Lenovoメーカー4015LS1の使用説明書/サービス説明書
ページ先へ移動 of 35
User's Manual LENOVO (BEIJING) LIMITED L S2421p Wid eM o n ito r.
First Edition (June 2011) © Copyright Lenovo 2011. LENOVO produc ts , data , computer software , and services have been developed exclusively at private expense and are sold to governmental entities as commercial items as de fined by 48 C.F.R. 2.101 with limited and restricted rights to use , reproduction and dis closure.
Contents ii Contents Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii General Safety guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
iii LS2421p Wide Flat Panel Monitor User’s Guide Safety information General Safety guidelines For tips to h elp you use yo ur computer safely , go to: http://www .
Chapter 1. 1-1 Chapter 1. Getting started This User ’ s Guide contains detailed information on the your Flat Panel Monitor . For a quick overview , please see the Setup Poster that was shipped with your monitor .
Chapter 1. 1-2 Product overview This section will provide inform ation on adjusting moni tor positions , setting user controls , and using the cable lock slot. Adjusting the tilt The illustration below shows th e tile range of the monitor . For more informati on , see "Positioning your mon itor"on page 2-1.
Chapter 1. 1-3 Cable lock slot Y our monitor is equipped with a cable lock slot lo cated on the rear of your monit or (in the lower position). Setting up your monitor This section provides information on ho w to set up your monitor .
Chapter 1. 1-4 3. Connect the analog signal cable to the video port on the back of the computer . Note: One end of the signal cable is alre ady pre-attached to your mo nitor . 4. Connect one end of the HDMI cable to the monitor HDMI connector and the other end to the computer if it has on e HDMI ou tput connecto r .
Chapter 1. 1-5 6. Plug the speaker's audio cable to audio jack of the monitor and the other end on the external speaker audio in jack. Note: The audio output only for HDMI mode. 7. Insert the power cord into the m onitor , then plug the monitor power cord and the computer cord into grounded electrical outlets.
Chapter 1. 1-6 9. T o install the monitor driver , insert the Reference and Driver CD , click Install driver , and follow the on-screen instructions. 10. T o optimize your monitor image , press the Automatic Image Setup key . Automatic image setup requires that the monitor is warmed u p for at least 1 5 mintues.
Chapter 2. 2-1 Chapter 2. Adjusting and using your monitor This section will give you informatio n on adjusting and using your monitor. Comfort and accessibility Good ergonomic practice is important to get the most from your personal computer and to avoid discomfort.
Chapter 2. 2-2 • Use the monitor brightne ss, contrast cont rols, if equipped to optimize the image on your screen to meet your visual preferences. • Keep your monitor screen clean so you can focus on the screen’s contents. Any concentrated and sustained visual activity can be tiring for your eye s.
Chapter 2. 2-3 Adjusting your monitor image This section describes the control feat ures to adjust your monitor image. Using the direct access controls The direct access controls can be used when the On Screen Display (OSD) is not displayed. Table 2-1.
Chapter 2. 2-4 Using the On-Screen D isplay (OSD) cont rols To adjust the settings, the user controls can be vie wed through the OSD. To use the controls: 1. Press to open the main OSD menu. 2. Use or to move among the icons. Select an icon and press to access that function.
Chapter 2. 2-5 Table 2-2. OSD functions OSD Icon on Main Menu Submenu Description Controls an d Adjustments (Analog) Controls and Adjustments (HDMI) Brightness/ Contrast Brightness Adjusts overall brightness Same as Analog Contra st Adjusts difference between light and dark areas Image Position Horizontal Position Moves the image left or right .
Chapter 2. 2-6 Scaling • Selects type of scaled image • Original AR: same as pect ratio with input signal • Full Screen: expand image to full screen Same as Analog NOVO VISION Screen prioritization Option s Information Shows resolution, refresh rate, and product details.
Chapter 2. 2-7 Selecting a suppor ted display mode The display mode the monitor uses is controlled by the computer. Therefore, refer to your computer documentation for details on how to change display modes. The image size, position and shape might change when the display mode changes.
Chapter 2. 2-8 Understanding power management Power management is invoked when the comp uter recognizes that you have not used your mouse or keyboard for a user-def inab le period.
Chapter 2. 2-9 Caring for your monitor Be sure to turn off the powe r before you perform any maintenance on the monitor. Do not: • Apply water or liquid directl y to your monitor. • Use solvents or abrasives. • Use flammable cleaning mate rials to clean your monitor or any other electrical equipment.
Chapter 2. 2-10 Step 3: Revolv e the monitor VE SA cover an d stand, refer to "Detaching the monitor hinge cover and stand" insure that it is paral lel to top of the back side. Step 4: Attach the mounting bracket from the VESA compatible wall mounting kit (100mm x100mm distance), VESA Mounting Screw M4 x 10 mm.
Chapter 3. 3-1 Chapter 3. Reference information This section contains monitor specificati ons, instructions to manually install the monitor driver, troubleshooting info rmation, and service information. Monitor specifications Table 3-1. Monitor specifications fo r type-model LS2421pwA Dimensions Height Depth Width 411.
Chapter 3. 3-2 Communications VESA DDC CI Supported Display Modes Horizo ntal frequency Vertical frequency 30 kHz - 83 kHz 50 Hz - 75 H z Native Resolution 1920 x 1080 at 60 Hz Temperature Operati ng .
Chapter 3. 3-3 Troubleshooting If you have a problem setting up or using your monitor, you might be able to solve it yourself. Before calling your dealer or Lenovo, try the suggested actions that are appropriate to your problem.
Chapter 3. 3-4 Manual image setup If automatic image setup does not estab lish the image that you prefer, perform manual image setup. Note: Have your monitor powered on for about 15 minutes, until the monitor warms up. 1. Press at the bottom of the monitor to open the OSD menu.
Chapter 3. 3-5 Manually installing the monitor driver Below are steps for manually installi ng th e monitor driver in Microsoft Windows 7, Microsoft Windows Vista, Microsoft Windows XP.
Chapter 3. 3-6 Installing the monitor dr iver in Windows Vista To use the Plug and Play feature in Mi crosoft Windows Vista, do the following: Note: You must down load file from the Reference and Driver CD to use the Plug and Play feature in Windows Vista.
Chapter 3. 3-7 Installing the monitor driver in Windows XP To use the Plug and Play feature in Microsoft Windows XP, do the following: Note: You must down load file from the Reference and Driver CD to use the Plug and Play feature in Windows XP. 1. Turn off the computer and all attached devices.
Chapter 3. 3-8 Service information Customer responsibilities The warranty does not apply to a product which has been damaged due to accident, misuse, abuse, improper installation, usage not in accordance with product specifications and instructions, natural or personal disaster, or unauthorized alterations, repairs or modifications.
Appendix A. A-1 Appendix A. Service and Support The following information describes the tec hnica l support that is available for your product, during the warranty period or thro ughout the life of your product. Refer to the Lenovo Limited Warranty for a full ex planation of Lenovo warranty terms.
Appendix A. A-2 Austria Warranty service and support:01-211-454-610 (Ger man) Belgium Warranty service and support: 02 -225-3611 (Dutch, French) Bolivia 0800-10-0189 (Spanish) Brazil Sao Paulo region:.
Appendix A. A-3 Greece +30-210-680-170 0 Guatemala 1800-624-0051 (Spanish) Honduras Tegucigalpa: 232-4222 San Pedro Sula: 552-22 34 (Spanish) Hungary +36-1-382-5716 +36-1-382-5720 (English, Hungarian).
Appendix A. A-4 Nicaragua 001-800-220-1830 (S panish) Norway Warranty service and support: 8152-1550 (Norwegian) Panama Lenovo Customer Support Center: 001-866-434-20 80 (Toll Free) 206-6047 (Spanish).
Appendix B. B-1 Appendix B. Notices Lenovo may not offer the products, services, or features discussed in this do cument in all countries. Consult your local Lenovo representative for information on the products and services currently availa ble in your area.
Appendix B. B-2 Recycling information Lenovo encourages owners of i nformation techno logy (IT) equipment to responsibl y recycle their equipment when it is no longer needed. Lenovo offers a variety of programs and services to assist equipment owners in recycling thei r IT products.
Appendix C. C-1 Appendix C. USB Hub description This section gives yo u information about the US B ports that are available on your monitor. Note: This monitor supports High-Speed Certified USB 2.0 interface USB Upstream Connector USB Downstream Connector Transfer speed Data Rate Power Consumption High speed 480 Mbps 2.
デバイスLenovo 4015LS1の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Lenovo 4015LS1をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLenovo 4015LS1の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Lenovo 4015LS1の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Lenovo 4015LS1で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Lenovo 4015LS1を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLenovo 4015LS1の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Lenovo 4015LS1に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLenovo 4015LS1デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。