LinksysメーカーC260の使用説明書/サービス説明書
ページ先へ移動 of 22
INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance.
2 T esTing i nforma Tion This manual describes the installation and operation of the Legacy™/Elite™ C/E260 non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’ s emissions limits for wood heaters sold on or after July 1, 199 0.
3 c onTenTs T esTing i nforma Tion .........................................................................2 g eneral s afeTy P recauTions ................................................................2 D rafTing ...................................
4 D rafTing Y our wood stove is dependent upon a properly functioning chimney for optimum per formance. It is a high efficiency appliance that loses much less heat up the chimney than older appliances and fireplaces. For this reason it is important to match the stove to the chimney .
5 Please be patient with the heat output of your stove for the first few wee ks. The steel will go thro ugh a curing proce ss that eliminates moisture, which is deep in the steel and firebrick. This moisture will reduce initial heat output of your stove and may make it difficult to start.
6 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. B rick i nsT alla Tion Legacy™/Elite™ C/E260 Brick Installation CAUTION: Wear gloves during brick installation in case of sharp edges inside the stove.
7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Model F (1) G H J M C260 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 57 2m m 5-1/4” 13 3m m 5 0 - 1 / 2 ” 12 83 m m E260 22” 55 9m m 14”.
8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. c himney r equiremenTs The L egacy ™/e Lite ™ c/e260 inserts are approved for use in masonry fireplaces built to UBC Chapter 37 or equivalent with a minimum 30” opening at the front of the fireplace.
9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Clearance to Combusibles See “Required Clearances” on Page 7 . Fireplace Pre-Installation Preparation NOTE: LENNOX HEARTH PRODUCTS RECOMMENDS PRO- FESSIONAL INST ALLA TION BY A LICENSED AND BONDED IN ST ALL ER .
10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. c himney l iner i nsT alla Tion Remove the existing chimney cap and install a stainless steel liner into the chimney (if a special section has been used or drilled to attach to the insert, it must be the bottom piece).
11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. o Pera Ting h inTs 1. Burn only dr y , well-seasoned wood for maxi- mum heat output. In some states it is illegal to burn wet wood or anything other than clean, dry wood products.
12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. s T arTing anD m ainT aining a f ire Be sure to clean the Nickel or Gold Plated door with Windex brand cleaner and a very soft cloth to remove any fingerprints and residues prior to the first fire.
13 Keeping freshly loaded wood away from the window will also help. Load fresh logs in the rear of the firebox. Build up tends to occur first on the right side of the window. This is caused by the swirling motion of the exhaust gases similar to water running down a drain.
14 m aximizing y our s Tove ’ s o verall e fficiency It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures insi de the fireb ox for thoro ugh combust ion . The best method for determining if you have sufficient temperatures is to watch the brick lining in your firebox.
15 Expe rime nt with differ ent load ing config urat ions to achi eve longer burns . T r y loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh wood should be loaded to the back of the firebox or to the sides.
16 T rouBleshooTing P roBlem s oluTion POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4 ) .
17 D o ’ s anD D on ’ T DO NOT : Install or operate this stove before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the stove door without fully opening the draft first.
18 BL O W ER P AR T S Ca t . N u mb er De s c ri p ti on H5 6 5 5 Sp e ed Co n tr o l - W o o d I n se r t U H P B l ow er 32 0 1 4 Bl o we r P o we r Co r d H5 5 5 9 UH P 1 C a ge Bl a ck H5 6 1 8 UH.
19 Replacement Parts Model C260 BL O W ER P AR T S Ca t . N o . De s c ri p ti on H5 6 5 5 Sp e ed Co n tr o l - W o o d I n se r t U H P B l ow er H6 1 5 1 Bl o we r P o we r Co r d H5 5 5 9 UH P 1 C.
20 TO P S URR OUN D P AN E L (R EQU IRE D ) Ca t . N o . De s c ri p ti on 71 0 1 5 7- 1/ 2 ” H x 48 ” W B l a ck (T ot a l d i me nsi o n w h en i ns t a ll e d e q ua ls 2 9” x 4 8” ) 71 0 1.
21 Notes.
Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,210M REV . B 12/2007 The manufacturer reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
デバイスLinksys C260の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Linksys C260をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLinksys C260の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Linksys C260の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Linksys C260で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Linksys C260を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLinksys C260の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Linksys C260に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLinksys C260デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。