Jura CapressoメーカーS9の使用説明書/サービス説明書
ページ先へ移動 of 22
IMPRESSA S90/S95/S9 IMPRESSA 601 Instructions for use 5/02 Art. Nr. 63720.
Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. = Note = Important = Tip Jura Impressa S90/S95/S9 – 601 English ..........................................................................................
Fig. 1 Fig. 4 Fig. 2 Fig. 9 Fig. 3 Fig. 7 Fig. 10 Fig. 6 Fig. 5 A B Fig. 8 1 2 3.
7 8 9 17 18 12 13 14 15 16 19 10 11 20 22 21 6 5 4 3 2 1 23 D C B A E F G H.
Instructions for use 1 Drip tray / residual water container 2 Drip tray cover 3 Cover for programming keys 4 Coffee key for 2 large cups 5 Coffee key for 1 large cup 6 Coffee key for 2 small cups 7 Co.
6 T able of contents Jura Impressa 1. Description ...................................................... page 7 2. Safety instructions ............................................ page 7 2.1 Warnings .................................................. page 7 2.
7 Important information for the user Thank you for choosing this Jura product. Please study these instructions carefully before using your new machine and keep them in a safe place for easy reference in the future.
8 If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especially natural stone and wooden surfaces, or take corresponding pre- cautions. 3. Check before use 3.1 Checking mains voltage The machine is set for the correct voltage before leaving our factory.
9 When you switch on the machine or press any key, the cup illumi- nation is activated for 3 minutes. To switch on the cup illuminati- on, with the machine switched off, press any key. 5. Rinsing the machine RINSE UNIT Place an empty cup under the coffee-spout (15).
10 Pull down cartridge mounting, until it engages audibly. Fill water tank with cold, fresh tap-water and replace it. Switch the machine on by pressing key ON/OFF.
11 8.1 Drawing off powder coffee Open cover (3) Press selector key for pre-ground powder coffee . FILL POWDER Now put 1 or 2 level measuring spoons of pre-ground coffee into the pre-ground powder funnel (14). Put 1, respectively 2 cups under the coffee-spout (15) and press the required key.
12 11.2 Constant frothing up of milk Pour milk into a milk container and immerse the intake-tube in the milk. Put a cup under the pivoting nozzle (20) and press key . Your milk froths up. STEAM INTAKE When the required amount of froth has been attained push selec- tor key anew.
13 The following settings can be programmed: Powder quantity Coffee temperature Water quantity Steam portion Tea portion Filter Water hardness Economy mode Timer clock Automatic switch on time Automatic switch off time Supplies and cup counter Language selection 13.
14 13.4 Programming steam portion STEAM PORTION Press key . PORTION /....20 SEC. By pressing key or you can programme time in seconds (drawing off time of 3 – 250 sec.) Press key . STEAM PORTION By pressing the button, you can select the next phase, or press the button in order to leave the programming.
15 13.9 Programming timer clock A programming of the timer clock is necessary if an auto- matic switch on time is required. TIME —.— Press key . By briefly pressing key or you can set the hours and then confirm by pressing key . By briefly pressing key or you can set the minutes and then confirm by pressing key .
16 If a mistake occurs while programming one of the above settings, just press key and the chosen setting moves back to its original standard setting. 14. Care and maintenance 14.1 Fill water FILL WATER If this message shows on the display no more coffee can be drawn off.
17 14.7 Unit calcified UNIT CALCED The machine signals when decalcifying becomes necessary. Under the correct implementation of Claris filter cartridges, decalcifying of the machine becomes unnecessary. For further indications read Chapter 7 “Use of Claris filter cart- ridges“.
18 PLEASE WAIT RINSE UNIT COFFEE READY The powder funnel for pre-ground coffee should be cleaned after each cleaning process. Remove it from the machine, rinse it with hot tap water and replace it after drying. 16. Decalcifying Your machine has an integrated decalcifying program.
19 CLEAN CONTACTS / EMPTY TRAY (please refer to chapter 14.8) PLEASE WAIT RINSE UNIT UNIT RINSING COFFEE READY E 17. Disposal For correct disposal, you should return your coffee machine to your dealer, Jura service centre or Jura Elektroapparate AG.
20 19. Messages Cause Action FILL WATER Water tank is empty Top up with water Water level indicator in tank is jammed Empty tank, rinse out, fill up and replace Tank is calcified, water level indicato.
21 Cause Action CLEAN UNIT You have drawn off coffee 220 times or run Clean as described in chapter 14.6 the rinsing program 180 times Message still displayed, although machine Run cleaning program ag.
22 Problem Cause Action Not enough froth while – Unsuitable milk-type – Use full cream milk frothing up milk – Frothing nozzle blocked – Clean frothing nozzle – Clean Auto-Cappuccino – Clean Auto-Cappuccino as described in chapter – 11.
デバイスJura Capresso S9の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Jura Capresso S9をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJura Capresso S9の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Jura Capresso S9の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Jura Capresso S9で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Jura Capresso S9を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJura Capresso S9の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Jura Capresso S9に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJura Capresso S9デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。