Jura CapressoメーカーX90の使用説明書/サービス説明書
ページ先へ移動 of 22
IMPRESSA X90/ X95 Instructions for use 3/03 Art. Nr. 63721 www. redmonkeycoffee .co.uk tel 0870 207 4831 | email mail @redmonkeycoffee.com.
Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. = Note = Important = Tip Jura Impressa X90/X95 English .....................................................................................................
Fig. 1 Fig. 4 Fig. 2 Fig. 9 Fig. 3 Fig. 7 Fig. 13 A B Fig. 8 1 2 3 Fig. 10 Fig. 11 Fig. 12 Fig. 6 Fig. 5.
7 8 9 17 18 12 13 14 15 16 19 10 11 20 22 21 6 5 4 3 21 23 D C B A E F G H.
Instructions for use 1 Drip tray / residual water container 2 Drip tray cover 3 Cover for programming keys 4 Coffee key for 2 large cups 5 Coffee key for 1 large cup 6 Coffee key for 2 small cups 7 Co.
6 T able of contents 1. Description ........................................................ page 7 2. Safety instructions .............................................. page 7 2.1 Warnings ................................................... page 7 2.
7 Important information for the user Thank you for choosing this Jura product. Please study these instructions carefully before using your new machine and keep them in a safe place for easy reference in the future.
8 If using acidic decalcifying agents be sure to immediately re- move any splashes and drops from delicate surfaces, especially natural stone and wooden surfaces, or take corresponding pre- cautions. 3. Check before use 3.1 Checking mains voltage The machine is set for the correct voltage before leaving our factory.
9 Place a container under the coffee-spout (15) and press rinsing key . UNIT RINSING COFFEE READY 4.2 Cup illumination The cup illumination puts your coffee in a good light, making it a treat for the eyes. When you switch on the machine or press any key, the cup illumi- nation is activated for 3 minutes.
10 7. Use of Claris filter cartridges Under proper implementation of Claris filter cartridges, decalcifying of the machine becomes unnecessary. For further information, please read the brochure “Claris. Tough to calcium deposits, gentle to your coffee machine“.
11 UNIT RINSING COFFEE READY Put 1, respectively 2 cups under the coffee-spout and press the required key. The pre-brew system (I.P.B.A.S. © ) moistens the coffee powder, briefly interrupts the flow and then starts the real brewing process.
12 Place a cup under the steam/frothing nozzle (20) and immerse the frothing aid in the milk to be frothed or the liquid to be heated. Press steam portion draw-off key . STEAM PORTION You can stop the draw-off operation at any time by pressing the steam draw-off key .
13 13. Programming Before leaving our factory, the machine is adjusted to enable you to obtain coffee without any additional programming. In order to adapt the result to your personal taste, various settings can be pro- grammed individually. The programming keys are located behind the front cover (3).
14 By pressing the button, you can select the next phase, or press the button in order to leave the programming. 13.4 Programming steam portion STEAM PORTION Press key . PORTION /....20 SEC. By pressing key or you can programme time in seconds (drawing off time of 3 – 250 sec.
15 ECONOMY MODE OFF means that the stand-by-status for steam is set to 20 minutes and the heating for the cup warming tray is on. After 10 minutes the warning lamp goes out. By pressing the steam key anew, the machine returns to stand-by-status for drawing off steam.
16 13.14 Program key By using key you can set back the following settings (powder quantity, coffee temperature, water quantity, steam portion, tea portion) to their original standard settings. COFFEE READY Press key until you can hear an acoustic signal.
17 14.6 Clean machine CLEAN UNIT After coffee, etc., has been drawn off 220 times or after 180 rinsing programs have been run, the machine must be cleaned. You can continue to draw off coffee and hot water / steam. However we recommend that you clean the machine (as described in chapter 15) within the next few days.
18 Switch on your machine by pressing ON/OFF key Press key until you can hear an acoustic signal. EMPTY TRAY (FILL WATER might show as well) Put a sufficiently large container under the coffee-spout (15) in order to prevent cleaning liquid from running into the drip tray.
19 FILL WATER Place a container under the pivoting nozzle (20). OPEN TAP PRESS CALC UNIT DECALCIFIYING / PLEASE WAIT Place a container under the height-adjustable tea-spout (22).
20 19. Messages Cause Action FILL WATER Water tank is empty Top up with water Water level indicator in tank is jammed Empty tank, rinse out, fill up and replace Tank is calcified, water level indicato.
21 Cause Action CLEAN UNIT You have drawn off coffee 220 times or run Clean as described in chapter 14.6 the rinsing program 180 times Message still displayed, although machine Run cleaning program ag.
22 Problem Cause Action Not enough froth while – Frothing nozzle blocked – Clean frothing nozzle frothing up milk – Clean Auto-Cappuccino – Clean Profi Auto-Cappuccino/Caffè Latte – as described in chapter 11.
デバイスJura Capresso X90の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Jura Capresso X90をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJura Capresso X90の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Jura Capresso X90の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Jura Capresso X90で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Jura Capresso X90を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJura Capresso X90の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Jura Capresso X90に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJura Capresso X90デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。