King CanadaメーカーMineral Hybridの使用説明書/サービス説明書
ページ先へ移動 of 20
P ool F ROG Mineral HyBrid Operations Manual IMPORT ANT : This manual must be given to the homeowner to ensure warranty coverage. Customer Service 800-222-0169 www .
When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: • It is recommended that a licensed electrician or certified electrical contractor perform the electrical connections. • DO NOT OPEN THE GENERATOR CONTROL PANEL – NOT A SERVICABLE UNIT.
T ABLE OF CONTENTS 3 W arning-Safety First 2 Intr oduction 4 Star t-up 5 Adding Salt to the P ool 6 Inser ting POOL FR OG ® Mineral Reser v oir 7 Basic Operation 8 Contr ols 9 Easy Maintenance 10 POO.
Par t 1 POOL FROG Mineral Hybrid Cycler The water treatment center that controls the flow of water through the system. Welcome to easier pool care courtesy of POOL FROG ® . With POOL FROG ® Mineral Hybrid, your pool water will look and feel better without a lot of work or a lot of chlorine.
• Make sure the pool has adequate circulation. The pool water must completely circulate through the pump and filter at least 1 1/2 to 2 times per day . Check with your dealer for the proper circulation time for your pool. Star t-up WATER BALANCE GUIDELINES Minimum Ideal Maximum pH: 7.
Adding Salt to the Pool 6 5. ADDING THE SAL T A. Distribute the determined amount of salt evenly around the pool. To avoid clogging the filter or damaging the control panel and pump, do not add salt thr ough the skimmer or surge tank . Brushing the bottom helps dissolve the salt.
Inser ting POOL FROG ® Mineral Reser voir ( POOL FROG ® Mineral Reservoir s MUST be Replaced Ever y Season) SLO T IN POOL FROG ® MINERAL RESER V OIR FIN INSIDE OF POOL FROG ® CYCLER.
Basic Operation Periodically test your water and always maintain the following readings. (Use Saturation Index on page 16 to ensure proper balance.) Salt Level: 3000 - 4500 ppm Chlorine Level: 0.5 - 1.0 ppm pH: 7.2 - 7.8 IMPORT ANT : At least once a month have a professional test your water.
CAUTION: Low Water Flow Power On/Off OUTPUT LEVEL 7 6 5 4 3 2 1 CAUTION: Salt Level High Set dial to achieve desired output level. IMPORTANT: Fine tuning is possible without indicator lights changing. See side panel or manual for additional directions.
Easy Maintenance Replacing the Contr ol Dial O-Rings Kit Replacing Cap O-Ring • Hold cap in front of you upside down with the o-ring groove facing up. Place one end of o-ring into cap groove at the point closest to you. Hold o-ring down with the thumb and forefinger of one hand.
Cleaning POOL FROG ® Mineral Hybrid Cell 11 CELL WIRING DIAGRAM Our clear cell allows for easy regular inspections for calcium build up. Visually check the cell periodically, and clean it as necessary (1 to 2 times per year).
Winterizing • T urn pump off and turn dial to 0. • Remove cap. • Unscrew knob in the back of POOL FROG ® Mineral Hybrid Cycler . Allow all water to drain. • Remove the POOL FROG ® Mineral Reservoir and discard in trash. Even if you hear spent minerals inside, it is no longer effective.
Insufficient water flow from pump This is normal for a few minutes at initial to flow sensor and cell. startup or if air is in the lines. Clean filters and strainers. Check for closed valves, faulty pump, etc. 4. CAUTION: Low Flow Light Obstruction or scale buildup in cell.
B. Red caution light is solid or Salt level is very high. The generator could Drain part of the water and refill the pool. output lights 1-7 go up completely turn off and no longer produce It is also recommended to periodically test and down quickly. chlorine until the situation is rectified.
Have your water tested for chlorine levels, pH, phosphates and nitrates. 12. Algae May be due to low chlorine levels Use a nonmetallic (polyquat) algaecide per or a chemical imbalance. the directions on the bottle and brush the sides of the pool often.
Saturation Index 16 Test the water for pH, Alkalinity, Calcium Hardness and Temperature, then follow the simple steps below: 1. Write your pool’s pH level here: pH: ________ 2.
Glossary 17 Salt: To ensure maximum benefits with the use of the system, the ideal salt level is 4000 ppm (parts per million). A low concentration of salt can hinder the generator’s effectiveness. A concentration of salt above 5500 ppm may cause corrosion damage to the pool fixtures.
POOL FROG ® Mineral Hybrid Cycler Parts List DIAGRAM/P ARTS LIST REF . # P ART No. DESCRIPTION QTY . REQ. 1 & 2 01-22-9412 Cap w/O-Ring 1 2 01-22-9920 Cap O-Ring 1 3 N/A Body 1 4 01-22-9480 Press.
19 King T echnology , Inc. w arrants to the original purchaser this unit will be free from any def ects in workmanship and/or material, for a period of two (2) years from the date of original purchase. This w arranty cov ers body , cap and control dial, but specifically e xcludes o-r ings.
Manufactured b y: KING TECHNOLOGY , INC. 530 11th A venue South, Hopkins, MN 55343 U .S.A. 952-933-6118 . 800-222-0169 . F AX 952-933-2206 www.kingtechnology.com Assembled from components made in the U.S.A. and Israel. Covered by one or more of the following U.
デバイスKing Canada Mineral Hybridの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
King Canada Mineral Hybridをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはKing Canada Mineral Hybridの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。King Canada Mineral Hybridの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。King Canada Mineral Hybridで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
King Canada Mineral Hybridを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はKing Canada Mineral Hybridの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、King Canada Mineral Hybridに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちKing Canada Mineral Hybridデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
