Lanzar Car AudioメーカーSD43MUの使用説明書/サービス説明書
ページ先へ移動 of 35
Detachable Panel Motorized Slide Down And 4.3 Inch Wide Color T ouch Screen Monitor CAR DVD/VCD/CD/MP3 Player AM/FM Digital PLL T uning Radio MPEG4 Player USB Connect BND APS MU SEL VOL- VOL+ RESET CAR DVD/VCD/CD/MP3 PLA YER WITH MPEG4 EQ IR AUX IN MENU REL MOD DISP CH 1-6 TOUCH SCREEN SD43MU INSTRUCTION MANUAL www .
Contents 1 Preautions ..................................... Safety Information......................... Disc Notes .................................... Installation .................................... Electric Connection ...................... Remote Control .
2 Precautions THANK YOU FOR PURCHASING THIS CAR DVD PLA YER . Before operating the unit, read this manual thoroughly and keep it handy for future reference . T o avoid injury or accident , read the following precautions before installing and operating the unit .
3 Safety Information CAUTION: W ARNING: REGION MANAGEMENT INFORMA TION: THIS DVD PLA YER IS A CLASS I LASER PRODUCT . HOWEVER THIS DVD PLA YER USES A VISIBLE/INVISIBLE LASER BEAM WHICH COULD CAUSE . HAZARDOUS RADIA TION EXPOSURE IF DIRECTED. BE SURE T O OPERA TE THE DVD PLA YER CORRECTL Y AS INSTRUCTED.
Disc Notes Preparing New Discs with Spots Rough A new disc may have rough edges on it s inside and outside edges.If a disc w it h rough edges is used, the proper s et ti ng will not be performed and the player will no t play the disc.Therefore, r e mo ve t h e rough edges in advance by using a ball point pen or pencil as shown on the right.
Choose the mounting location where the unit will not interfere with the normal driving function of the driver . Before finally installing the unit, connect the wiring temporarily and make sure all connected up properly and the unit and the system work properly .
Installation 6 If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, first remove the PLASTIC COVER of the both sides away , then insert the two KEY PLA TE into left and right side of chassis as above illustration.
7 Installation FIG.4 FIG.3 PROTECTIVE CASE FRONT P ANEL FIG.2 FRONT P ANEL FIG.1 FRONT P ANEL RELEASE BUTTON How T o Remove And Install The Front Panel When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder .
Panel Angle Adjustment 8 Caution: Do not insert your finger behind the control panel. CHANGING THE CONTROL P ANEL ANGLE Angle 3 Angle 4 Angle 1 Angle 2 When you want to change the viewing angle of the.
Electric Connection WIRING CONNECTION 9 Note: the earth connection cable (parking brake B-) must be connected in order for DVD pictures to be played back to the monitor . If the cable has not been correctly connected, the message “P ARKING BRAKE” appears on the monitor .
Remote Control 10 1. CLK 2. MODE 3. STOP 4. SETUP 5. MO/ST(AUDIO) 6. SUBTITLE LO/DX 7. REPEA T 8. GOTO 9. / 10. SEL 1 1. VOL+/VOL- 12. / / / 13.MENU SUB WOOFER 14.BAND(OSD) 15.POWER 16.PLA Y/P AUSE 17.MUTE 18.TITLE/PBC (A/P) 19. 20.ANGLE 21.EQ 22. / 23.
Remote Control 11 Using the Remote Control Face the remote control towards the player front face IR mark (remote control signal receiver), make sure there is no obstacle in between . Operation angle: About 30 degree in each the direction of the front of the IR mark.
1 11 17 18 7 5 19 6 3 15 10 13 8 14 4 16 12 BND APS MU SEL VOL- VOL+ RESET CAR DVD/VCD/CD/MP3 PLA YER WITH MPEG4 EQ IR AUX IN MENU REL MOD DISP CH 1-6 TOUCH SCREEN 2 9 Control Panel T ouch Panel Key Functions 12 SWF LUD DSP CLK MOD VOLUME- SEL VOLUME+ T ouch Screen Key : 1.
13 Unit Keys : 2. (POWER On/Off )BUTTON Press this button to switch the device on. WELCOME appears in the display . Press it again to switch the device off. SEE YOU appears in the display . 1.REL BUTTON Press this button to release the front panel for removal .
14 7. APS/DISP BUTTON Automatic Memory Function: Program Scan Function: Display ON/OFF Function: In Radio mode, press the APS/DISP button for about 2 seconds to active automatic station storage. In Radio mode, press the APS/DISP button to scan and play briefly all the preset sations in order , and it will hold at each band for about 5 seconds .
15 12. MODE BUTTON Use this button to select an input mode by pressing repeatedly until the proper one is found: AUX IN > RADIO > DISC If you are in USB Playback mode and want to select DISC mode, press the STOP button and then the GO T O button.
16 Basic Operation Setting The Clock CLK T ouch the CLK section on the screen and hold for about 2 seconds the hour will flash , press the VOL+/- to adjust .
17 TFT Monitor Adjustment SEL During DISC playback, use your finger touch briefly the SEL section on the screen (or press SEL button on the front panel . mode ) to across the Picture selection menu, by repeatedly touch the SEL section, and then touch the VOL+/- (or press the VOL+/-) to adjust the selected mode .
18 Basic Operation Setting Audio Modes It`s depend on your habit to select the Audio mode . SWF LUD DSP CLK MOD VOLUME- SEL VOLUME+ ROCK touch to select POP FLA T ROCK CLASSIC JAZZ T ouch the screen the DSP range ( o rp r e s st h eE Qb u t t o no nt h e front panel ) to select one of the preset sound modes DSP (Rock/Pop/Jazz/Classic/Flat) .
Radio Operation Start Searching For a Station Setting Memory Press the /CH 1-6 button repeatedly on the front panel to preset stations at radio mode . Or touch the screen the 1-6 sections ( ) 12 3 MOD 6 4 5 BND ST DX DISC-IN CH 6 SWF POP 11: 0 8 A M FM1 98.
Radio Operation Automatic Memory Storing & Program Scanning Loud Function T ouch the LUD section on the touch screen to switch the LOUND ON or OFF .
DISC Operation Stopping Play T ouch the screen the range (or press the button on remote control .) T o stop the unit playback. T ouch the section or press button on front panel to start play . ZOOM Function Repeatedly touch the section of the ZOOM, the displaying rate can be 1x, 2x, 3x, 1/2, 1/3, 1/4 .
T ouch the section , it display will following as below : T ouch the section , it display will following as below : T ouch the section , it display will following as below : DVD 1 1-0:44:36 ENT Above these operation cursor buttons for DVD setup. T ouch it for previous .
During DISC playback, T ouch the RDM section ( press the 4/RDM button longer on remote control to play in random. Each playing, the order is different . (depend on the disc used for VCD). 2). RDM(RANDOM) Function RDM NOTE : The 3/INT button is not available.
24 E. T ouch or Press for fifth time: The message on the screen will be cleared. OSD TITLE ELAPSED TT 01/01 CH 01/38 0:02:06 TITLE REMAIN TT 01/01 CH 01/38 3:24:36 CHAPTER ELAPSED TT 01/01 CH 01/38 0:02:56 CHAPTER REMAIN TT 01/01 CH 01/38 0:04:32 E.T ouch or Press for the fifth time: The message on the screen will be cleared for SVCD and VCD.
DVD/VCD Special Function MONO LEFT MONO RIGHT STEREO MIX-MONO For VCD/CD: AUDIO AUDIO during playback, touch the section of the touch screen or Press on the remote . It is possible to switch the sound between monaural and stereo sound. During DVD playback.
Setup 26 USING THE MENU TV Display Angle Mar k OSD Lang Spdif Output Captions Screen Saver Last Memor y DOLBY ....GENERAL SETUP P AGE.... Set TV Display Mode TV Display Nor mal/PS Nor mal/LB W ide Nor mal/LB GENERAL SETUP 1.TV DISPLA Y SETUP This is to select the appropriate TV aspect (4:3 or 16:9) according to the connected TV set.
27 Setup 5.CAPTIONS SETUP Activate the CAPTIONS feature by selecting ON. And release this feat- ure by selecting OFF . 2. ANGLE MARK DISPLA Y SETUP If it is set to ON, when the multi-angle DVD disc is playing, (the angle mark) will appears on the screen; if is set to OFF , the mark will not appear .
Setup 6.SCR SA VER SETUP Select the SCR SA VER output ON/OFF . 7.LAST MEMORY SETUP Select the LAST MEMOR Y output ON/OFF . SPEAKER SETUP This is to activate the audio output from DOLBY AC3 5.1 DOWNMIX to 2 channel mode. Select the preferred SPEAKER connection by using the cursor buttons.
Setup OSD Lang Prefer red Audio Language English F rench Ger man Spanish Italian Portuguese English TV Type Audio Subtitle Disc Menu Parental Pas swor d Default DOLBY ....Preference Page.... Audio --- PREFERENCES P AGE --- 1.TV TYPE SETUP This player can play discs recorded in either P AL or NTSC format.
Setup 5.P ARENT AL Select suitable parental guidance by the cursor buttons and conformed by pressing ENTER button. 6.P ASSWORD Select the change and press ENTER button. T ype the old password (The initial factory code is ) and key in 4 characters password now you want to use, and retype again to confirm key in correctly .
Other Main Operation Important Note: T o prevent damage to the USB device, do not remove or disconnect it during playback. it is also a good practice to remove the USB drive during disc playback.
Other Main Operation REP-ONE: Play the same song over and over again. 1.When inserting an MP3/WMA/JPEG/MPEG4 disc. Ex: When MP3 file is detected. 00:56 04:07 003/1 12 Repeat one Mp3 Mp3 Mp3 ....... ....... K P woman 1 new ton 1 2 3 4 56 .Current track(file)(highlighted bar) .
Supply V oltage: 12V DC (1 1V -15V) Current Consumption: Less than10 A Signal System: Compositive video 1.0Vp-p 75 Discs Played: (1) DVD-VIDEO Disc 5"(12 cm) single-sided, single-layer 5"(12.
888-J4304-02S Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . T rouble Shooting 34 Inserting the disc in reverse direction Press the RESET button.
デバイスLanzar Car Audio SD43MUの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Lanzar Car Audio SD43MUをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLanzar Car Audio SD43MUの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Lanzar Car Audio SD43MUの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Lanzar Car Audio SD43MUで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Lanzar Car Audio SD43MUを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLanzar Car Audio SD43MUの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Lanzar Car Audio SD43MUに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLanzar Car Audio SD43MUデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。