JVCメーカーCA-PCX290の使用説明書/サービス説明書
ページ先へ移動 of 24
LVT1189-001A [B] PC-X290 SP-PCX290 CA-PCX290 SP-PCX290 SENSOR TAPE AUX PLAY REC PLAY PHONES P R E S E T U P / R E P E A T P R O G R A M / S E T N W O D T E S E R P O R T N I Y A L P S I D CD/ RANDOM T.
15 cm 15 cm W arnings, Cautions and Others IMPORT ANT for the U .K. DO NO T cut off the mains plug from this equipment. If the plug fitted is not suitable f or the power points in y our home or the cable is too short to reach a power point, then obtain an appro- priate safety appro ved extension lead or consult y our dealer .
G-2 SAFETY INSTR UCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manuf actured to meet international safety standards but, lik e an y electr ical equipment, care must be taken if y ou are to obtain the best results and saf ety is to be assured.
– 1 – Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons and controls on the unit. Y ou can also use the b uttons on the remote contr ol if they have the same or similar names (or marks) as those on the unit.
– 2 – Contents Location of the Buttons and Controls ....................... 3 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Getting Started .
– 3 – SENSOR TAPE AUX PLA Y REC PLA Y PHONES P R E S E T U P / R E P E A T P R O G R A M / S E T N W O D T E S E R P O R T N I Y A L P S I D CD/ RANDOM TUNER/ BAND PLAY REW FF PA USE PLAY REW FF S.
– 4 – See pages in the parentheses for details. Front Panel 1 Display windo w 2 Operation buttons • 4 (9, 12 – 14), 3¥8 (play/pause) (13 – 15), 7 (13 – 15), ¢ (9, 12 – 15) 3 T APE b ut.
– 5 – When using the remote control, point it at the remote sensor on the front panel. Remote Control Remote Control 1 ST ANDBY/ON button (9) 2 A UX b utton (9) 3 DISPLA Y button (9) 4 FM MODE but.
– 6 – Connecting the Speakers T o connect speakers Y ou can connect the speakers using the speaker cords. 1 Hold the clamp of the speaker terminal. 2 Insert the end of the speaker cord into the terminal. Match the polarity of the speaker terminals: red ( ª ) to red ( ª ) and black ( · ) to black ( · ).
– 7 – R L AC IN R 2 1 Detaching the speaker system from the main unit W ith the le ver on the back of the unit pushed in the direction of the arro w ( 1 ), lift up the speaker verticall y ( 2 ) as the illustration shows.
– 8 – 4 3 8 7 1 2 5 6 R20(SUM-1)/D(13D) (not supplied) • DO NO T use an old battery together with a new one. • DO NO T use different types of batteries to gether . • DO NO T expose batteries to heat or flame. • DO NO T leave the batteries in the battery compartment when you are not going to use the unit for an extended period of time.
– 9 – 3 Press 4 or ¢ to adjust the minute, then press PR OGRAM/SET . If there is a power failur e The clock loses the setting and is reset to “0:00. ” Y ou need to set the clock again. If the batteries are inserted in the unit, this has no ef fect on the memory .
– 10 – Adjusting the V olume Y ou can adjust the volume le vel only while the unit is turned on. T urn the V OLUME +/– clockwise to increase the volume or counter clockwise to decrease it. • The volume le vel can be adjusted in 31 steps (00 V OL to 30 VOL).
– 11 – For better r eception of both FM and AM • Make sure the antenna conductors do not touch an y other terminals and connecting cords. • K eep the antennas away from metallic parts of the unit, connecting cords, and the A C po wer cord.
– 12 – T uning in a Station 1 Pr ess TUNER/BAND . The unit automatically tunes in the pre viously tuned station (either FM or AM). • Each time you press the button, the band alternates between FM and AM. 2 Pr ess and hold 4 or ¢ f or more than 1 second.
– 13 – Loading CD On the unit ONL Y : 1 Pr ess 0 OPEN on the disc door to open the disc door . 2 Place a disc correctl y with its label side up as shown belo w . 3 Pr ess 0 OPEN again to close the disc door . Playing Back the Entire Disc Y ou can play CD continuously .
– 14 – Programming the Playing Order of the T racks —Program Play Y ou can arrange the order in which the tracks play before you start playing. Y ou can pr ogram up to 20 tracks. • T o use Repea t play (see page 15) for Program play , pr ess PRESET UP/REPEA T after starting Program play .
– 15 – Repeating T racks or CD—Repeat Play Y ou can have the CD, the progr am or the individual track currently playing repeat as many times as you lik e. T o repeat play , press PRESET UP/ REPEA T during or before playing. T o use Repeat play for Program play , Random play and Intro play , press the button bef ore or after starting playback.
– 16 – Y ou can play back only type I (Normal) tapes. Playing Back a T ape 1 Pr ess STOP/EJECT 7 / 0 f or the deck y ou want to use. 2 Put a cassette in, with the exposed part of the tape down. 3 Close the cassette holder gently . 4 Pr ess T APE. 5 Pr ess PLA Y 3 .
– 17 – IMPORT ANT : • It should be noted that it may be unlawful to re-r ecord pr e-recorded tapes, r ecords, or discs without the consent of the owner of copyright in the sound or video recording , broadcast or cable pr ogram and in any literary , dramatic, musical, or artistic embodied therein.
– 18 – Recording Disc —Disc Synchronized Recording Y ou can start disc play and recording at the same time. 1 Put a recordable cassette into the deck A with the exposed part of the tape down. • See also page 16. 2 Close the cassette holder gently .
– 19 – Maintenance T o get the best performance of the unit, keep your discs, tapes, and mechanism clean. Handling cassette tapes • If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating. • If the tape is loose, it may get stretched, cut, or caught in the cassette.
– 20 – R BEAT CUT RESET 12 SPEAKER IMPEDAN Resetting the unit If “T roubleshooting” (see above) does not eliminate malfunctioning (failure to operate or display properly etc.), press the reset switch on the back of the unit with something having a sharp point.
0204TMMMDWORI EN © 2004 VICTOR COMPANY OF JAPAN, LIMITED VICTOR COMPANY OF JAPAN, LIMITED PC-X290 CD PORTABLE COMPONENT SYSTEM PC-X290[B]COVER_f.p65 04.
デバイスJVC CA-PCX290の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
JVC CA-PCX290をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJVC CA-PCX290の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。JVC CA-PCX290の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。JVC CA-PCX290で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
JVC CA-PCX290を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJVC CA-PCX290の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、JVC CA-PCX290に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJVC CA-PCX290デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
