Lenoxx ElectronicsメーカーCD-511の使用説明書/サービス説明書
ページ先へ移動 of 24
IB-CD51 1(T A)-SW-E-091002 COMP ACT DISC PLA YER MW/FM DUAL CASSETTE RECORDER WITH REMOTE CONTROL MODEL CD-51 1 INCLUDES FULL FEA TURE REMOTE CONTROL MUL TI-COLOURED FLUORESCENT DISPLA Y P.
IB-CD51 1(T A)-SW-E-091002 1 CAUTION This compact disc player is classified as a CLASS 1 LASER PRODUCT as stated on the back of the player . W ARNINGS CAUTI ON RISK OF ELECTRIC SHOCK DO NOT OPEN L ASER PRODUCT CL ASS 1 This player uses a laser .
IB-CD51 1(T A)-SW-E-091002 PLEASE SA VE THESE INSTRUCTIONS CAUTION: TO REDUCE THE RISK OF FIRE, PERSONAL INJURY OR DAMAGE TO THE PLA YER, PLEASE READ AND FOLLOW THESE INSTRUCTIONS. BA TTER Y SAFETY INSTRUCTIONS 2 1 . Use only the type and size of batteries stated in the operating instructions booklet (Batteries are not included with the player .
IB-CD51 1(T A)-SW-E-091002 CHOOSING A POWER SOURCE AC power or batteries may be used as a power source. TIP Replace the batteries when the display dims or when the player stops operating.
IB-CD51 1(T A)-SW-E-091002 A TT ACHING THE SPEAKERS 1.Position one of the speakers to the right of the main unit. 2. Align the tracks (rails) on the speaker with the main unit as shown in FIG. 1. 3. When the speaker tracks (rails) are lined up, push the speaker into the tracks (rails) on the main unit as shown in FIG.
IB-CD51 1(T A)-SW-E-091002 REMOTE CONTROL The CD PLA YER can be operated with the REMOTE CONTROL provided (includes the following controls: POWER ON/OFF , MUTE, VOLUME, CD REPEA T and PLA Y).
IB-CD51 1(T A)-SW-E-091002 PLA YING A CD 1 Press the POWER button for the VFD display and AUDIO LEVEL to come on. 1 3 Open the CD DOOR by pressing the bottom righthand corner of the CD door marked OPEN/CLOSE and place the CD in the CD compartment. The label side of the CD should face upward.
IB-CD51 1(T A)-SW-E-091002 USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS T o Press or Adjust Adjust the volume VOLUME control Stop playback Pause playback will flash when a CD is in pause mode.
IB-CD51 1(T A)-SW-E-091002 REPEA T PLA Y PLA YING CD SONGS (TRACKS) REPEA TEDL Y T o repeat Press a single track (song) Press the REPEA T button once all the tracks (all songs) CD tracks can be played over and over again in either normal or programmed play mode (see page 9).
IB-CD51 1(T A)-SW-E-091002 9 Up to 19 tracks may be programmed to play in whatever order you wish. PROGRAMME PROGRAMMED CD PLA Y SELECTING YOUR OWN MUSIC PLA YING ORDER NOTE : Programming is only done during STOP mode. 1 2 3 4 5 During STOP mode, press the PROGRAMME button.
IB-CD51 1(T A)-SW-E-091002 LISTENING TO THE RADIO Connect the supplied AC power cord or batteries (see page 3). Set the FUNCTION switch to the RADIO position. 1 2 3 1 2 3 Set the BAND switch to the proper band position (MW or FM), and the FM MODE switch to STEREO or MONO.
IB-CD51 1(T A)-SW-E-091002 USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS To Press or Set Adjust the volume VOLUME control (UP or DOWN). TIP • If an FM broadcast is noisy , move the FM MODE switch from STEREO to MONO. Turn off the Radio Set the FUNCTION switch to the T APE position or press the POWER button.
IB-CD51 1(T A)-SW-E-091002 PLA YING A T APE Connect the supplied AC power cord or batteries (see page 3). Press the STOP/EJECT button (DECK A or DECK B) to open the tape compartment and insert a recorded tape. Close the door . 4 2 2 3 Press the PLA Y button.
IB-CD51 1(T A)-SW-E-091002 RELA Y PLA Y 3 2 4 Press the cassette P AUSE button on DECK B. 3 1 Press the cassette PLA Y button on DECK A for the tape in DECK A to play . 5 Connect the supplied AC power cord or batteries (see page 3). T o play tapes in DECK A and then DECK B, follow the steps below: Press the cassette PLA Y button on DECK B.
IB-CD51 1(T A)-SW-E-091002 USE THESE BUTTONS FOR ADDITIONAL CASSETTE T APE OPERA TIONS To Stop playback Eject the cassette Press or Adjust Adjust the volume Press the VOLUME button (UP or DOWN) Fast f.
IB-CD51 1(T A)-SW-E-091002 RECORDING ONTO A T APE Connect the supplied AC power cord or batteries (see page 3). Press the STOP/EJECT button (DECK B) to open the tape compartment and insert a blank tape. Select the source (MW , FM, CD, or microphone) you wish to record from.
IB-CD51 1(T A)-SW-E-091002 USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS To Turn off the power Press the STOP/EJECT button and the POWER button. The VFD display will go off. TIP Press or Set Stop recording STOP/EJECT button P AUSE button Press the button again to resume recording.
IB-CD51 1(T A)-SW-E-091002 SING ALONG WITH KARAOKE FUNCTION Connect the supplied AC power cord or batteries (see page 3). 1 2 3 4 Insert the microphone plug into the microphone jack. T o avoid howling from the microphone, lower the volume level first.
IB-CD51 1(T A)-SW-E-091002 PROG. USE THESE BUTTONS FOR ADDITIONAL OPERA TIONS To Press or Adjust Adjust the MIC volume MIC. VOLUME VOLUME control VOLUME CONTROL 18 Adjust the sound effect for low or high tones. TIP : If any squealing or howling (feedback) occurs during KARAOKE use, move the microphone away from the speakers or turn down the volume.
IB-CD51 1(T A)-SW-E-091002 PRECAUTIONS Safety Power Sources For battery operation, use 8 X LR20 (size D) batteries (not included). We recommend alkaline batteries for longer life.
IB-CD51 1(T A)-SW-E-091002 PRECAUTIONS (continued) CDs Before playing, clean the CD with a cleaning cloth. Wipe the CD from the centre out. Do not use solvents such as benzene, thinner , commercially available cleaners or anti-static spray intended for vinyl LPs.
IB-CD51 1(T A)-SW-E-091002 MAINTENANCE Cleaning the Lens If the lens is dirty , skipping may occur while the CD is playing. Clean with a commercially available lens cleaner and blower .
IB-CD51 1(T A)-SW-E-091002 TROUBLE SHOOTING Problem The power is not on. Connect the AC power cord securely to a wall outlet. Make sure the batteries are inserted correctly and are not worn out. There is no sound. Make sure the FUNCTION switch is in the correct position.
IB-CD51 1(T A)-SW-E-091002 SPECIFICA TION General Description Power source: AC 240V , 50Hz 20Watts DC 8 X LR20 (size D) batteries (not included) for player DC 2 X LR4 (size AAA) batteries (not included) for Remote Control Speakers (2 ways): 50 - 125mm 4 ohm woofers 50 - 75mm 4 ohm tweeters with crossover 5.
デバイスLenoxx Electronics CD-511の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Lenoxx Electronics CD-511をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLenoxx Electronics CD-511の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Lenoxx Electronics CD-511の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Lenoxx Electronics CD-511で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Lenoxx Electronics CD-511を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLenoxx Electronics CD-511の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Lenoxx Electronics CD-511に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLenoxx Electronics CD-511デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。