Kenmoreメーカー415.161278の使用説明書/サービス説明書
ページ先へ移動 of 28
Use and Care Guide LiquidPropane Gas Grill Kenmore Model No. 415.16127800 Kmart Item No. 640-810984-112 ® This Grill is For Outdoor Use Only • Read this manual before cooking on grill. Failure to follow all manufacturer's instructions could result in fire or explosion which could cause property damage, personal injury or death.
if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. if odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. 1. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.
For Your Safety ...................................... 2 Grill Service Center ................................... 2 Product Record Information ............................ 2 Safety Symbols ...................................... 2 Installation Safety Precautions .
LP Tank * NEVER store a spare LP tank under or near grill or in enclosed areas ............ / N _ . Never fill the cylinder beyond 80% full. * An overfilled or improperly stored tank is a hazard due to possible gas release from the safety relief valve.
LP Tank Exchange o Many retailers that sell grills offer you the option of replacing your empty LP tank through an exchange service. Use only those reputable exchange companies that inspect, precision fill, test and certify their cylinders.
Hold coupling nut and regulator as shown for proper connection to LP tank valve. Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. , 3. Be sure regulator is tightly connected to LP tank. Completely open LP tank valve by turning OPD hand wheel counterclockwise.
For Safe Use Of Your Grill And To Avoid Serious injury: • Do not let children operate or play near grill. • Keep grill area clear and free from materials that burn. • Do not block holes in bottom or back of grill. • Check burner flames regularly.
Main Burner ignitor Lighting A Do not lean over grill while lighting. 1. Open lid during lighting. 2. Turn ON valve from source or tank. 3. Push and turn Ignition Burner control knob to_. Hi and immediately press and hold Electronic Ignition button. 4.
, Plastic parts: Wash with warm soapy water and wipe dry. ,A. Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts.
Indirect Cooking Poultry and large cuts of meat cook slowly to perfection on the grill by indirect heat. The heat from selected burners circulates gently throughout the grill, cooking meat or poultry without the touch of a direct flame.
1 1 2 1 3 1 4 1 5 1 6 1 7 4 8 12 9 2 10 2 11 1 12 2 13 1 14 1 15 1 16 1 17 12 18 1 19 1 20 1 21 1 22 4 23 4 24 3 25 1 26 2 27 1 28 1 29 1 3O 1 31 12 32 4 33 4 34 1 35 1 36 8 37 1 38 1 39 1 Description Part # Right LegAssembly .................. 80015595 Left LegAssembly .
@ @ @ ® @ ® ® ° ®, ® @ @ @ ® @ /'! © ¢/ I L_. ® @ @ @ ® 12 • 464310808• 464310608.
Tank Exclusion Wire Place legs as shown (A). Left leg assembly has largeaxle holes on ends of legs. Hooktank exclusion wire into right and left leg assemblies (B).
Bottom Shelf to Legs Place bottom shelfend with cut out hole for LP cylinderbetween legs with axle holes.Attach to right and left leg assemblies with (4) 1/4-20x1-1/2" screws and 1/4-20 flange nuts, Tighten securely.
Wheels and Leg Extenders to Cart Turn assembly upside down. Insert axle rod through wheel,wheel spacer, legs,wheel spacerand other wheel.Attach with (1) 8mmflat washer and hitchpin.
Front Panels Stand cart upright. Attach lower front panelto lower half of cart with (4) #8x318" self-tap screws. Slideslot in upperpanelonto tank exclusion wire andattach to upper half of cart with (4) #8x3/8" self-tap screws. !" 17 #8x3/8" self-tap screws Qty: 8 Lower FrontPanel Upper FrontPanel 16.
Grill Head to Cart This step requires two peopleto lift and positiongrill headonto cart. Carefully lower the grill headonto the cart. Makesure the regulator hose is hangingoutside the cart.
Right Side Shelf Hookside wall of shelfover supportbrackets on side of firebox(A). Insert (2) 7ram fiber washers and 1/4-20x1/2" screws through inside front d firebox and (2) through outside backof fireboxfor each side as shown(B).
Sideburner Shelf and Left Fascia Hookside wall of sideburner shelf over supportbrackets on side of firebox(A). Insert (2) 7ram fiber washers and 1/4-20x1/2" screws through inside front of firebox.
Sideburner Bezel, Sideburner, Sideburner Knob and ignitor Wire. Position valve behind fascia and line up holes. Insert (1) of the #8-32x3/8" stainlesssteelscrews, do not fully tighten. Slip bezel underscrew inserted and positionas shown(A). Line up other hole and insertscrew #8-32x3/8" through bezel and into valve.
Sideburner Lid Attach sideburner handle to lidwith (2) #10-24x3/8"screws, 5ram lock washers and 5ram flat washers (A). Place sidebumer lid onto sidebumer shelf, attach with (4) #8-32x 3/8" screws and#8-32 flange nuts (B).
Heat Diffusers Place heat diffusers over burners by inserting tabs into slots in front of firebox. Opposite ends of heat diffusers rest on pins in backof firebox. Cooking Grate Place cookinggratesonto grate rests. CookingGrate Swing Away Insert ends of Swing Away pivotwire into holes in sides d grill lid.
Grease Cup Clip and Grease Cup Hang grease cup clip from bottom of firebox and place grease cup into grease cup clip. Grease Cu Grease Cu CAUTION Failure to install grease cup clip and cup will cause hot grease to drip from bottom of grill with risk of fire or property damage.
Troubleshooting EMERGENCIES: if a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. , Damaged hose. , Turn off gas at LP tank. If hose is cut or cracked,replace Gas leaking from cracked/cut/burned valve/hose/regulator.
Burner(s) will not light using ignitor. Troubleshooting (continued) , Push-button sticks at bottom.. Burner(s) will not match light. Suddendrop in gas flow or low flame. Flames blow out. Flare-up. Persistent grease fire. Flashback... (fire in burner tube(s)).
Troubleshooting - Electronic ignition SECTION I No sparks appear at , Battery not installed any electrodes when properly. ignition buttonis pushed; no noise can be heardfrom spark . Dead battery. module. SECTION II No sparks appear at any electrodes when ignition switchis pushed; noise can be heard from spark module.
Page intentionally blank 464310808" 464310608 • 27.
Your Home ':;i_i_i_i_i_i_i_i_i_i_i_i_i_i iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii Forrepair-in yourhome-ofall majorbrand appliances, iiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii lawn and garde.
デバイスKenmore 415.161278の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Kenmore 415.161278をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはKenmore 415.161278の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Kenmore 415.161278の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Kenmore 415.161278で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Kenmore 415.161278を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はKenmore 415.161278の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Kenmore 415.161278に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちKenmore 415.161278デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
