LinearメーカーAM3Plusの使用説明書/サービス説明書
ページ先へ移動 of 20
AM3Plus Access Controller (760) 438-7000 • FAX (760) 438-7043 USA & Canada (800) 421-1587 & (800) 392-0123 Toll Free FAX (800) 468-1340 www.linearcorp.com PRINTER’S INSTRUCTIONS: INSTR,INSTL,AM3PLUS - LINEAR P/N: 227542 A - INK: BLACK - MA TERIAL: 20 LB.
2 Contents Introduction The AM3Plus Access Controller is designed for use as a primary access control device f or gated communities, parking garages, offi ce buildings , apar tments, dormitories, hotels/motels, commercial buildings and recreational facilities .
3 Har dware Features ✓ FOUR FORM “C” (N.O. & N.C) RELAYS Each relay has 3-amp @ 24-volt rating with a status indicator and relay latching pushbutton ✓ FOUR REQUEST-TO-EXIT INPUTS Activates.
4 Accessor y Over view PBUS Accessories Sev eral compatible accessories are av ailable to connect to the two 6- wire communications “PBUS” inputs . Up to six PBUS accessories can be used with each AM3Plus unit. AM-RRR R emote Radio Receiv er For wireless tr ansmitters, connect the Model AM-RRR high-gain superheterodyne UHF receiver .
5 Component Locations POWER INDICATOR RE S ET BUTTON ENTER BUTTON S TATU S /PROGRAM DI S PLAY ARROW BUTTON S S TATU S INDICATOR S RELAY INDICATOR S (4) RELAY LATCH BUTTON S (4) AM-MIO INTERFACE CONNEC.
6 Wiring Diagram ELECTRIC DOOR S TRIKE DOOR S TRIKE POWER S UPPLY GATE OPERATOR OPEN GATE EXIT LOOP S EN S OR MAGNETIC DOOR LOCK DOOR LOCK POWER S UPPLY DOOR EXIT REQUE S T BUTTON "A" DOOR &.
7 Impor tant Mounting Requir ements The AM3Plus Access Control System can be installed f or public or private use. The mounting requirements for remote k eypads will v ar y depending on the installation. Revie w the follo wing information before star ting the installation.
8 AM3Plus Mounting Standard Cabinet The AM3Plus cabinet is designed to be mounted directly to a wall or fl at surface . Wiring access for pow er, telephone , ear th ground, control output must be av ailable at the mounting location. For easier wiring, choose a well lit location.
9 Rela y Output Wiring Any of the f our relay outputs channels (A-D) can be used to control access devices on doors or gates . Door or Pedestrian Gate Control 1. Install a low v oltage electr ic door strike or magnetic lock as a locking de vice for the door or pedestrian gate.
10 P ower, Bat ter y, & Gr ound Wiring Power Wiring ✦ NO TE: DO NO T APPL Y PO WER UNTIL THE IN S T ALLA TION I S COMPLETE. TURN MA S TER PO WER S WITCH OFF BEFORE WIRING. 1. Route two wires between the AM3Plus and the po wer transformer . • F or power wire runs up to 100 feet, use 18 A WG, 600-volt insulated wire.
11 T elephone Wiring For prog ramming, the AM3Plus connects to a standard telephone line. ✦ NO TE: The optional Model ACM-1 modem is required f or telephone communications to the AM3Plus controller . Impor tant T elephone Wiring Tips • DO NO T ROUTE TELEPHONE AND AC WIRING INSIDE THE SAME CONDUIT .
12 Wiegand Accessories The two AM3Plus Wiegand inputs (READER A & B) can connect to a large variety of 26, 30, and 31-bit Wiegand output accessories. The Wiegand format is a common standard f or access control equipment. A typical application would be to add s wipe card or proximity readers to the system.
13 Optional Net work Connections Linear’ s AM3Plus, AE1000Plus, & AE2000Plus Access Control Systems can be connected together in a network. A network will allow sharing programming and user inf or mation between the systems. Program each unit to a different netw or k Node Address (see P age 16).
14 Optional Net work Connections (Continued) Network Confi guration for AccessBase2000 Programming If the system is going to be programmed using Linear’ s AccessBase2000 software, units comm unicate with each other on the network through RS-485 cable connections .
15 Optional Net work Connections (Continued) RS-485 Networ k Wiring Network wiring conforms to 3-wire RS-485 electr ical specifi cations. Units connected in the network can be wired using one unit as a “hub” or by wiring from one unit to the next in “daisy-chain” f ashion.
16 Sys tem Contr ols Pushbuttons Refer to the fi gure f or the location of each of the eight pushbuttons. • UP button adds one to the v alue on the ST A TUS/PROGRAM display . • DO WN button subtracts one from v alue on the ST A TUS/PROGRAM displa y .
17 Sys tem Diagnos tics Sev eral indicators on the AM3Plus are f or monitor ing the system during operation. When calling f or technical assistance, Linear’ s T echnical Services Depar tment ma y ask the installer to use these indicators to diagnose the system.
18 Specifi cations MECHANICAL Case dimensions: 11.5” W x 12.5” H x 3.5” D ELECTRICAL V oltage: 16-24 V olts AC or 12-24 V olts DC Current: 850 mA maximum @ 12 V olts DC Backup Battery: 12 V olt.
19 Linear Limited W arrant y This Linear product is warranted against def ects in material and workmanship for tw enty-four (24) months. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’ s normal distr ibution channels .
Copyright © 2007 Linear LLC 227542 A.
デバイスLinear AM3Plusの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Linear AM3Plusをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLinear AM3Plusの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Linear AM3Plusの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Linear AM3Plusで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Linear AM3Plusを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLinear AM3Plusの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Linear AM3Plusに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLinear AM3Plusデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。