Lenoxx ElectronicsメーカーCD203の使用説明書/サービス説明書
ページ先へ移動 of 19
IB-CD203(AD)-WM-E-012503 PLA YS MUSIC COMP ACT DISCS FULL Y PROGRAMMABLE CD PLA YER WITH REPEA T RECEIVES AM/FM STEREO BROADCASTS RECORDS FROM CD, RADIO, OR BUIL T-IN MICROPHONE FM.
IB-CD203(AD)-WM-E-012503 TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THE PLUG WITH AN EXTENSION CORD, RECEPT ACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULL Y INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IB-CD203(AD)-WM-E-012503 ADDITIONAL SAFETY INSTRUCTIONS 1 . Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 2 . Wall or Ceiling Mounting - The appliance should not be mounted to a wall or ceiling.
IB-CD203(AD)-WM-E-012503 CAUTION: TO REDUCE THE RISK OF FIRE OR PERSONAL INJURY OR DAMAGE TO YOUR SET , READ AND FOLLOW THESE INSTRUCTIONS. BA TTER Y SAFETY INSTRUCTIONS 1. Use only the type and size of batteries mentioned in the operating instructions booklet (batteries are not included with this set, please buy the proper batteries).
IB-CD203(AD)-WM-E-012503 Y ou can use the AC power or batteries as a power source. 4 T o a wall outlet Replace the batteries when the POWER lamp dims or when the player stops operating.
IB-CD203(AD)-WM-E-012503 1 3 4 2 Connect the supplied AC power cord or batteries (refer to page 4). Track number PLA Y/PROG. lamp PLA YING A CD 5 POWER lamp POWER lamp Rotate the FUNCTION switch to CD position (power on), the POWER lamp will be on. Lift the right corner of the CD DOOR to open it and place a CD in the CD compartment.
IB-CD203(AD)-WM-E-012503 To Press or Adjust Adjust the volume VOLUME control Stop playback Pause playback Go to the next track Go back to the previous track Locate a point in a song When CD play is paused, the track number current playing will flash and no music will play .
IB-CD203(AD)-WM-E-012503 T o repeat Press a single track (song) Display shows programmed tracks REP EA T PLA Y/ PRO G. Y ou can play CD tracks over and over in normal or programmed play mode (refer to page 8). PLA YING CD TRACKS REPEA TEDL Y (REPEA T PLA Y) 1.
IB-CD203(AD)-WM-E-012503 PLA YING CD TRACKS IN PROGRAMMED OR RANDOM ORDER T o change the current program Just create a new program following the programming procedure. T o cancel Programmed Play Press the STOP button, then rotate the FUNCTION switch to T APE position.
IB-CD203(AD)-WM-E-012503 1 2 3 Tune into the station you prefer using the TUNING control. Adjust for the clearest sound. 4 This indicator will light up when receiving an FM Stereo broadcast. 9 LISTENING TO THE RADIO Connect the supplied AC power cord or batteries (refer to page 4).
IB-CD203(AD)-WM-E-012503 To Rotate or Adjust Adjust the volume Turn off the Radio • Next time you want to listen to the radio, just rotate the FUNCTION switch to RADIO position. The player will automatically start playing the previously tuned station.
IB-CD203(AD)-WM-E-012503 PLA YING A T APE 2 3 Rotate the FUNCTION switch to T APE position. 1 4 When the set finishes playing this side of the tape, the set will automatically stop. T o hear the other side of the tape, flip the tape over , then insert and press PLA Y .
IB-CD203(AD)-WM-E-012503 RECORDING ON A T APE 1 2 T o hear what you recorded, rotate the FUNCTION switch to T APE position, then press REWIND and PLA Y . 12 FULL REEL EMPTY REEL T APE PLA Y DIRECTION A OK NO OK NO Press the STOP/EJECT button to open the tape compartment and insert a blank tape.
IB-CD203(AD)-WM-E-012503 To Press or Adjust Adjust the volume T o enjoy the music without disturbing others Insert your headphone plug into the PHONES jack (HEADPHONE not included) 13 T o shut power o.
IB-CD203(AD)-WM-E-012503 PRECAUTIONS 14 On Operation If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. Should this occur , the player will not operate properly .
IB-CD203(AD)-WM-E-012503 T o record on a tape with its tab broken off, cover the respective tab hole for side A or B with adhesive tape. Use of a cassette with more than 90 minutes, such as C-120 (120 minutes), is not recommended. The extreme thinness of this tape may damage this set.
IB-CD203(AD)-WM-E-012503 Cleaning the Cabinet Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution.
IB-CD203(AD)-WM-E-012503 TROUBLE SHOOTING Problem Remedy The power is not on. There is no sound. Make sure the FUNCTION switch is at the right position as you want. Adjust the volume. Unplug the headphones when listening through speakers. appears in the display even when a CD is in place.
IB-CD203(AD)-WM-E-012503 General Description Power source: Speakers: 2 - 3 1 / 2 8 ohm Output power: 1.5W/channel Dimensions: AM: Lenoxx reserves the right to make design and specification changes for product improvement.
デバイスLenoxx Electronics CD203の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Lenoxx Electronics CD203をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLenoxx Electronics CD203の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Lenoxx Electronics CD203の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Lenoxx Electronics CD203で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Lenoxx Electronics CD203を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLenoxx Electronics CD203の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Lenoxx Electronics CD203に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLenoxx Electronics CD203デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。