の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Jura Capresso 601で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Jura Capresso 601を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJura Capresso 601の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Jura Capresso 601に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJura Capresso 601デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。