JVCメーカーMX-J500の使用説明書/サービス説明書
ページ先へ移動 of 28
For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear , bottom or side of the cabinet. Retain this information for future reference.
– G-1 – W arnings, Cautions and Others Mises en gar de , précautions et indications diverses CA UTION T o reduce the risk of electrical shocks, fire , etc.: 1. Do not remov e screws, co vers or cabinet. 2. Do not expose this appliance to r ain or moisture.
– G-2 – For Canada/pour le Canada CA UTION: TO PREVENT ELECTRIC SHOCK, MA TCH WIDE BLADE OF PLUG TO WIDE SLOT , FULL Y INSERT . A TTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE D ANS LA BORNE CORRESPOND ANTE DE LA PRISE ET POUSSER JUSQU A U FOND .
– 1 – English Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons and controls on the unit. Y ou can also use the b uttons on the remote control if they ha ve the same or similar names (or marks) as those on the unit.
– 2 – English Contents Location of the Buttons and Controls ....................... 3 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Getting Started .
– 3 – English 1 2 3 6 7 8 9 p q w r t u i 5 4 MX-J700 o j l k e / z x c y v b ; a s d f g MX-J506/MX-J500 h Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Front Panel Powered Rolling Panel Press P ANEL OPEN/ CLOSE to open the panel.
– 4 – English See pages in the parentheses for details. Front Panel 1 Disc trays 2 PO WER button and ST ANDBY lamp (9) 3 Display windo w 4 For MX-J700: SUBW OOFER V OLUME control (10) For MX-J506/MX-J500: A CTIVE BASS EX.
– 5 – English When using the remote control, point it at the remote sensor on the front panel. Remote Control Remote Control 1 Disc number buttons (CD1, CD2, and CD3) (13) Pr essing one of these buttons also turns on the unit.
– 6 – English Getting Started Unpacking After unpacking, check to be sure that you ha ve all the follo wing items. The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) If any is missing, consult your dealer immediately .
– 7 – English 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. 2 T urn the AM loop antenna until y ou hav e the best r ece ption. T o connect an outdoor AM antenna When reception is poor , connect a single vinyl-covered wir e to the AM EXT terminal and extend it horizontally .
– 8 – English For pla ying the other equipment through this unit, connect between the audio output jacks on the other equipment and A UX jacks by using audio cords (not supplied). T o audio output T o start the display demonstration manually Press and hold DEMO f or more than 2 seconds.
– 9 – English Common Operations T urning On or Off the Power T o tur n on the unit, press POWER so tha t the ST ANDBY lamp goes off. The Po wered Rolling Panel opens automatically . T o tur n off the unit (on standby), press PO WER again so that the ST ANDBY lamp lights up.
– 10 – English When using the remote control, press SUBWOOFER + to increase the subwoofer v olume or press SUBWOOFER – to decrease it. For MX-J506/MX-J500 The ACTIVE B ASS EX. (e xtension) LEVEL control provided for this unit can maintain the richness and fullness of the bass sound while listening to any source at lo w volume.
– 11 – English Surround modes * : D.CLUB : Increases resonance and bass. HALL : Adds depth and brilliance to the sound. ST ADIUM : Adds clarity and spreads the sound, like in an outdoor stadium. SEA (Sound Effect Amplifier) modes: R OCK : Boosts lo w and high frequency .
– 12 – English Listening to FM and AM Broadcasts T uning in a Station 1 Pr ess FM/AM. The unit automatically turns on and tunes in the previously tuned sta tion (either FM or AM). The P owered Rolling Panel automatically opens. • Each time you press the button, the band alternates between FM and AM.
– 13 – English Playing Back CDs Loading CDs On the unit ONL Y : 1 Pr ess 0 f or the disc tray (CD1 to 3) y ou want to load a CD onto. The unit automatically turns on and the disc tray comes out. T he Powered Rolling Panel also opens automatically .
– 14 – English T o locate a particular point in a track During play , press and hold 1 or ¡ . • 1 : Fast re verses the disc. • ¡ : Fast forw ards the disc. When using the remote control, press and hold 1 / 4 or ¢ / ¡ . T o go to another track Press 4 or ¢ repeatedly before or during playback.
– 15 – English T o stop during play , press 7 . • Random play also stops when one of the disc trays is opened. T o exit fr om Random play mode, press PROGRAM/ RANDOM repeatedly again before or after play so that the unit enters another play mode.
– 16 – English Playing Back T apes Y ou can play back type I, type II, and type IV tapes without changing any settings. Playing Back a T ape 1 Pr ess EJECT ( 0 ) for the deck y ou want to use. 2 Put a cassette in, with the exposed part of the tape down.
– 17 – English Recording Recording a T ape on Deck B 1 Press EJECT 0 f or the deck B. 2 Put in a recordab le cassette, with the exposed part of the tape down. 3 Close the cassette holder gently . 4 Check the tape direction of deck B. • If the tape direction is not correct, press T APE 2 3 twice then 7 to change the tape direction.
– 18 – English CD Direct Recording Everything on the CD goes onto the tape in the order it is on the CD, or according to the order you hav e made for Program play . 1 Put a recordable cassette into deck B. 2 Place a disc correctl y on the circle of the disc tray , with its label side up.
– 19 – English Auto Edit Recording By using Auto Edit Recording, you can record the CD tracks to f it the tape. Auto Edit Recording makes a program by selecting the CD tracks in numerical order .
– 20 – English Using the T imers There are three timers av ailable — Recording T imer, Daily T imer , and Sleep T imer . Before using the timers, you need to set the clock built in the unit. (See page 9.) Using Daily Timer W ith Daily T imer , you can wake to your fa vorite music or radio program.
– 21 – English DAILY Canceled ON TIME ON TIME Clock setting (See page 9.) REC 6 When selecting “– CD – –” 1) Press 4 or ¢ to select the disc number , then press SET . 2) Press 4 or ¢ to set the track number , then press SET . The unit enters volume setting mode.
– 22 – English Recording Timer 7:00 6:30 Sleep Timer 7:30 does not work. Recording Timer AM 6:00 7:30 7:00 6:30 Daily Timer AM 6:00 Using Sleep T imer W ith Sleep T imer , you can fall asleep to music. Y ou can set Sleep T imer when the unit is turned on.
– 23 – English Maintenance T o get the best performance of the unit, keep your discs, tapes, and mechanism clean. Handling cassette tapes • If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating.
– 24 – English Specifications MX-J700 Amplifier section — CA-MXJ700 Output P ower SUBWOOFERS: 100 W per channel, min. RMS, dri ven into 6 Ω at 63 Hz with no more than 10% total harmonic distortion. MAIN SPEAKERS:50 W per channel, min. RMS, driv en into 6 Ω at 1 kHz with no more than 10% total harmonic distortion.
VICTOR COMP ANY OF JAP AN , LIMITED 0200MWMMDWJEM EN, FR J V C MX-J500/506/700[C].COVER/1 00.1.8, 8:16 PM 2.
デバイスJVC MX-J500の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
JVC MX-J500をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJVC MX-J500の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。JVC MX-J500の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。JVC MX-J500で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
JVC MX-J500を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJVC MX-J500の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、JVC MX-J500に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJVC MX-J500デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
